Powermatic OES9138 - Manuals

8 Unpacking Open shipping container and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not discard any shipping material until the Edge Sander is assembled and running properly. Compare the contents of your container with the following parts list ...

9 7. The Edge Sander should be located in a dry, well-lighted area, on a solid and level surface, preferably a concrete floor. Leav e plenty of space around the machine for operations and routine maintenance work. 8. Exposed metal areas of the Edge Sander hav e been factory coated with a protectant....

11 Test Run After Wiring On the three-phase unit, after wiring has been completed, you should check that the wires are connected properly: 1. Connect machine to power source and press the start button (A, Figure 8). 2. The sanding belt should mov e left to right, as viewed from the front of the mach...

13 End Guard The end guard (A, Figure 15) on the right side of the machine can be swung out of the way for sanding long workpieces. (The miter gauge will need to be removed for such a procedure.) Loosen the hand knob (B, Figure 15) and swing open the end guard all the way until it catches the latch ...

14 To adjust tracking, proceed as follows: 1. Loosen the nut (A, Figure 18). 2. Turn the adjustment knob (B, Figure 18) counter-clockwise to shift the belt upward; clockwise to shift the belt downward. 3. When the belt is centered and tracking properly, tighten nut (A, Figure 18). 4. After adjustmen...

15 Maintenance Before doing maintenance on the machine, disconnect it from the electrical supply. Failure to comply may cause serious injury. Periodically check both drums. The drums are made of rubber material and may experience wear after a long period of use, at which time they should be replaced...

16 Troubleshooting the OES9138 Edge Sander Trouble Probable Cause Remedy Machine will not start/restart or repeatedly trips circuit breakers or blows fuses. Machine not connected to power source. Verify machine is connected to power. Fuse blown, or circuit breaker tripped. Replace fuse, or reset cir...

19 Replacement Parts Replacement parts are listed on the following pages. To order parts or reach our serv ice department, call 1-800-274-6848, Monday through Friday (see our website for business hours, www.powermatic.com). Having the Model Number and Serial Number of your machine av ailable when yo...

20 Parts List: Base Assembly Index No. Part No. Description Size Qty 1 ............... OES-001 ..................Machine Base........................................................................................ 1 2 ............... OES-002 ..................Magnetic Motor Starter ....................

22 Parts List: Drive Unit Index No. Part No. Description Size Qty 1 ............... OES-020 ..................Ball Bearing Assembly .................................... ...................................... 2 2 ............... TS-2360121 .............Flat W asher ......................................

24 Parts List: Tracking and Belt Release Unit Index No. Part No. Description Size Qty 1 ............... OES-036 ..................Belt Release Post .................................................................................. 2 2 ............... OES-037 ..................Bushing ..................

26 Parts List: Table Assembly Index No. Part No. Description Size Qty 1 ............... OES-056 ..................Elevation Casting................................................................................... 1 2 ............... OES-057 ..................DU Bushing ...............................

28 Parts List: Contour Sanding Unit Index No. Part No. Description Size Qty 1 ............... OES-077 ..................Sanding Arm Casting ............................................................................. 1 2 ............... TS-1550071 .............Flat W asher ............................