Poulan PRO PDGT26H48C - Manuals

5 UNASSEMBLED PARTS (2) Keys Slope Sheet Keys Gauge Wheels (4) Washers 3/8 x 3/4 x 14 Ga. (4) Wheels (4) Adjusting Bars (4) Retainer Springs (double loop) (4) Clevis Pins (4) Locknuts 3/8-16 (1) Oil Drain Tube For Future Use (4) Shoulder Bolt Steering Wheel Steering Wheel Insert Seat Mower (1) Front...

6 ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper ...

7 ASSEMBLY FIG. 4 2466 02464 SEAT PAN SHOULDER BOLT ADJUSTMENT KNOB FLAT WASHER SEAT FIG. 3 NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid. INSTALL SEAT (See Fig. 3) Adjust seat before tightening adjustment knob...

9 ASSEMBLY ✓ CHE CKLIST BEFORE YOU OPERATE AND ENJOY YOUR NEW TRAC- TOR, WE WISH TO ASSURE THAT YOU RE CEIVE THE BEST PER FORM ANCE AND SATISFACTION FROM THIS QUAL ITY PROD UCT. PLEASE REVIEW THE FOLLOWING CHECKLIST: ✓ All assembly instructions have been completed. ✓ No remaining loose parts in cart...

10 These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their mean-ing. OPERATION DANGER, KEEP HANDS AND FEET AWAY FREE WHEEL (Automatic Models only) OVER TEMP LIGHT KEEP AREA CLEAR SLOPE HAZARDS 15 15 (SEE SAFETY RULES SECTION) BATTERY REVERSE FO...

11 OPERATION 02507 KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR. Compare the illustrations with your tractor to familiarize yourself with the location of various controls and adjustments. Save this man ual for future reference. HEIGHT AD JUST MENT KNOB MO...

12 OPERATION FIG. 8 MOWER BLADES -• To stop mower blades,move attachment clutch switch to “DIS EN GAGED” po si tion. GROUND DRIVE -• To stop ground drive, depress brake pedal into full “BRAKE” position. IMPORTANT: THE MOTION CONTROL LEVER RETURNS TO NEUTRAL (N) POSITION WHEN THE BRAKE PEDAL IS FULLY...

13 OPERATION TO TRANSPORT (See Figs. 7 and 11) When pushing or towing your tractor, be sure to disengage transmission by placing freewheel control in free wheel ing po si tion. Free wheel control is located at the rear drawbar of tractor.• Raise attachment lift to highest position with at tach ment ...

14 OPERATION TO START ENGINE (See Fig. 7) When starting the engine for the fi rst time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.• Be sure freewheel control is in the transmission en gaged position. • Sit on seat in operating posi...

15 OPERATION FIG. 12 PURGE TRANSMISSION CAUTION: Never engage or disengage freewheel lever while the engine is run- ning. To ensure proper operation and performance, it is rec om -mend ed that the transmission be purged before operating tractor for the fi rst time. This procedure will remove any tra...

16 BEFORE EACH USE T R A C T 0 R Inspect Muffler/Spark Arrester Lubrication Chart Check Brake Operation Clean Air Filter Change Engine Oil (with oil filter) Replace Air Filter Paper Cartridge Replace Spark Plug Check Battery Level Check Tire Pressure Clean Battery and Terminals FILL IN DATESAS YOU C...

17 MAINTENANCE TRACTOR Always observe safety rules when performing any main- te nance. BRAKE OPERATION If tractor requires more than six (6) feet stopping distance at high speed in highest gear, then brake must be adjusted. (See “TO ADJUST BRAKE” in the Service and Ad just ments section of this manu...

18 MAINTENANCE TRANSAXLE COOLING The fan and cooling fi ns of transmission should be kept clean to assure proper cooling. Do not attempt to clean fan or transmission while engine is running or while the transmission is hot. To prevent pos-sible damage to seals, no not use high pressure water or stea...

19 MAINTENANCE 00667 MUFFLER Inspect and replace corroded muffl er and spark arrester (if equipped) as it could create a fi re hazard and/or dam-age. SPARK PLUGS Replace spark plugs at the beginning of each mowing season or after every 100 hours of operation, whichever occurs fi rst. Spark plug type...

20 02565 SERVICE AND ADJUSTMENTS TO REMOVE MOWER (See Fig. 19) • Place attachment clutch in “DIS EN GAGED” position.• If equipped, turn height adjustment knob to low est set ting. • Lower mower to its lowest position.• Disengage belt tension rod from lock bracket. CAUTION: Rod is spring loaded. Have...

21 TO LEVEL MOWER HOUSING Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly infl ated (See “PROD UCT SPECIFICATIONS” section of this manual). If tires are over or underinfl ated, you will not properly adjust your mower. SIDE-TO-SIDE ADJUSTMENT (See Fi...

22 02515 FIG. 25 L.H. MAN DREL IDLERPUL LEY CEN TER MAN DREL SPRING SEC OND ARY IDLER ARM SEC OND ARY SPRING ARM R.H. MAN DREL 02513 TO REPLACE MOWER BLADE (SEC OND ARY) DRIVE BELT (See Fig. 25) Park the tractor on level surface. En gage parking brake.• Remove mower (See “TO REMOVE MOWER” in this se...

23 SERVICE AND ADJUSTMENTS TO ADJUST ATTACHMENT CLUTCH (See Fig. 26) The electric clutch should provide years of service. The clutch has a built-in brake that stops the pulley within 5 seconds. Eventually, the internal brake will wear which may cause the mower blades to not engage, or, to not stop a...

24 0066 3sq RE TAIN ING RING WASH ERS FIG. 29 AXLE COVER TO REMOVE WHEEL FOR REPAIRS FRONT WHEEL (See Fig. 29)• Block up axle securely.• Remove axle cover, retaining ring and washers to allow wheel removal. • Repair tire and reassemble.• Replace washers and snap retaining ring securely in axle groov...

26 STORAGE Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more. WARNING: Never store the trac tor with gas o line in the tank inside a building where fumes may reach an open fl ame or spark. Allow the engine to cool before stor...

27 TROUBLESHOOTING POINTS Will not start 1. Out of fuel. 1. Fill fuel tank. 2. Engine not “CHOKED” properly. 2. See “TO START ENGINE” in Operation section. 3. Engine fl ooded. 3. Wait several minutes before attempting to start. 4. Bad spark plug. 4. Replace spark plug. 5. Dirty air fi lter. 5. Clean...

29 TRACTOR - MODEL NUMBER PDGT26H48C SCHEMATIC BATTERY FUSE RED RED BLACK BLACK BLACK BLACK BLACK NON-REMOVABLE CONNECTIONS REMOVABLE CONNECTIONS BLACK BLACK BROWN RED ORANGE BROWN M SOLENOID WIRING INSULATED CLIPS NOTE: IF WIRING INSULATED CLIPS WERE REMOVED FOR SERVICING OF UNIT, THEY SHOULD BE RE...

30 30 33 24 42 43 40 26 28 25 50 29 27 27 41 16 12 12 11 10 8 2 1 27 D.C . A MP ER ES 45 81 46 89 22 21 REPAIR PARTS TRACTOR - MODEL NUMBER PDGT26H48C ELECTRICAL

32 REPAIR PARTS TRACTOR - MODEL NUMBER PDGT26H48C CHASSIS AND ENCLOSURES 31 68 43 34 47 24 39 17 86 166 2 19 20 16 17 56 21 47 17 28 91 1 36 36 50 17 17 8 156 156 156 152 159 6 7 7 7 30 45 17 35 5 14 18 130 130 144 17 130 142 17 130 32 17 139 17 33 139 122 150 167 122 148 153 130 157 158 37 17 17 58...

34 REPAIR PARTS TRACTOR - MODEL NUMBER PDGT26H48C GROUND DRIVE 9 7 55 65 130 131 34 35 37 38 40 41 42 68 46 36 37 38 64 39 56 29 89 132 77 70 74 89 120 89 133 120 98 112 123 94 94 126 138 23 114 73 120 127 153 143 48 120 117 52 129 50 117 48 128 142 58 77 152 151 135 137 6 22 124 125 111 121 122 114...

36 REPAIR PARTS TRACTOR - MODEL NUMBER PDGT26H48C STEERING ASSEMBLY 8 29 28 23 31 41 22 21 20 1 45 14 25 34 33 32 6 27 42 27 6 19 9 8 7 2 6 6 4 14 15 14 14 15 12 9 3 8 7 3 6 6 5 13 13 53 8 14 15 36 26 10 11 steering_18-vgt 47 28 46 49 50 52 15 14 35 18 16

40 35 73 34 32 31 30 4 5 5 4 2 7 10 3 6 1 38 42 39 40 43 29 70 33 72 26 12 78 24 75 76 76 23 11 11 23 77 74 41 41 23 79 70 70 23 8 lift_rh_8 REPAIR PARTS TRACTOR - MODEL NUMBER PDGT26H48C LIFT ASSEMBLY

42 REPAIR PARTS TRACTOR - MODEL NUMBER PDGT26H48C SEAT ASSEMBLY 1 171684 Seat2 140551 Bracket, Pivot Seat3 140675 Strap Asm. Fender4 127018X Bolt, Shoulder 5/16-18 x .625 145006 Clip, Push-In Hinged6 73800600 Nut, Crownlock 3/8-167 124181X Spring, Seat Cprsn.8 171877 Bolt 5/16-18 unc x 3/4 w/Sems10 ...

43 REPAIR PARTS TRACTOR - MODEL NUMBER PDGT26H48C DECALS 23 1 3 9 14 4 23 10 19 6 8 17 11 KEY PARTNO. NO. DESCRIPTION KEY PARTNO. NO. DESCRIPTION 1 164097 Decal, Dash2 184858 Decal, Engine3 176272 Decal, Hood, RH4 176273 Decal, Hood, LH5 185539 Decal, Hood Sides6 170563 Decal, Warning7 166960 Decal,...

44 REPAIR PARTS TRACTOR - MODEL NUMBER PDGT26H48C MOWER DECK 132 91 94 182 95 183 132 48 _nos e_r oller 57 56 118 116 119 5 117 46 45 33 46 45 33 30 30 30 32 39 21 20 18 21 31 1 32 31 36 36 52 24 25 26 27 28 29 18 8 11 13 16 100 113 17 48 19 5 6 3 14 15 47 49 49 49 49 130 43 121 126 97 115 50 50 98 ...

46 LIMITED WARRANTY The Manufacturer warrants to the original consumer purchaser that this product as manufactured is free from defects in materi-als and work man ship. For a period of two (2) years from date of purchase by the original consumer purchaser, we will repair or replace, at our option, w...

47 15 DEGREES MAX. FOLD ALONG DOTTED LINE THIS IS A 15 DEGREE SLOPE ONLY RIDE UP AND DOWN HILL,NOT ACROSS HILL SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION WARNING: To avoid serious injury, operate your tractor up and down the face of slopes, never across the face. Do not mowslopes greater...

Your POULAN PRO product has been expertly en gi neered and carefully manu fac tured to rigid quality stan dards. As with all mechanical products, some adjustments or part replacement may be necessary during the life of your unit. FOR SERVICE OR REPLACEMENT PARTS: 1. Consult your dealer/place of purc...