Poulan PRO FN620L - Manuals

5 ASSEMBLY han dle s_96 TILLERHANDLES CABLE HANDLEPANELBOLTS 02051 FIG. 2 HAN DLEPANEL HEX BOLT5/16-18X3/4" TILLERHANDLE HEX BOLT5/16-18X1" FLATWASHER LOCKWASH ER NUT depth_stak e_5 DEPTHSTAKE SUPPORTBOLT HEX BOLTS,LOCK WASH ERS,AND HEX NUTS DEPTH STAKESUPPORT NUT “A” ENGINE BRACK ETHALVES F...

6 KNOW YOUR TILLER READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TILLER. Compare the illustrations with your tiller to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference. RECOILSTARTERHANDLE DEPTH STAKE TINESHIELD CHOKE...

7 OPERATION The operation of any tiller can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields before starting your tiller and while tilling. We recommend a wide vision safety mask over spectacles or standard safety glasse...

8 OPERATION FIG. 7 engine_a rt_4 OIL FILLERPLUG OIL LEVEL TO START ENGINE (See Fig. 8) CAUTION: Keep drive control bar in “DISENGAGED” position when start- ing en gine. When starting engine for the fi rst time or if engine has run out of fuel, it will take extra pulls of the recoil starter to move f...

9 OPERATION • You will fi nd tilling much easier if you leave a row un- tilled between passes. Then go back between tilled rows. (See Fig. 9) There are two reasons for doing this. First, wide turns are much easier to negotiate than about-faces. Sec ond, the tiller won’t be pulling itself, and you, t...

10 GENERAL RECOMMENDATIONS The warranty on this tiller does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, operator must main tain tiller as instructed in this manual. Some adjustments will need to be made periodically to properly m...

11 MAINTENANCE FIG. 12 AIR CLEANER (See Fig. 13) Service air cleaner cartridge every twenty-fi ve hours, more often if engine is used in very dusty conditions.• Loosen air cleaner screws, one on each side of cover. • Remove air cleaner cover.• Carefully remove air cleaner cartridge. Be care ful. Do ...

12 MUFFLER Do not operate tiller without muffl er. Do not tamper with exhaust system. Damaged muffl ers or spark arresters could create a fi re hazard. Inspect pe ri odi cally and re place if nec es sary. If your engine is equipped with a spark arrester screen assembly, re move every 50 hours for cl...

13 TILLER TO ADJUST HANDLE HEIGHT (See Fig. 15) Factory assembly has provided lowest handle height. Se lect handle height best suited for your tilling conditions. Handle height will be different when tiller digs into soil.• If a higher handle height is desired, loosen the four nuts securing handle p...

14 SERVICE AND ADJUSTMENTS TINE OPERATION CHECK (See Fig. 21) Be sure tines do not rotate when engine is running and tine control is in the “OFF” position. WARNING: Disconnect spark plug wire from spark plug to prevent starting while checking tine operation. FINAL CHECK “OFF” POSITION • With tine co...

15 SERVICE AND ADJUSTMENTS V-BELT IDLERPUL LEY TRANS MIS SIONPUL LEY BELTGUIDE ENGINE PULLEY BELTGUIDE TO REPLACE V-BELT (See Fig. 23) Replace V-belt if it has stretched considerably or if it has cracks or frayed edges. Belt guard must be removed to service belt. See “TO RE-MOVE BELT GUARD” in this ...

16 STORAGE ENGINE OIL Drain oil (with engine warm) and replace with clean oil. (See “ENGINE” in the Maintenance section of this man ual). CYLINDER(S) • Remove spark plug.• Pour 1 ounce (29 ml) of oil through spark plug hole into cylinder. • Pull starter handle slowly several times to distribute oil....

17 Will not start 1. Out of fuel. 1. Fill fuel tank. 2. Engine not “CHOKED” properly. 2. See “TO START ENGINE” in the Operation section. 3. Engine fl ooded. 3. Wait several minutes before attempting to start. 4. Dirty air cleaner. 4. Clean or replace air cleaner cartridge. 5. Water in fuel. 5. Empty...

18 REPAIR PARTS TILLER - - MODEL NUMBER FN620L HANDLE ASSEMBLY 1 2 3 15 19 23 5 5 6 4 7 8 9 12 18 34 28 3 16 14 13 11 10 handle_assy_99_26 1 137176X505 Bracket, Handle2 72140512 Bolt, Carriage 5/16-18 unc x 1-1¦23 9266R Grip, Handle4 151473 Handle, L.H.5 73680500 Locknut, Crown 5/16-186 19111116 Was...

20 REPAIR PARTS TILLER - - MODEL NUMBER FN620L WHEEL AND DEPTH STAKE ASSEMBLY 22 7 8 13 9 10 23 22 15 3 24 5 4 7 4 5 17 16 18 18 21 17 16 2 2 1 3 4 5 19 19 20 20 wheel_d.stake_4 1 9194R Pin, Clevis2 74760520 Bolt, Hex 5/16-18 x 1-1/43 74760512 Bolt, Hex 5/16-18 x 3/44 73220500 Nut, Hex 5/16-18 5 100...

21 KEY PART NO. NO. DESCRIPTION 1 165774 Tine, Outer, R.H.2 4921H Retainer, Spring3 165772 Tine, Inner, R.H. 4 165771 Tine, Inner, L.H.5 165773 Tine, Outer, L.H.6 9194R Pin, Clevis KEY PART NO. NO. DESCRIPTION 3 1 6 4 5 6 2 2 tine_ipb_4 REPAIR PARTS TILLER - - MODEL NUMBER FN620L TINE ASSEMBLY

22 REPAIR PARTS TILLER - - MODEL NUMBER FN620L TRANSMISSION KEY PART NO. NO. DESCRIPTION 18 10040400 Washer, Lock 1/419 74610412 Bolt, Hex 1/4-28 x 3/4 Gr. 520 - - - - - - - Engine, Briggs Model 94202 (Order parts from engine Manufac-turer) 2 3 5 6 8 11 16 17 11 10 7 19 14 10 12 18 10 14 1 20 transm...

23 KEY PART NO. NO. DESCRIPTION 1 132629 Decal, Logo2 163989 Decal, Logo 4 127185X Decal, Description5 110613X Decal, Tine Control 6 110614X Decal, Hand Placement 8 120076X Decal, Warning, Rotating Tines9 171803 Decal, Briggs & Stratton11 162384 Decal, Warning12 165327 Decal, Speed Control - - 1...

LIMITED WARRANTY The Manufacturer warrants to the original consumer purchaser that this product as manufactured is free from de-fects in materials and work man ship. For a period of two (2) years from date of purchase by the original consumer purchaser, we will repair or replace, at our option, with...