Poulan PRO DPR22H48STA - Manuals

5 UNASSEMBLED PARTS Mower Gauge Wheels (4) Washers 3/8 x 3/4 x 14 Ga. (4) Wheels (4) AdjustingBars (4) Retainer Springs (double loop) (4) Clevis Pins (4) Locknuts 3/8-16 (4) Shoulder Bolts Nose Roller NoseRollerBrackets (2) Hex Bolts 5/16-18 x 1 (2) Washers 17/32 x 7/8 x 16 Ga. (2) Locknuts 5/16-18 ...

6 Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. Toensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use thecorrect tools as necessary to insure proper tightness. ...

8 ASSEMBLE GAUGE WHEELS TO MOWERDECK (See Fig. 4) The gauge wheels are designed to keep the mower deck inproper position when operating mower. Be sure they areproperly adjusted to ensure optimum mower performance.• Slide gauge wheel bar down into bracket channel, Besure that gauge wheel bar aligning...

10 CHECK TIRE PRESSURE The tires on your tractor were overinflated at the factory forshipping purposes. Correct tire pressure is important forbest cutting performance.• Reduce tire pressure to PSI shown in “PRODUCTSPECIFICATIONS” section of this manual. CHECK MOWER LEVELNESS For best cutting results...

11 These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. BATTERY CAUTION OR WARNING REVERSE FORWARD FAST SLOW ENGINE ON ENGINE OFF OIL PRESSURE LIGHTS ON FUEL CHOKE MOWER HEIGHT PARKING BRAKE LOCKED UNLOCKED REVERSE NEUTRAL HIGH LOW ...

12 ELAPSED TIME AMPS 60 0 60 HOURS 1/10 0 0 0 0 0 0 0 0 0 0 OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and adjustments. Savethis manual ...

13 OPERATION CAUTION: Always stop tractor com-pletely, as described above, before leav-ing the operator's position; to emptygrass catcher, etc. TO USE THROTTLE CONTROL (See Fig. 8) Always operate engine at full throttle.• Operating engine at less than full throttle reduces thebattery charging rate. ...

14 OPERATION L O WPOSITION TO OPERATE MOWER (See Fig. 10) Your tractor is equipped with an operator presence sensingswitch. Any attempt by the operator to leave the seat withthe engine running and the attachment clutch engaged willshut off the engine.• Select desired height of cut. • Lower mower wit...

15 OPERATION TO START ENGINE (See Fig. 7) When starting the engine for the first time or if the engine hasrun out of fuel, it will take extra cranking time to move fuelfrom the tank to the engine.• Be sure freewheel control is in the transmission engagedposition. • Sit on seat in operating position,...

16 OPERATION FIG. 12 PURGE TRANSMISSION CAUTION: Never engage or disengagefreewheel lever while the engine isrunning. To ensure proper operation and performance, it is recom-mended that the transmission be purged before operatingtractor for the first time. This procedure will remove anytrapped air i...

17 BEFORE EACH USE T RAC T 0 R Adjust Motion Drive Belt(s) Tension Inspect Muffler/Spark Arrester Lubrication Chart Check Brake Operation Clean Air Filter Change Engine Oil Replace Air Filter Paper Cartridge Replace Spark Plug Check Battery Level Check Tire Pressure Clean Battery and Terminals FILL ...

18 CUSTOMER RESPONSIBILITIES TRACTOR Always observe safety rules when performing any mainte-nance. BRAKE OPERATION If tractor requires more than six (6) feet stopping distanceat high speed in highest gear, then brake must be adjusted.(See “TO ADJUST BRAKE” in the Service and Adjust-ments section of ...

19 CUSTOMER RESPONSIBILITIES CLEAN AIR SCREEN Air screen must be kept free of dirt and chaff to preventengine damage from overheating. Clean with a wire brush orcompressed air to remove dirt and stubborn dried gum fibers. TRANSAXLE COOLING The transmission fan and cooling fins should be kept cleanto...

20 CUSTOMER RESPONSIBILITIES MUFFLER Inspect and replace corroded muffler and spark arrester (ifequipped) as it could create a fire hazard and/or damage. SPARK PLUGS Replace spark plugs at the beginning of each mowingseason or after every 100 hours of operation, whicheveroccurs first. Spark plug typ...

21 SERVICE AND ADJUSTMENTS CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:• Depress brake pedal fully and set parking brake. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key “OFF” and remove key. • Make sure the blades and all moving parts have completely stopped. • Dis...

22 SERVICE AND ADJUSTMENTS TO REPLACE MOWER DRIVE BELT MOWER DRIVE BELT REMOVAL (See Fig. 24)• Park tractor on a level surface. Engage parking brake. • Lower mower to its lowest position. • Disengage belt tention rod from lock bracket. • Remove screws from R.H. mandrel cover and removecover. • Remov...

23 SERVICE AND ADJUSTMENTS FIG. 25 TO REPLACE MOWER BLADE DRIVE BELT(See Fig. 25) Park the tractor on level surface. Engage parking brake.• Remove mower drive belt (See “TO REPLACE MOWERDRIVE BELT” in this section of this manual). • Remove mower (See “TO REMOVE MOWER” in thissection of this manual)....

24 TO REMOVE WHEEL FOR REPAIRS(See Fig. 30) • Block up axle securely. • Remove axle cover, retaining ring and washers to allowwheel removal (rear wheel contains a square key - Do notlose). • Repair tire and reassemble. • On rear wheels only: align grooves in rear wheel hub andaxle. Insert square key...

25 SERVICE AND ADJUSTMENTS FIG. 32 HEXB O L T KEPS NUT POSITIVE(RED)CABLE NEGATIVE(BLACK)CABLE TERMINALGUARD TERMINALACCESSD O O R TO REPLACE HEADLIGHT BULB • Raise hood. • Pull bulb holder out of the hole in the backside of the grill. • Replace bulb in holder and push bulb holder securelyback into ...

26 SERVICE AND ADJUSTMENTS CLAMP SCREW FIG. 35 FIG. 34 SWIVEL CLAMPSCREW STOP ENGINE TO ADJUST THROTTLE CONTROL CABLE(See Fig. 34) The throttle control has been preset at the factory andadjustment should not be necessary. Check adjustmentas described below before loosening cable. If adjustmentis nec...

27 STORAGE Immediately prepare your tractor for storage at the end ofthe season or if the tractor will not be used for 30 days ormore. CAUTION: Never store the tractor withgasoline in the tank inside a buildingwhere fumes may reach an open flameor spark. Allow the engine to coolbefore storing in any...

28 TROUBLESHOOTING POINTS Will not start 1. Out of fuel. 1. Fill fuel tank. 2. Engine not “CHOKED” properly. 2. See “TO START ENGINE” in Operation section. 3. Engine flooded. 3. Wait several minutes before attempting to start. 4. Bad spark plug. 4. Replace spark plug. 5. Dirty air filter. 5. Clean/r...

31 BATTERY FUSE RED RED RED RED BLACK BLACK BLACK BLACK BLACK BLACK BLACK IGNITION UNIT SPARK PLUGS GAP (2 PLUGS ON TWIN CYL. ENGINES) NON-REMOVABLE CONNECTIONS REMOVABLE CONNECTIONS BLACK ORANGE BROWN M SOLENOID WIRING INSULATED CLIPS NOTE: IF WIRING INSULATED CLIPS WERE REMOVED FOR SERVICING OF UN...

32 REPAIR PARTS TRACTOR - MODEL NUMBER DPR22H48STA ELECTRICAL 28 29 26 24 42 43 25 41 27 27 40 33 30 50 22 21 79 81 D.C. AMPERES 45 12 12 11 10 8 2 1 27 55 52 16

34 REPAIR PARTS TRACTOR - MODEL NUMBER DPR22H48STA CHASSIS AND ENCLOSURES 64 209 158 74 30 159 209 13 3 31 1 9 157 156 60 26 144 25 26 60 3 3 3 142 3 3 3 142 143 60 17 29 145 161 166 37 37 209 11 209 209 20 59 28 166 166 154 209 166 155 166 209 54 58 54 14 14 38 38 213 214 3 2 206

35 NOTE: All component dimensions given in U.S. inches1 inch = 25.4 mm 1 174619 Chassis 2 176554 Drawbar 3 17060612 Screw 3/8-16x3/4 9 163976X428 Dash 11 167203 Panel Dash Lh 13 167202 Panel Dash Rh 14 17490608 Screw Thdrol 3/8-16 x 1/2 17 175259X428 Hood 20 162026 Plate Battery 25 19131312 Washer 1...

36 REPAIR PARTS TRACTOR - MODEL NUMBER DPR22H48STA DRIVE 29 28 30 52 32 37 53 35 55 36 62 35 36 22 34 16 1 77 77 241 32 30 52 57 25 19 24 26 26 76 78 75 74 27 26 59 19 219 221 221 220 222 221 19 19 51 61 19 19 6 231 239 33 239 238 52 237 233 240 232 241 235 242 221 215 224 225 223 223 223 223 226 22...

38 REPAIR PARTS TRACTOR - MODEL NUMBER DPR22H48STA STEERING ASSEMBLY 11 5 87 5 87 4 3 43 6 43 8 40 32 8 6 46 46 8 6 2 33 35 34 68 67 67 67 13 65 68 15 29 29 82 10 38 12 72 1 37 36 37 41 73 42 88 71 29 17 29 43 91

41 KEY PART NO. NO. DESCRIPTION KEY PART NO. NO. DESCRIPTION 1 171684 Seat 2 140551 Bracket Pivot Seat 8 720 3 71110616 Bolt Fin Hex 3/8-16 Unc x 1 4 19131610 Washer Flat 13/32 x 1 x 10 Ga. 5 145006 Clip Push-In 6 73800600 Nut Hex w/Ins. 3/8-16 Unc 7 124181X Spring Seat Cprsn 2 250 Blk Zi 8 17000616...

42 1 0 3 1 6 9 KEY PART NO. NO. DESCRIPTION KEY PART NO. NO. DESCRIPTION 1 59192 Cap Valve Tire 2 65139 Stem Valve 3 170455 Tire F T 15 X 6 0 - 6 Service 4 59904 Tube Front (Service Item Only) 5 106732X421 Rim Asm 6"front Service 6 278H Fitting Grease (Front Wheel Only) 7 9040H Bearing Flange (F...

43 REPAIR PARTS TRACTOR - MODEL NUMBER DPR22H48STA MOWER LIFT 36 4 5 6 2 3 1 6 5 4 7 8 23 24 25 27 28 29 30 50 26 37 41 40 38 49 18 17 16 15 54 54 13 12 11 13 13 31 53 32 32 13 52 49 49 51 51 13 13 20 1 159461 Wire Asm Inner/Sprg W/plunger 2 159476 Shaft Asm Lift RH w/Inf 3 138284 Pin Groove 4 12000...

44 REPAIR PARTS TRACTOR - MODEL NUMBER DPR22H48STA MOWER DECK 57 56 118 116 119 5 117 46 45 33 46 45 33 30 30 30 32 39 21 20 18 21 31 1 107 32 31 36 36 52 24 25 26 27 28 29 18 8 11 13 16 109 108 100 113 17 48 19 5 6 3 55 54 72 92 92 14 15 47 49 49 49 49 130 43 121 126 97 115 50 50 98 42 99 42 114 11...

46 LIMITED WARRANTY The Manufacturer warrants to the original consumer purchaser that this product as manufactured is free from defects inmaterials and workmanship. For a period of two (2) years from date of purchase by the original consumer purchaser, we willrepair or replace, at our option, withou...

47 15 MAX. SIGHT AND HOLD THIS LEVEL WITH SKY LINE OR TREE. CUT OUT ON DOTTED LINES THIS IS A 15 SLOPE SIGHTING GUIDE ONLY RIDE UP AND DOWN HILL, NOT ACROSS HILL SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION Operate your Tractor up and down the face of slopes (not greater than 15 ), never a...

Your POULAN PRO product has been expertly engineered and carefully manufactured to rigid quality standards. As with all mechanical products, some adjustments or part replacement may be necessary during the life of your unit. FOR SERVICE OR REPLACEMENT PARTS: 1. Consult your dealer/place of purchase....