Poulan PRO 952711964 - Manuals

Page 2 - IDENTIFICATION OF SAFETY SYMBOLS

2 IDENTIFICATION OF SAFETY SYMBOLS WARNING: This unit can be dangerous! Careless or improper use can cause serious injury. Trimmer line can throw objects violently. You can be blinded or injured. Always wear hearing protection and safety glasses marked Z87. Always wear heavy, long pants, long sleeve...

Page 3 - OPERATOR SAFETY

3 IDENTIFICATION OF SAFETY SYMBOLS When servicing unit, use only identical replace- ment parts. Store unit indoors in a high, dry place out of the reach of children. Always stop unit and disconnect spark plug before cleaning or servicing. WARNING: Fire hazard. Never mix, pour, or store gasoline or u...

Page 5 - ASSEMBLY; ADJUSTING THE HANDLE; PIVOT

5 ASSEMBLY WARNING: If received assembled, repeat all steps to ensure your unit is properly assembled and all fasteners are secure.Examine parts for damage. Do not use dam- aged parts. NOTE: If you need assistance or find parts missing or damaged, call 1-800-554-6723.It is normal for the fuel filter...

Page 6 - OPERATION; HELPFUL TIP

6 OPERATION KNOW YOUR TRIMMER READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference. Primer Bulb Line Limiter Blade Fu...

Page 7 - OPERATING INSTRUCTIONS

7 HELPFUL TIP If your engine switch reads “push to stop”, it is always in the ON position. HOW TO STOP YOUR UNIT S To stop the engine, push and hold the STOP switch in the STOP position until the engine stops. S If engine does not stop, move choke lever to FULL CHOKE position. HOW TO START YOUR UNIT...

Page 9 - MAINTENANCE

9 SWEEPING -- The fanning action of the rotat- ing line can be used for a quick and easy clean up. Keep the line parallel to and above the surfaces being swept and move the tool from side to side. Sweeping MAINTENANCE WARNING: Disconnect the spark plug before performing maintenance except for carbur...

Page 10 - SERVICE AND ADJUSTMENTS; REPLACING THE LINE

10 SERVICE AND ADJUSTMENTS REPLACING THE LINE For unit to operate properly, the cutting line should be replaced when line becomes worn to less than 3 inches in length from the edge of each side of the cutting head. WARNING: Use only 0.095 inch (2,4 mm) diameter Poulan brand cut length line. Never us...

Page 11 - STORAGE; SEASONAL STORAGE; ENGINE

11 STORAGE WARNING: Perform the following steps after each use: S Allow engine to cool before storing or trans- porting. S Store unit and fuel in a well ventilated area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc. S Store unit w...

Page 12 - LIMITED WARRANTY

12 TROUBLE CAUSE REMEDY Engine will not start. 1. Engine flooded. 2. Fuel tank empty. 3. Spark plug not firing. 4. Fuel not reaching carburetor. 5. Carburetor requires adjustment. 1. See “Starting a Flooded Engine” in Operation Section. 2. Fill tank with correct fuel mixture. 3. Install new spark pl...

Page 13 - EMISSION CONTROL WARRANTY STATEMENT

13 Giving the model number, serial number and date of purchase of your product and the name and address of the authorized dealer from whom it was purchased. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY HAVE OTH- ER RIGHTS WHICH VARY FROM STATE TO STATE. NO CLAIMS FOR CONSEQUENTIAL OR O...