Poulan PRO 952711880 - Manuals

Page 2 - IDENTIFICATION OF SAFETY SYMBOLS

2 IDENTIFICATION OF SAFETY SYMBOLS WARNING: Always use a metal shield and dust cup in the order shown when using blades. Always use a handlebar and shoulder strap. Ensure handlebar remains installed at all times. WARNING: This unit can be dangerous! Careless or improper use can cause serious injury....

Page 4 - OPERATOR SAFETY

4 the unit. Read the entire instruction manual be- fore assembling and using the unit! Restrict the use of this unit to persons who read, under- stand, and follow the warnings and instructions in this manual and on the unit. Never allow chil- dren to operate this unit. SAFETY INFORMATION ON THE UNIT...

Page 5 - TRANSPORTING AND STORAGE; ASSEMBLY; CARTON CONTENTS

5 S Always keep engine on the right--hand side of your body. S Hold the unit firmly with both hands. S Keep firm footing and balance. Do not over- reach. S Keep blade or trimmer head below waist level. Do not raise engine above your waist. S Keep all parts of your body away from blade, trimmer head,...

Page 9 - OPERATION; HELPFUL TIP

9 OPERATION KNOW YOUR UNIT READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference. Line Limiter Blade Primer Bulb Handl...

Page 11 - OPERATING INSTRUCTIONS

11 WARNING: Always stop unit and dis- connect spark plug before removing or instal- ling attachments. REMOVING TRIMMER ATTACH- MENT (OR OTHER OPTIONAL ATTACHMENTS) CAUTION: When removing or installing at- tachments, place the unit on a flat surface for stability. 1. Loosen the coupler by turning the...

Page 13 - ADDITIONAL SAFETY RULES; FOR OPTIONAL ATTACHMENTS; EDGER SAFETY

13 more likely to occur in areas where it is difficult to see the material being cut. By using the unit properly, the occurrence of blade thrust will be reduced and the operator will be less likely to lose control. S Cut only grass, weeds, and woody brush up to 1/2 inch (1 cm) in diameter with the w...

Page 15 - SNOW THROWER SAFETY

15 WARNING: A coasting blade/rotat- ing chain can cause injury while it continues to move after the engine is stopped. Maintain proper control of the unit until the blade/chain has completely stopped moving. Keep hands, face and feet at a distance from all moving parts. Do not attempt to touch or st...

Page 16 - MAINTENANCE

16 MAINTENANCE WARNING: Disconnect the spark plug before performing maintenance except for carburetor adjustments. HELPFUL TIP IMPORTANT: Have all repairs other than the rec- ommended maintenance described in the instruction manual performed by an authorized service dealer. If any dealer other than ...

Page 17 - SERVICE AND ADJUSTMENTS; REPLACING THE LINE

17 SERVICE AND ADJUSTMENTS REPLACING THE LINE For unit to operate properly, the cutting line should be replaced when line becomes worn to less than 3 inches (7.5 cm) in length from the edge of the line exit tunnels on each side of the cutting head. 1. Remove and discard worn line before installing n...

Page 18 - STORAGE; SEASONAL STORAGE; ENGINE

18 STORAGE WARNING: Perform the following steps after each use: S Allow engine to cool before storing or trans- porting. S Store unit and fuel in a well ventilated area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc. S Store unit w...