Poulan PRO 545137277 - Manuals

Page 2 - SAFETY RULES; OPERATOR SAFETY

2 SAFETY RULES WARNING: When using gardening appliances, basic safety precautions must al- ways be followed to reduce the risk of fire and serious injury. Read and follow all instruc- tions. This power unit can be dangerous! Operator is responsible for following instructions and warnings on unit and...

Page 3 - FOR OPTIONAL ATTACHMENTS; EDGER SAFETY

3 S Keep others away when making carburetor adjustments. S Use only recommended Poulan PRO accessories and replacement parts. S Have all maintenance and service not explained in this manual performed by an authorized service dealer. FUEL SAFETY S Mix and pour fuel outdoors. S Keep away from sparks o...

Page 6 - SNOW THROWER SAFETY; ASSEMBLY; INSTALLING TRIMMER ATTACH-

6 S Stop the unit immediately if you feel excessive vibration. Vibration is a sign of trouble. Inspect thoroughly for loose nuts, bolts or damage before continuing. Contact an authorized service dealer for repair or replacement of affected parts as necessary. SNOW THROWER SAFETY WARNING: Keep hands ...

Page 7 - OPERATION; KNOW YOUR UNIT

7 Coupler Primary Hole Upper Shaft Locking/ Release Button Lower Attachment Guide Recess WARNING: Make sure the locking/ release button is locked in the primary hole and the knob is securely tightened before op- erating the unit. All attachments are designed to be used in the primary hole unless oth...

Page 8 - HELPFUL TIP

8 ON/OFF SWITCH The ON/OFF switch is located on the trigger handle and is used to stop the engine. Move the switch to the OFF position to stop the engine. PRIMER BULB The PRIMER BULB removes air from the car- buretor and fuel lines and fills them with fuel. This allows you to start the engine with f...

Page 10 - OPERATING INSTRUCTIONS; It is recommended that the engine not be; OPERATING POSITION; Right

10 WARNING: Make sure the locking/ release button is locked in the primary hole and the knob is securely tightened before op- erating the unit. All attachments are designed to be used in the primary hole unless otherwise stated in the applicable attachment instruction manual. Using the wrong hole co...

Page 11 - MAINTENANCE

11 S During light duty cutting. S Near objects around which the line can wrap such as small posts, trees or fence wire. S For mowing or sweeping, use full throttle for a good clean job. TRIMMING -- Hold the bottom of the trimmer head about 3 inches (8 cm) above the ground and at an angle. Allow only...

Page 12 - SERVICE AND ADJUSTMENTS; REPLACING THE LINE

12 1. Clean the cover and the area around it to keep dirt from falling into the carburetor chamber when the cover is removed. 2. Remove parts by pressing button to re- lease air filter cover. NOTE: To avoid creating a fire hazard or producing harmful evaporative emissions, do not clean filter in gas...

Page 14 - STORAGE; SEASONAL STORAGE; ENGINE

14 STORAGE WARNING: Perform the following steps after each use: S Allow engine to cool before storing or trans- porting. S Store unit and fuel in a well ventilated area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc. S Store unit w...