Poulan PRO 2001-08 - Manuals

5 Symmetrical Guide Bar Large Radius Tip S Low--Kickback Chain, designed with a contoured depth gauge and guard link which deflect kickback force and allow wood to gradually ride into the cutter. Low-- Kickback Chain has met kickback per- formance requirements when tested on a representative sample ...

6 symptoms occur such as numbness, pain, loss of strength, change in skin color or texture, or loss of feeling in the fingers, hands, or joints, discontinue the use of this tool and seek medical attention. An anti-vibration system does not guarantee the avoidance of these problems. Users who operate...

7 S Place the chain over and behind the clutch, fitting the drive links in the clutch drum sprocket. Place chain onto the sprocket S Fit bottom of drive links between the teeth in the sprocket in the nose of the guide bar. S Fit chain drive links in to bar groove. S Pull the bar forward until the ch...

8 OPERATION KNOW YOUR SAW READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR CHAIN SAW. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference. Chain Adjustment Tool (Bar Tool)...

9 FUELING & LUBRICATION WARNING: Remove fuel cap slow- ly when refueling. FUELING ENGINE This engine is certified to operate on unleaded gasoline. Before operation, gasoline must be mixed with a good quality synthetic 2-cycle air-cooled engine oil designed to be mixed at a ratio of 40:1. Poulan/...

10 Primer Bulb ON/STOP Switch ON STOP ON/STOP SWITCH OFF FULL CHOKE/FAST IDLE LEVER Choke/Fast Idle Lever (SIDE VIEW) STARTING A WARM ENGINE: S Move ON/STOP switch to the ON position. S Pull the choke/fast idle lever out to the full extent, then push the lever back in com- pletely (to the OFF positi...

11 S Keep the engine at full speed the entire time you are cutting. S Allow the chain to cut for you. Exert only light downward pressure. If you force the cut, damage to the bar, chain, or en- gine can result. S Release the throttle trigger as soon as the cut is completed, allowing the en- gine to i...

12 S DO NOT cut down a partially fallen tree with your saw. Be extremely cautious with partially fallen trees that may be poorly supported. When a tree doesn’t fall com- pletely, set the saw aside and pull down the tree with a cable winch, block and tackle, or tractor. CUTTING A FALLEN TREE (BUCKING...

13 1 st Cut 2 nd Cut Using a support stand 1 st Cut 2 nd Cut LIMBING AND PRUNING WARNING: Be alert for and guard against kickback. Do not allow the moving chain to contact any other branches or ob- jects at the nose of the guide bar when limb- ing or pruning. Allowing such contact can re- sult in se...

16 TROUBLE CAUSE REMEDY Engine will not start or will run only a few seconds after starting. S Ignition switch off. S Engine flooded. S Fuel tank empty. S Spark plug not firing. S Fuel not reaching carburetor. S Move ignition switch to ON. S See “Difficult Starting” in Operation Section. S Fill tank...

17 U.S. EPA/CALIFORNIA/ENVIRONMENT CANADA EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OB- LIGATIONS: The U.S. Environmental Protection Agency, California Air Resources Board, Environment Canada and POULAN/ WEED EATER. DIVISION OF WCI OUT- DOOR PRODUCTS, INC., are pleased to explain ...