Poulan PRO 188781 - Manuals

5 UNASSEMBLED PARTS (1) Large Flat Washer Steering Wheel Insert Steering Sleeve Steering Wheel (1) Knob (1) Washer 17/32 x 1-3/16 x 12 Gauge Seat (2) Keys Slope Sheet SteeringExtensionShaft Steering Adapter (1) Oil Drain Tube (1) Hex Bolt 1/4-28 x 1-1/4 (1) Locknut 1/4-28 (1) Locknut 1/2-20

6 02601 ASSEMBLY TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Stan dard wrench sizes are listed.Utility knife Pliers (1) 3/4" wrenches Tire pressure gauge (2) 7/16" wrenches Utility knife When right or left hand is mentioned in this man ual, it means when you ar...

7 ASSEMBLY FIG. 3 SEAT PAN SHOULDER BOLT ADJUSTMENT KNOB FLAT WASHER SEAT HOW TO SET UP YOUR TRACTOR INSTALL SEAT (See Fig. 3) Adjust seat before tightening adjustment knob.• Remove adjustment knob and fl at washer securing seat to cardboard packing and set aside for assembly of seat to tractor. • P...

8 INSTALL MULCHER PLATE (See Figs. 4) • Install two latch hooks to mulcher plate using screw, washer, lock washer, and weld nut as shown. NOTE: Pre-assemble weld nut to latch hook by in sert ing weld nut from the top with hook pointing down.• Tighten hardware securely.• Raise and hold defl ector shi...

9 OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their mean-ing. DANGER, KEEP HANDS AND FEET AWAY FREE WHEEL (Automatic Models only) OVER TEMP LIGHT KEEP AREA CLEAR SLOPE HAZARDS 15 15 (SEE SAFETY RULES SECTION) BATTERY REVERSE FOR...

10 OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. Our tractors conform to the safe...

11 OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any adjustments or repairs. We rec om mend a wide vision safety mask over spec...

12 OPERATION TO OPERATE ON HILLS WARNING: Do not drive up or down hills with slopes greater than 15° and do not drive across any slope. • Choose the slowest speed before starting up or down hills. • Avoid stopping or changing speed on hills.• If slowing is necessary, move throttle control lever to s...

13 OPERATION TO START ENGINE (See Fig. 5) When starting the engine for the fi rst time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.• Be sure freewheel control is in the transmission en gaged position. • Sit on seat in operating posi...

14 FIG. 10 MOWING TIPS • Mower should be properly leveled for best mowing per- formance. See “TO LEVEL MOWER HOUSING” in the Service and Adjustments section of this manual. • The left hand side of mower should be used for trim- ming. • Drive so that clippings are discharged onto the area that has be...

15 MULCHING MOWING TIPS IMPORTANT: FOR BEST PERFORMANCE, KEEP MOWER HOUSING FREE OF BUILT-UP GRASS AND TRASH. CLEAN AFTER EACH USE. • The spe cial mulch ing blade will recut the grass clip- pings many times and reduce them in size so that as they fall onto the lawn they will disperse into the grass ...

16 MAINTENANCE BE FO RE E AC H US E T RAC T 0 R Inspect Muffler/Spark Arrester Lubrication Chart Check Brake Operation Clean Air Filter Change Engine Oil (with oil filter) Replace Air Filter Paper Cartridge Replace Spark Plug Check Battery Level Check Tire Pressure Clean Battery and Terminals FILL I...

17 MAINTENANCE BLADE REMOVAL (See Fig. 12) • Raise mower to highest position to allow access to blades. • Remove blade bolt, lock washer and fl at washer se cur ing blade. • Install new or resharpened blade with trailing edge up towards deck as shown. IMPORTANT: TO ENSURE PROPER ASSEMBLY, CENTER HOL...

18 MAINTENANCE V-BELTS Check V-belts for deterioration and wear after 100 hours of operation and replace if necessary. The belts are not ad just able. Re place belts if they begin to slip from wear. TRANSAXLE COOLING The transmission fan and cooling fi ns should be kept clean to assure proper coolin...

19 MAINTENANCE MUFFLER Inspect and replace corroded muffl er and spark arrester (if equipped) as it could create a fi re hazard and/or dam-age. SPARK PLUGS Replace spark plugs at the beginning of each mowing season or after every 100 hours of operation, whichever occurs fi rst. Spark plug type and g...

20 SERVICE AND ADJUSTMENTS WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER VICE OR AD JUST - MENTS • Depress clutch/brake pedal fully and set parking brake. • Place motion control lever in neutral (N) position. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “S...

21 SERVICE AND ADJUSTMENTS NUT "E" "D" "D" MANDREL FIG. 20 NUT "F" FRONT LINKS FIG. 21 FRONT-TO-BACK ADJUSTMENT (See Figs. 20 and 21) IMPORTANT: DECK MUST BE LEVEL SIDE-TO-SIDE. IF THE FOLLOWING FRONT-TO-BACK ADJUSTMENT IS NECESSARY, BE SURE TO AD JUST BOTH FRONT LINK...

24 SERVICE AND ADJUSTMENTS TO REPLACE HEADLIGHT BULB • Raise hood.• Pull bulb holder out of the hole in the backside of the grill. • Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill. • Close hood. INTERLOCKS AND RELAYS Loose or damaged wiring may c...

25 ENGINE TO AD JUST THROTTLE CON TROL CABLE (See Fig. 30) The throttle control has been preset at the factory and ad just ment should not be necessary. Check adjustment as described below before loosening cable. If adjustment is necessary, proceed as follows:• With engine not running, move throttle...

26 STORAGE Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more. WARNING: Never store the trac tor with gas o line in the tank inside a building where fumes may reach an open fl ame or spark. Allow the engine to cool before stor...

27 TROUBLESHOOTING POINTS Will not start 1. Out of fuel. 1. Fill fuel tank. 2. Engine not “CHOKED” properly. 2. See “TO START ENGINE” in Operation section. 3. Engine fl ooded. 3. Wait several minutes before attempting to start. 4. Bad spark plug. 4. Replace spark plug. 5. Dirty air fi lter. 5. Clean...

29 BATTERY FUSE IGNITION SWITCH RED RED RED BLACK IGNITION UNIT HEADLIGHTS REMOVABLE CONNECTIONS BLACK BLACK BLACK WHITE WHITE WHITE RED BLACK ORANGE BLACK BROWN BLACK BLACK BLACK STARTER M SEAT SWITCH (NOT OCCUPIED) GROUNDING CONNECTOR ATT'MENT CLUTCH (CLUTCH OFF) CLUTCH / BRAKE (PEDAL UP) SOLENOID...

30 TRACTOR - - MODEL NUMBER PD22H42STA ELECTRICAL 28 29 26 24 42 43 27 27 25 41 27 27 40 33 30 12 12 11 10 8 2 1 27 D.C . A MP ER ES 45 16 22 21 52 16

32 TRACTOR - - MODEL NUMBER PD22H42STA CHASSIS 10 30 209 31 1 9 208 209 209 5 5 207 26 144 26 10 209 142 209 142 58 208 13 208 11 64 143 60 145 37 37 18 14 14 38 38 166 39 209 2 206 74 159 chassis_elite sv_pro_7 17 28 264 263 259 258 261 144 26 26 60 219 20 219 23 217

34 TRACTOR - - MODEL NUMBER PD22H42STA DRIVE 66 29 28 112 13 14 41 38 39 57 120 74 75 78 76 77 1 25 19 24 2 53 35 34 37 36 35 62 36 64 65 59 56 55 63 77 61 22 27 26 6 113 18 51 5 18 6 85 52 30 32 32 30 52 11 85 80 4 3 81 84 82 145 79 16 96 26 26 26 89 90 27 51 48 150 151 202 49 47 50 120 21 8 10 156...

36 TRACTOR - - MODEL NUMBER PD22H42STA STEERING ASSEMBLY 5 5 3 43 95 43 8 10 40 11 8 6 87 46 46 8 6 87 29 88 71 17 43 91 2 1 41 42 37 36 37 38 12 39 44 51 54 68 67 67 67 13 65 68 15 15 15 29 29 82 4 32 26 30 28 steering_pl.lt_47

38 TRACTOR - - MODEL NUMBER PD22H42STA SEAT ASSEMBLY 1 188720 Seat2 140551 Bracket Pivot Seat 8 7203 71110616 Bolt Fin Hex 3/8-16 unc x 14 19131610 Washer 13/32 x 1 x 10 Ga.5 145006 Clip Push-In6 73800600 Nut Hex w/Ins. 3/8-16 unc7 124181X Spring Seat Cprsn 2 250 Blk Zi8 17000616 Screw 3/8-16 x 1.5 ...

39 TRACTOR - - MODEL NUMBER PD22H42STA DECALS NOTE: All component dimensions given in U.S. inches 1 inch = 25.4 mm KEY PART NO. NO. DESCRIPTION 6 2 1 5,8 4,10 3,9 11 7 WHEELS AND TIRES KEY PART NO. NO. DESCRIPTION KEY PART NO. NO. DESCRIPTION 10 3 16 9 1 59192 Cap Valve Tire 2 65139 Stem Valve 3 106...

40 TRACTOR - - MODEL NUMBER PD22H42STA ENGINE 2 1 OPTIONAL EQUIPMENT Spark Arrester 29 10 6 5 72 13 26 25 4 8 32 31 33 37 33 17 17 3 81 23 45 14 38 41 112 engine-bs intek-twin_39

42 15 14 13 11 10 9 8 16 68 30 31 32 33 146 148 145 150 45 144 147 147 142 149 142 54 52 53 55 56 34 1 46 44 21 24 25 26 27 2 28 29 23 21 21 21 18 18 20 2 48 59 19 4 3 5 6 21 40 143 36 40 37 40 159 140 37 184 42_deck_man-t-path_4. 118 136 21 139 18 119 117 116 5 21 134 21 5 134 135 136 116 113 117 1...

44 TRACTOR - - MODEL NUMBER PD22H42STA MOWER LIFT 36 15 20 16 17 18 20 20 15 20 4 5 6 2 3 1 6 5 4 7 8 37 41 40 38 12 11 3132 3132 19 19 13 13 13 13 23 24 25 27 28 29 30 50 26 49 lift-rh.1pc.stlt_10

46 LIMITED WARRANTY The Manufacturer warrants to the original consumer purchaser that this product as manufactured is free from defects in materi-als and work man ship. For a period of two (2) years from date of purchase by the original consumer purchaser, we will repair or replace, at our option, w...

47 15 DEGREES MAX. FOLD ALONG DO TTED LINE THIS IS A 15 DEG REE SLOPE ONLY RIDE UP AND DOWN HILL,NOT ACROSS HILL SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION WARNING: To avoid serious injury, operate your tractor up and down the face of slopes, never across the face. Do not mowslopes great...

Your POULAN PRO product has been expertly en gi neered and carefully manu fac tured to rigid quality stan dards. As with all mechanical products, some adjustments or part replacement may be necessary during the life of your unit. FOR SERVICE OR REPLACEMENT PARTS: 1. Consult your dealer/place of purc...