Poulan PRO 115225426 - Manuals

Page 3 - IDENTIFICATION OF SAFETY SYMBOLS

3 IDENTIFICATION OF SAFETY SYMBOLS When servicing unit, use only identical replacement parts. Never allow children to operate this unit. Store unit indoors in a high, dry place out of the reach of children. Always stop unit and disconnect spark plug before clean- ing or servicing. WARNING: Fire haza...

Page 4 - OPTIONAL ATTACHMENTS; SAFETY RULES; OPERATOR SAFETY

4 OPTIONAL ATTACHMENTS Cutting attachment / guard, Powerhead model Attachments Type part. no. Trimmer head WE fixed line 545053902 / 545003325 Brushcutter attachment PP4000C 952711610 Attachments Type Part. no. Edger attachment PP1000E 952711607 Cultivator attachment PP2000T 952711608 Pruner attachm...

Page 8 - SNOW THROWER SAFETY

8 WARNING: Falling objects can cause severe head injury. Wear head protec- tion when operating this unit with a pole prun- er attachment. WARNING: To prevent serious injury, do not use more than one boom extension with a pole pruner attachment. WARNING: Keep the pruner away from power lines or elect...

Page 9 - ASSEMBLY; INSTALLING TRIMMER ATTACH-

9 ASSEMBLY WARNING: If received assembled, repeat all steps to ensure your unit is properly assembled and all fasteners are secure. Examine parts for damage. Do not use dam- aged parts. NOTE: If you need assistance or find parts missing or damaged, call 1-800-554-6723.It is normal for the fuel filte...

Page 10 - OPERATION; HELPFUL TIP

10 ADJUSTING THE HANDLE WARNING: When adjusting the han- dle, be sure it remains above the safety label and below the mark or arrow on the shaft. 1. Loosen wing nut on handle. 2. Rotate the handle on the shaft to an up- right position; retighten wing nut. OPERATION KNOW YOUR UNIT READ THIS INSTRUCTI...

Page 12 - OPERATING INSTRUCTIONS; OPERATING POSITION

12 WARNING: Always stop unit and dis- connect spark plug before removing or instal- ling attachments. REMOVING TRIMMER ATTACH- MENT (OR OTHER OPTIONAL ATTACHMENTS) CAUTION: When removing or installing at- tachments, place the unit on a flat surface for stability. 1. Loosen the coupler by turning the...

Page 13 - CUTTING METHODS

13 CUTTING METHODS WARNING: Use minimum speed and do not crowd the line when cutting around hard objects (rock, gravel, fence posts, etc.), which can damage the trimmer head, become entangled in the line, or be thrown causing a serious hazard. S The tip of the line does the cutting. You will achieve...

Page 14 - MAINTENANCE

14 MAINTENANCE WARNING: Disconnect the spark plug before performing maintenance except for carburetor adjustments. HELPFUL TIP IMPORTANT: Have all repairs other than the rec- ommended maintenance described in the instruction manual performed by an authorized service dealer. If any dealer other than ...

Page 15 - SERVICE AND ADJUSTMENTS; REPLACING THE LINE

15 SERVICE AND ADJUSTMENTS REPLACING THE LINE For unit to operate properly, the cutting line should be replaced when line becomes worn to less than 3 inches in length from the edge of the line exit tunnels on each side of the cutting head. 1. Remove and discard worn line before installing new line. ...

Page 16 - STORAGE; SEASONAL STORAGE; ENGINE

16 Air Filter Cover Idle Speed Screw If you require further assistance or are unsure about performing this procedure, contact an authorized service dealer or call 1--800--554--6723. STORAGE WARNING: Perform the following steps after each use: S Allow engine to cool before storing or trans- porting. ...