POSIFLEX XP3000 - Manuals

Page 5 INSTALLATION GUIDES Hardware Power Switch and printer paper feed The power switch located in the front bezel of main unit. It is a pushbutton switch and controls the power on/off of the whole system. Also, next to the power and status indicators is the paper feed button for integrated printer...

Page 6 CAUTION: Before any installation or cable connection to the set, please always make sure that the system is turned off and the external power source to the set is removed to prevent electric hazard! Never touch any metal pin in the connectors or circuits to avoid high voltage hazard or electr...

Page 7 the preloaded Windows system with a USB interface touch panel controller. This program can also be obtained by download from the POSIFLEX web site. Mouse Emulation Touch Function The touch panel in XP-3000/3300 system uses internal USB interface as standard and occupies no external port. When...

Page 9 appropriate position of sensor block. The default height of near end sensor is the lowest position. Self Test For XP-3000/3300 series printer’s test mode, please turn off the terminal first. After the system power off, please press and hold down the feed button while turning on the system pow...

Page 10 highest priority of printer setup mode. For the setup priority of printer, whatever hardware switch or software setting can be choose by software. CAUTION: On doing any function’s modification of switches, please contact authorized dealer or technicians. Failure to do this could make the pri...

Page 11 UPS Battery (Option) CAUTION: Please notice that to connect the UPS battery only before power up the system or when system is switch off. Always disconnect the UPS battery when the system is to be left powered off for more than few days. When the XP-3000/3300 system is ordered with the UPS b...

Page 12 I/O Plate Please follow steps A to C sequentially with reference to pictures to use the I/O Plate. Step A: Please hold the LCD panel and push lock/release lever for tilt angle adjust backward. Step B: Turn the panel backward to most horizontal position Step C: Please hold the base and pull u...

Page 13 N evertheless, except Posiflex peripheral device, do not connect any other device to this port before the power in this port is disabled. CAUTION: Please turn off the system power first! Then hold the base and move the terminal carefully. Connecting Cables To have the terminal ready for oper...

Page 14 Rear Mount Upgrade Kit There are plenty of upgrade kits of XP-3000/3300 series for choice. To install these upgrade kits, please refer the installation guide of each kit. For some interface such as serial ports and VGA ports, please remember to enable the power supply of the main unit for th...

Page 15 the DC power to the 2 nd display, it required a qualified technician to set the power supply in XP main unit through the VGA connector according to Posiflex technical information. Do not connect other monitor to this port before the power in this port is disabled. Note: When 2 nd display is ...

Page 16 required drivers will be available on our web: http://www.posiflex.com. Then follow instructions from your system integrator for software recovery. Operating System Installation This product is highly professionalized equipment. The installation of an OS into a machine without any preloaded ...

Page 17 unexpected result even if the battery is not in work. The UPS battery can support basically the data preservation and smooth operation during intermittent or up to 30 minutes. Battery replacement: In the preloaded OS for Jiva system, there is a built in utility Power Manager that will interf...

Page 18 Please notice that if the XP system is improperly turned off before a complete boot up procedure, the above preset power on control functions will be disabled until next turning off after a complete boot up. Storage Device The standard system storage device is 2.5” SATA HDD in the main unit....