POSIFLEX 6800 - Manuals

Page 5 INDICATORS * Power LED: Green. * Error LED: Red (brief lit indicates printer busy). * Paper out LED: Red. QUICK START-UP LOADING PAPER Desk Top Application Press down the hood release button to release the top hood as in Pix. 1 . Raise the released hood wide open manually as in Pix. 2 . Drop ...

Page 6 Furthermore, during the standby mode (not in the power off mode), it can straight to replace the paper roll. The printer will automatically cut the unnecessary paper right after the top hood closed. CONNECTING CABLES Serial Connection All the external connectors are in the recessed area at th...

Page 7 Peripheral Connection The peripheral controller is a 6-pin RJ11 type modular jack. With use of Posiflex cash drawer cable come with cash drawer, this port can control a Posiflex cash drawer CR3100 or CR3200 or CR4000 or CR4100 or CR-6310. If a Posiflex special split cable is used instead, thi...

Page 8 The header is printed in text mode and the rest part of this slip is printed in page mode. If FEED button is pressed at this moment, a font table will be printed in text mode again. To exit the test printing, please turn the printer off and on again. SPECIAL ADJUSTMENTS Paper Near End Sensor ...

Page 9 Paper Cutting Generally, after paper printed and automatically cut every time, printer will retract the paper roll in order to reduce the paper loss. When the auto-cut function enable, the printer will leave the advance paper in 4.8 mm long. Incase the user applies cut without paper feed thro...

Page 10 LAN POS Printer Manager This utility can be used to manage multiple Aura-6800L’s connected in same network under Windows as long as there is no conflicting IP in the network. This utility can assign to each LAN printer a different device name for easy recognition. In case of confusion, pleas...

Page 11 * When handling the interior of the thermal printer, please pay attention not to be hurt by any sharp edge of the metal parts. GENERAL CLEANING Please use soft hairbrush or compressed air to clear away any dust or paper scraps accumulation inside the printer. Check also the area of the auto-...

Page 12 Nothing can be printed with ERROR LED ON – Check the Paper Out LED. If it is ON, most probably either the paper roll is not installed or the paper roll is at or near the end. Install a new paper roll. If the Paper Out LED is OFF, please check if the print hood is properly closed. There are 2...

Page 13 release button is pressed. Should the cutter jam be so serious to interfere the hood release operation, please re-close the hood and try opening it again. Never force open the top hood. Please also clear away any contaminants accumulated in the cutter track above the thermal elements. Advanc...

Page 14 * Do not touch the areas around the print head and motor during or right after printing. It can be very hot. * Do not allow the cut receipt to slide back into the cutter during the operation. As this would lead to multiple cutting at the lower edge of a receipt and the multiple cut thin slip...

Page 15 Thermal head configuration 512 dots / line(Maximum 576 dots/line) Printing speed 150 mm / sec. max. Paper feed method Friction auto-feed Paper load method Drop and use Auto-cutter capability Partial cut (1 point at center left) Manual cutter Saw tooth blade Dot Pitch 0.125 x 0.125 mm Input p...

Page 19 Switch position 6 defines the parity check regulation in serial interface. In Aura-6800, it is selectable between even and none. For switch position 7 can choice the handshaking method in serial interface. When it is set to ON, the printer transmits an “XOFF” for busy and sends an “XON” for ...