Porter-Cable PC2525SP - Manuals

5- ENG D25115 RISK OF UNSAFE OPERATION • If proper starting procedure is not fol-lowed, engine can kickback causingserious hand and arm injury. HAZARD HOW TO PREVENT IT WHAT CAN HAPPEN • Become familiar with the operation and controls of the pressure washer. • Keep operating area clear of all person...

6- ENG D25115 HOW TO PREVENT IT WHAT CAN HAPPEN HAZARD RISK OF CHEMICAL BURN • Use of acids, toxic or corrosive chemi- cals, poisons, insecticides, or any kindof flammable solvent with this productcould result in serious injury or death. • Do not use acids, gasoline, kerosene, or any other flammable...

7- ENG D25115 HOW TO PREVENT IT WHAT CAN HAPPEN HAZARD RISK OF HOT SURFACES • Contact with hot surfaces, such as engines exhaust components, couldresult in serious burn. • During operation, touch only the control surfaces of the pressure washer. Keepchildren away from the pressure washerat all times...

8- ENG D25115 BOX CONTENTS Bagged Handle Bagged Parts Nozzle Cleaning Kit Engine Frame and Wheel Assembly High Pressure Hose Chemical Hose Engine Oil Spray Gun Knobs SaddleBolts Quick Connect Wand Grommet Kit with Quick Connect Nozzles Engine Manual Handle Parts Manual English/ Spanish/ French Opera...

9- ENG D25115 5. Assemble grommet kit andquick-connect nozzles asdescribed in instructions sup-plied . 6. Add engine oil (supplied) toengine. Refer to engine manualsupplied by engine manufacturerfor correct procedure. NOTE: There will be a slight amount of oil in the engine from factory test-ing. NO...

10- ENG D25115 PRESSURE WASHER High Pressure Pump : Increases the pressure of the water supply. Engine: Drives the high pressure pump. High Pressure Hose: Carries the pressurized water from the pump tothe gun and wand. Spray Gun: Connects with wand to control water flow rate, direction, andpressure....

11- ENG D25115 TO ADJUST PRESSURE The pressure setting is preset at thefactory to achieve optimum pressureand cleaning. If you need to lower thepressure, it can be accomplished bythese methods. 1. Back away from the surface to becleaned. The further away youare, the less the pressure will beon the s...

12- ENG D25115 The nozzles arehoused in receptacleson the panel of thepressure washer han-dle. Colors on thepanel identify nozzlelocation and spraypattern. Risk of injection orinjury to person. Do not direct discharge stream towardpersons, unprotected skin, eyes, orany pets or animals. Serious injur...

13- ENG D25115 TO SIPHONCHEMICALS/CLEANINGSOLVENTS Siphoning chemicals or cleaning sol-vents is a low pressure operation. NOTE: Use only soaps and chemi- cals designed for pressure washeruse. Do not use bleach. 1. Press chemical hose ontobarbed fitting located near highpressure hose connection ofpum...

14- ENG D25115 NOTE: Water source must providea minimum of 5 gallons per minuteat 20 p.s.i. 6. If you are applying a chemical orcleaning solution, See How To Siphon Chemicals/CleaningSolvents in Operation section of this manual. 7. Turn water source on. NOTE: Make sure water supply isturned on. 8. S...

15- ENG D25115 MAINTENANCE WHEN PERFORMING MAINTENANCE, YOU MAY BEEXPOSED TO HOT SURFACES, WATER PRESSURE, MOV- ING PARTS, OR FIRE RESULTING IN DEATH. BEFORE PERFORMING ANYMAINTENANCE OR REPAIR, DISCONNECT SPARK PLUG WIRE, LETENGINE COOL AND RELEASE ALL WATER PRESSURE. THE ENGINE CON-TAINS FLAMMABLE...

16- ENG D25115 2. Disconnect spark plug wire. 3. Pull trigger on gun handle torelieve any water pressure. 4. Disconnect the wand from thegun. 5. Remove the high-pressure nozzlefrom the wand. Remove anyobstructions with the nozzlecleaning tool provided and back-flush with clean water. 6. Direct water...

17- ENG D25115 ENGINE Refer to the engine manual for themanufacturer’s recommendations forstorage. PUMP It is recommended that you followthese steps to protect the internalseals of the pressure washer when storing the unit for an extendedperiod and WHEN FREEZING TEM-PERATURES ARE EXPECTED. NOTE: If ...

18- ENG D25115 TROUBLESHOOTING GUIDE PROBLEM CAUSE CORRECTION Engine will notstart 1. No fuel. 2. Pressure builds up aftertwo pulls on the recoilstarter or after initial use. 3. Not choked. 4. Spark plug wire notattached. 5. Choke lever in the"Choke" position on a"hot" engine or an e...

19- ENG D25115 6. Air in hose. 6. Turn off the engine, thenthe water source.Disconnect the watersource from the pumpinlet and turn the watersource on to remove all airfrom the hose. When thereis a steady stream ofwater present, turn watersource off. Reconnectwater source to pump inletand turn on wat...

LIMITED WARRANTY PORTER-CABLE CORPORATION warrants to the original purchaser that all products covered under this warranty are free from defects in material and workmanship. Products covered under this warranty include aircompressors, air tools, service parts, pressure washers, and generators, which...