Porter-Cable D22885-011-0 - Manuals

5 — ENG OWNER’S RESPONSIBILITIES • DO NOT RETURN THIS PRODUCT TO THERETAILER! Call 1-888-559-8550. • Read and understand all safety warnings. • Read this Owner’s Manual. • Do not operate this unit until you have read thisOwners Manual for Safety, Operation, andMaintenance Instructions. • Read the En...

6 — ENG D22885 BOX CONTENTS Bagged Handle Handle Engine Manual Bagged Parts Nozzle Cleaning Kit Knobs w/hardware English/ Spanish/ French Operator’s Manual Engine Frame and Wheel Assembly High Pressure Hose Chemical Hose Engine Oil Spray Gun Multi-Reg Wand PCV2021 Accessories Panel with hardware PCV...

7 — ENG D22885 2. Connect wand to gun. Tighten securely. 3. Attach high pressure hose to gun. NOTE: The point of attachment for the high pressure hose willdiffer depending on the model purchased. Tightensecurely. ASSEMBLY 1. Connect handle to frame. To connect handle and hose reel to PCH3540HR: a. C...

8 — ENG D22885 REMOVE SHIPPING PLUG(PCH2627, PCH3030) THE PUMP IS SHIPPED FROM THE FACTO-RY WITH OIL IN IT AND A REDSHIPPING PLUG TO PREVENT ANY OIL FROM LEAKING OUT OF THEPUMP DURING SHIPMENT. ATTACHED TOTHE SHIPPING PLUG IS A PLASTIC BAG(SEE THE FOLLOWING PHOTO) WHICHCONTAINS THE DIPSTICK/OIL PLUG...

9 — ENG D22885 OPERATION BASIC ELEMENTS OF A PRESSUREWASHER High Pressure Pump : Increases the pressure of the water supply. Engine: Drives the high pressure pump. High Pressure Hose: Carries the pressurized water from the pump to the gun and wand. Spray Gun: Connects with wand to control water flow...

Pressure Adjustment The pressure setting is preset at the factory to achieveoptimum pressure and cleaning. If you need tolower the pressure, it can be accomplished bythese methods. 1. Back away from the surface to be cleaned.The further away you are, the less the pressurewill be on the surface to be...

11 — ENG D22885 For Quick-Connect Turret Wands (PCH2425, PCH2627, PCH3030, PCH3540HR): Spray Nozzles The turret holds five spray nozzles. Each nozzle iscolor coded and delivers a specific spray pattern for aparticular cleaning purpose. The 0º, 15º , 25º , and 40ºnozzles are high pressure nozzles. Th...

12 — ENG D22885 STARTING 1. Add fresh high quality unleadedgasoline. Never fill fueltank indoors. Never fill fuel tank when engine isrunning or hot. Do not smokewhen filling fuel tank. Never fill fuel tank com-pletely. Fill tank to 1/2" below bottom of filler neck to provide spacefor fuel expans...

13 — ENG D22885 SHUTTING DOWN 1. If you have siphoned chemicals, siphon a bucketof clean water through the chemical hose. NOTE: Failure to do so will cause damage to the pump. 2. Turn engine off. See Engine Owner’s Manual. NOTE: NEVER turn the water off with the enginerunning. Never turn water suppl...

14 — ENG D22885 PUMP TYPE OIL TYPE OIL CAPACITY CHANGE OIL Annovi Reverberi (XMV) Annovi Reverberi (XRV) Annovi Reverberi (XTV) DAPC (axial cam) DAPC (radial) Cat 30W non detergent 30W non detergent 30W non detergent * R&O 150 ** none 30W non detergent 13.5 oz. 18.54 oz. 9.92 oz. 8 oz. red dot o...

15 — ENG D22885 HOW TO CHANGE PUMP OIL 1. Loosen oil fill cap. 2. Place a container under the oil drain plug. 3. Remove oil drain plug. 4. After oil is drained replace oil drain plug. Tightensecurely. 5. Remove oil fill cap and fill with recommended oil.See the Pump Maintenance Chart for the correct...

16 — ENG D22885 5. Add RV antifreeze to hose as shown. 6. Pull engine starter rope slowly several times until antifreeze comes out of high pressure hose con-nection of pump. 7. Remove short hose from water inlet of pump. 8. Install spark plug into spark plug hole and tighten securely, then reconnect...

17 — ENG D22885 PROBLEM CAUSE CORRECTION Engine will not start (see Engine Manual forfurther engine trouble-shooting) 7. Chemical build up in chemicalinjector. No or low pressure (initial use) Will not draw chemicals TROUBLESHOOTING GUIDE 1. Wand not in high pressure. 1. See How to Use Wand paragrap...

18 — ENG D22885 PROBLEM CAUSE CORRECTION No or low pressure (afterperiod of normal use.) Water leaking at gun/wandconnection Water leaking at pump Oil leaking at pump (if applicable) 1. Worn seal or packing. 2. Worn or obstructed valves. 3. Worn unloader piston. 4. Worn E-Z start valve. 1. Worn or b...

19 — ENG D22885 LIMITED WARRANTY Porter-Cable Corporation warrants to the original purchaser that each new pressure washer, service part, and accessory is free from defects in material and workmanship, and agrees to repair or replace under this warrantyany defective product or part as follows from t...

D22885 QUICK FACTS CALL 1-888-559-8550 TO FIND A LOCAL AUTHORIZED SERVICE CENTER NEAR YOU FOR REPAIRS AND SERVICE PART PURCHASES. ALWAYS REFER TO THE MANUALS SUPPLIED WITH THIS UNIT HOSE GAS OIL WATER PRESSURE ADJUSTMENT PUMP BY-PASS MODE THERMAL RELIEF VALVE Use fresh high quality gas.Add stabilize...