Porter-Cable BN125A - Manuals

Page 2 - IMPORTANT SAFETY INSTRUCTIONS; When using pneumatic tools, basic safety precautions should

IMPORTANT SAFETY INSTRUCTIONS WARNING: When using pneumatic tools, basic safety precautions should always be followed to reduce the risk of personal injury, including thefollowing: READ AND FOLLOW ALL INSTRUCTIONS. There are certain applications for which this tool was designed. Porter-Cablestrongly...

Page 4 - REMOVE FINGER FROM TRIGGER; Keep proper; DO NOT DRIVE FASTENERS; on top of; DO NOT DRIVE FASTENERS CLOSE; or for tasks in which changing

Fig. 12 Fig. 13 Fig. 13A 4 16. REMOVE FINGER FROM TRIGGER when not driving fasteners. Never carry toolwith finger on trigger: tool may fire a fastenerif safety is bumped while trigger isdepressed. Fig. 10. 17. DON’T OVERREACH. Keep proper footing and balance at all times when usingor handling the to...

Page 5 - FOREWORD; see ACCESSORIES Listing in back of this manual.; POWER SOURCE

5 EMPLOYER’S RESPONSIBILITIES Employer must enforce compliance with the safety warnings and all otherinstructions contained in this manual. Keep this manual available for use by all people assigned to use this tool. For personal safety and proper operation of this tool, read and follow all ofthese i...

Page 6 - PREPARING THE TOOL; Keep tool pointed away from yourself and others at all times.; USING THE TOOL

Fig. 16 Fig. 17 ← 6 PREPARING THE TOOL 1. After reading and understanding this entire manual, connect tool to air supply. CAUTION: Keep tool pointed away from yourself and others at all times. Always connect tool to air supply before loading fasteners. Do not load fasteners with trigger or safety de...

Page 7 - Do Not; use the tool unless both the

7 To fire, grip tool firmly, position nose of tool onto work surface, push forwardon tool to depress safety, and squeeze trigger to fire a fastener. This “triggerfire” method provides the most accurate fastener placement. This tool isshipped from the factory with a “restrictive fire trigger” that on...

Page 8 - CLEARING A JAMMED FASTENER; Disconnect tool from air supply.; NOSE CUSHION; Disconnect tool from air supply before removing or

8 CLEARING A JAMMED FASTENER 1. CAUTION: Disconnect tool from air supply. 2. Open magazine and remove any remaining fasteners. CAUTION: Remove fasteners from tool before opening the fastener guide plate. Fasteners are under pressure and may shoot out ofmagazine which could cause injury. 3. Depress t...

Page 9 - MAINTENANCE; CLEAN AND INSPECT DAILY; Disconnect tool from air supply before cleaning and; SERVICE AND REPAIRS; TROUBLESHOOTING; Disconnect tool from air supply before performing any

9 MAINTENANCE CLEAN AND INSPECT DAILY CAUTION: Disconnect tool from air supply before cleaning and inspection.Correct all problems before placing the tool back in use. Wipe tool clean and inspect for wear or damage. Use non-flammable cleaningsolutions to wipe exterior of tool only if necessary. DO N...

Page 10 - ACCESSORIES; Since accessories other than those listed have not been; “OVERHAUL” Maintenance Kit

10 PORTER-CABLE LIMITED ONE YEAR WARRANTY Porter-Cable warrants its nailing and stapling tools for a period of one year from the date of originalpurchase. We will repair or replace at our option, any part or parts of the product and accessoriescovered under this warranty which, after examination, pr...

Page 11 - PORTER-CABLE SERVICE CENTERS; DELTA SERVICE CENTERS

The following are trademarks of PORTER-CABLE Corporation (Las siguientes son marcas registradas de PORTER-CABLE S.A.) (Les marquessuivantes sont des marques de fabriquant de la PORTER-CABLE Corporation): BAMMER ® , LASERLOC ® , OMNIJIG ® , POCKET CUTTER ® , PORTA-BAND ® , PORTA-PLANE ® , PORTER-CABL...