Planet VIP-320 - Manuals - manualsarea.com

Page 3 - TABLE OF CONTENTS

3 TABLE OF CONTENTS Chapter 1 Introduction .......................................................................... 5 Overview............................................................................................................................ 5 Package Content ................................

Page 5 - Chapter 1 Introduction; Overview; Firewall/Security Feature; SPI (Stateful Packet Inspection) firewall; VoIP Functions

1 Chapter 1 Introduction Overview With years of Internet telephony and router manufacturing experience, PLANET proudly introduces the newest member of the PLANET VoIP gateway family: the VIP-320. As a direct response to feedback from our customers, PLANET's new VoIP gateway, the VIP-320, not only pr...

Page 6 - DECT Features; Package Content

6 • Voice processing: Voice Active Detection, DTMF detection/ generation, G.168 echo cancellation (16mSec.), Comfort noise generation, Call progress detection, Gain Control DECT Features • DECT & GAP Compatible • Base can register up to 8 Handsets • Intercom call during external call, Call trans...

Page 7 - Physical Details; The following figure illustrates the front/rear panel of VIP-320.; Front Panel of VIP-320

7 Physical Details The following figure illustrates the front/rear panel of VIP-320. Front Panel of VIP-320 Rear Panel of VIP-320

Page 8 - LED Display & Button; The Default LAN IP is; Note

8 LED Display & Button Front Panels Descriptions Paring LED When the base connect to the handset Battery Charge When charging the handset’s battery Handset charge Holder Holder the handset Intercom When it pairing LED Indicators Descriptions LINE LINE LED will light when PSTN line is in use VoIP...

Page 9 - Overview of DECT handset DCT-100; Keypad and button definition on DCT-100; Descriptions

Overview of DECT handset DCT-100 Keypad and button definition on DCT-100 Descriptions INT Intercom conversation mode Adjust the volume level during the conversation and menu selection on the LCD display Last Number Redial Hang on / up telephone or pressing until to open /close speaker C Cancel and C...

Page 10 - DCT-100 installation; Replace the battery cover, slide the cover up until it snaps shut.

10 Reversing the orientation may damage the handset. The battery needs to be replaced if it does not recover its full storage capacity after recharging. When replacing batteries, always use good quality Ni-MH re-chargeable AAA size batteries. Never use other batteries or conventional alkaline batter...

Page 11 - Physical Installation Requirement; Administration Interface; admin

2 Chapter 2 Preparations & Installation Physical Installation Requirement This chapter illustrates basic installation of VIP-320 • Network cables. Use standard 10/100BaseT network (UTP) cables with RJ45 connectors. • TCP/IP protocol must be installed on all PCs. For Internet Access, an Internet ...

Page 12 - LAN/WAN Interface quick configurations; default LAN side IP address is “; LAN IP address configuration via web configuration interface; Execute your web browser, and insert the IP address (default:; Parameter Description; Hint; LAN IP address of VIP-320

Please locate your PC in the same network segment (192.168.0.x) of VIP-320. If you’re not familiar with TCP/IP, please refer to related chapter on user’s manual CD or consult your network administrator for proper network configurations. Í Note LAN/WAN Interface quick configurations Nature of PLANET ...

Page 13 - WAN IP address configuration via web configuration interface; Save Modification to Flash Memory

It is suggested to keep the DHCP server related parameters in default state to keep machine in best performance. L Hint After confirming the modification you’ve done, Please click on the Modify button to macke the changes effective. WAN IP address configuration via web configuration interface Execut...

Page 15 - Configuring and monitoring your VIP-320 from web browser; Overview on the web interface of VIP-320; Log on VIP-320 via web browser

3 Chapter 3 Network Service Configurations Configuring and monitoring your VIP-320 from web browser The VIP-320 integrates a web-based graphical user interface that can cover most configurations and machine status monitoring. Via standard, web browser, you can configure and check machine status from...

Page 17 - “System

Chapter 4 VoIP Configurations VIP-320 Status This page main display the current and last time VoIP call status & result. Parameter Description PC Time will show the date & time that your connected PC now. Gateway Time will show the date & time of this VoIP router, the date amd time is ge...

Page 18 - Server; Line Setting

Server ” Error Message For some reason (ex. All lines of this VoIP router are busy), here will display the failure information of last time VoIP Call in. Line Setting This page will setup the phone line information each port. Parameter Description Port display FXS interfase the port number. Interfac...

Page 19 - Tone Config

number. That mean it will direct call out by VoIP when you off hook the phone of this line. Tone Config This page defines the tones generated to the phone connected to the phone port. All lines use same tone parameters. After modify the tone parameters, you must save modify then Reboot to let the mo...

Page 20 - VoIP Call Out; for call out rule without needed to press # key.

VoIP Call Out This page defines the routing rule for Call out to VoIP. (User key in the phone number through phone set dial pad, then VoIP router translate the phone number by the routing table setting here to destination IP, and dial out number then call out via network protocol). Each time when yo...

Page 22 - mean wait 1 second; Profile; VoIP Config Routing Setup Routing Profile; Delete; Syetem Maintenance Save Modification; When user enable the hot line function on “; VoIP Config; menu, it will over ride the; VoIP Call In; Area Code”

number will be 0,22199518 ( “ , “ mean wait 1 second ). This example is especially for speed dial function. Profile Define the optional special call out parameters on this destination. Please input the name you Udefined on the profile (Please refer to the “ VoIP Config Routing Setup Routing Profile ...

Page 25 - Call Setup

Please remember to press the modify button to take it effect. For store back to flash memory, please press “ Save Modification” (Plaase refer to the “ Syetem Maintenance Save Modification ”). Call Setup This page defines the optional special VoIP parameters when making/received a VoIP call. For defi...

Page 26 - Save Modification”; Call Forwarding

OFF: FAX over IP is disable. Package Frame Select the voice payload frame on each UDP package VoIP transmit. More frames into one package is save more bandwidth. The default frames on each package is 3. Q.931 Fast Start ON: Enable Fast Start capability during Q.931 handshaking. OFF: Disable Fast Sta...

Page 28 - Register Server

28 Register Server If this VoIP router want to use GK/SIP proxy service to transfer the VoIP call, you can input the GK /SIP information here. The VoIP router can register to up to four GK/SIP proxy simultaneously. Parameter Description Register Server Status Success: Register successful. Failure: R...

Page 29 - SIP protocol; Done”; WebCall; VoIP Config Web Call Setting

When voice communication is established via H.323 protocol , please add a ”h323:” in front of the IP address. Such as: the GK IP address is 192.168.0.100, then input “h323:192.168.0.100” in the IP address. When voice communication via the SIP protocol , please add a “sip:” in front of the IP address...

Page 30 - WebCall Config; Web Call accept List:

30 Parameter Description Gateway IP Show the IP of this VoIP router Name Select the name you want to make connect, this is defined on Web Call page. (Please refer to the “ VoIP Config Web Call Setting Web call ). Call Press to make a call. Stop Stop the call. WebCall Config This page let you define ...

Page 31 - Browse; button to select the “Welcome” file you want to upload and; Upload; Delete this rule item on routing table.; Stop; valid name for Web Call user

name, please rename your logo graphic file(.bmp, .jpg, .gif) to “Welcome” before upload. There is a file size limitation. Please press the Browse button to select the “Welcome” file you want to upload and press Upload to Upload it. Delete Delete this rule item on routing table. Stop Stop the call. S...

Page 32 - Chapter 5 System Configurations; System Config; Bridge Mode Setting; setting will be ignored.; Password; New password in the New Password and Confirm New Password fields.; ” and the password is “; Basic Setup; firewall built inside the router.

5 Chapter 5 System Configurations System Config Bridge Mode Setting This page allows you to disable/enable this device become bridge device or not. When it becomes a bridge device, bridge interface use LAN's IP address, LAN's subnet mask. When working on Bridge Mode, the VoIP router will use only th...

Page 33 - LAN to WAN Access Rules; Access Rules” at System Setup Firewall WAN-to-LAN Access Rules

LAN-to-WAN Access Rules: You can define LAN-to-WAN network access rules which evaluate the network traffic's source IP address, destination IP address, and communication port to decide if it's allowed to pass through the firewall. WAN-to-LAN Access Rules: You can define WAN-to-LAN network access rul...

Page 34 - WAN to LAN Access Rules; through the firewall.; Access Rules” at System Setup Firewall LAN-to-WAN Access Rules; Discard all sessions originating from the Internet to the LAN.; This page display the Current Status of the VoIP router.; Dynamic DNS Setting; more advanced knowledge about TCP/IP might still be required.

34 The ability to define network access rules is a very powerful management tool. Using a custom rule, it's possible to disable all firewall protection, creating holes in the firewall, or block all access to the Internet. Use with extreme caution when creating or deleting network access rules. Netwo...

Page 35 - DHCP Server Setting; server on the network.; Show Current IP Ranges; To assign a fixed-IP for a certain host on private network, click “; Static Routing; supports RIP I and RIP II standards.; View or Add Static Routing Table

35 When any change is made on this page, you MUST restart all PCs to update their TCP/IP settings from this DHCP server. Adding incorrect routing information can affect the connection, a local host, or the whole private network. You must have experience working with routing tables before using this ...

Page 36 - Virtual Server; requests on the private network.; DMZ; This page let you set up the DMZ service on the VoIP router.

36 Virtual Server This page allows you to map a TCP or a UDP port of the router to a host which actually deals with requests on the private network. DMZ This page let you set up the DMZ service on the VoIP router.

Page 37 - System Maintenance; Configurations; Saved modification”; Never power off the VoIP router when during Restore; Reboot System; Saved modification

37 System Maintenance This page let you backup / Restore all of your configuration parameters on the VoIP router. It is very good idea to back up all of your VoIP router configuration parameters after install. Configurations To Backup, press Download setting backup file, and input the file name you ...

Page 38 - Appendix A Voice communications

38 Appendix A Voice communications There are several ways to make calls to desired destination in VIP-320. In this chapter, we’ll lead you step by step to establish your first voice communication via web browsers operations. Peer-to-Peer (P2P) mode VIP-280/320 WAN IP Address: 172.16.0.1 Number: 7001...

Page 39 - H.323 IP phone, and number 2001 to connect to the SIP IP phone.; Voice communication via SIP proxy server –SIP50; Please log in machine via web browser, and select; setting; VoIP

When the calling party is an H.323 device, please add a ” h323: ” in front of the IP address. Such as: the destination H.323 device is 172.16.0.100, theninput “ h323:172.16.0.100 ” in the IP address column of VIP-320/VIP-280 VoIP Callout setting page When the calling party is a SIP device, please ad...

Page 40 - When voice communication is established via “; Gatekeeper; please add a ”

When voice communication is established via “ Gatekeeper ”, please add a ” h323: ” in front of the IP address. Such as: the GK IP address is 192.168.0.100, then input “ h323:192.168.0.100 ” in the IP address. When voice communication via the SIP proxy server, pleaseadd a “ sip: ” in front of the IP ...

Page 41 - status, make sure the registrations are completed.; Test the scenario:

STEP 4: Repeat the same configuration steps on the VIP-280, and check the machine registration status, make sure the registrations are completed. ====================================================== Test the scenario: To verify the VoIP communication, you may make calls from SIP client (VIP-280) 2...

Page 42 - Appendix B VIP-320 Specifications

42 Appendix B VIP-320 Specifications Product H.323/ SIP DECT VoIP Router Model VIP-320 Hardware LAN 2 x 10/100Mbps RJ-45 port WAN 1 x 10/100Mbps RJ-45 port PSTN 1 x RJ-11 connection DECT 1 x DECT GAP compatible base Standards and protocol Standard H.323 version v2/v3,H.323 Fast start, and H.245 DTMF...