Planet POE-151 - Manuals - manualsarea.com

Page 2 - Trademarks; Disclaimer; FCC Warning; WEEE Warning

- 2 - Trademarks Copyright  PLANET Technology Corp. 2006. Contents subject to revision without prior notice. PLANET is a registered trademark of PLANET Technology Corp. All other trademarks belong to their respective owners. Disclaimer PLANET Technology does not warrant that the hardware will work ...

Page 3 - TABLE OF CONTENTS; IEEE

- 3 - TABLE OF CONTENTS 1. INTRODUCTION .......................................................................................................................................... 4 1.1 C HECKLIST ...........................................................................................................

Page 4 - Injector package shall contains following contents:; Check the contents of your package for following parts:; About the Power over Ethernet Injector

- 4 - 1. INTRODUCTION 1.1 Checklist Thank you for purchasing our POE-151 IEEE 802.3af Power over Ethernet Injector, your Power over Ethernet Injector package shall contains following contents: Check the contents of your package for following parts: Power over Ethernet Injector x1 User's manual CD x1...

Page 5 - Model; LED

- 5 - 1.4 Specification Model POE-151 Ethernet Connector 2 x RJ-45( 1 for data + DC in, 1 for Data out) Ethernet Data rate 10/100Mbps( vary on Ethernet device attached) Input voltage DC 48V, 0.4A Number of device can be powered 1 Ethernet cable TIA/EIA-568, Category 5/5e cable LED indicator 1 x powe...

Page 6 - HARDWARE INSTALLATION; Before Installation

- 6 - 2. HARDWARE INSTALLATION This product provides two different running speeds – 10Mbps, 100Mbps in the same device and automatically distin- guishes the speed of incoming connection. This section describes the hardware features of POE-151. Before connecting any network device to the POE-151, rea...

Page 7 - Supply equipment

- 7 - 2.2 POE-151, the Injector installation 1. Connect a standard network cable from Switch/workstation to “Ethernet” port of POE-151. 2. Connect the long cable that will be used to connect to the remote device to the port “Ethernet + DC” . The screen in Figure 1 appears. 3. Connect the AC adapter ...

Page 8 - Figure 4: Connection to IEEE 802.3af device; dicator of POE-151 will not be steady on.

- 8 - Figure 3: Connection architecture over POE-151/151S Notice: 1. According to IEEE 802.3af standard, the POE-151 will not inject power to the cable if not connecting to IEEE 802.3af devices. 2. Please ensure the output voltage is correct before applying power to remote device. 2.4 Connect with I...

Page 9 - The PoE LED is not lit; Can the POE-151 work with Gigabit Ethernet device?

- 9 - 3.TROUBLESHOOTING This chapter contains information to help you solve problems. If the Switch is not functioning properly, make sure the Ethernet Switch was set up according to instructions in this manual. The PoE LED is not lit Solution: Check the cable connection between POE-151 and IEEE 802...

Page 10 - APPENDIX A NETWORKING CONNECTION; RJ-45 Connector pin assignment

- 10 - APPENDIX A NETWORKING CONNECTION A.1 Switch‘s RJ-45 Pin Assignments RJ-45 Connector pin assignment Contact MDI Media Dependant In- terface MDI-X Media Dependant In- terface -Cross 1 TX + (transmit) Rx + (receive) 2 TX - (transmit) Rx - (receive) 3 Rx + (receive) TX + (transmit) 4, 5 DC curren...