Philips BT50B/00 - Manuals - manualsarea.com

Page 3 - Contents

1 EN Contents 1 Important 2 2 Your portable speaker 3 Introduction 3 What's in the box 3 Over view of the speaker 3 3 Get started 4 Charge the built-in batter y 4 Turn on/off 4 4 Play from Bluetooth devices 5 Connect a device 5 Disconnect a device 5 Reconnect a device 6 5 Play from external devices ...

Page 4 - Important

2 EN 1 Important Warning • Never remove the casing of this product. • Never lubricate any par t of this product. • Never place this product on other electrical equipment. • Keep this product away from direct sunlight, naked flames or heat. • Read these instructions. • Heed all warnings. • Follow all...

Page 5 - Introduction; Overview of the speaker

3 EN 2 Your portable speaker Congratulations on your purchase, and welcome to Philips! To fully benefit from the suppor t that Philips offers, register your product at www.philips.com/welcome. Introduction With this speaker, you can enjoy audio from Bluetooth-enabled devices or other external device...

Page 6 - Get started; Charge the built-in battery; Switch to standby mode

4 EN 3 Get started Always follow the instructions in this chapter in sequence. Charge the built-in battery The speaker is powered by a built-in rechargeable batter y. Note • Before use, fully charge the built-in batter y. • The micro USB socket is for charging only. • It takes you approximately two ...

Page 7 - Connect a device; Disconnect a device

5 EN 4 Play from Bluetooth devices With this speaker, you can listen to audio from Bluetooth-enabled devices. Note • The speaker can memorize a maximum of four paired devices. The fifth paired device will replace the first one. • Any obstacle between this speaker and a Bluetooth device can reduce th...

Page 8 - Reconnect a device

6 EN Reconnect a device When you turn on the speaker, it will reconnect the last connected device automatically; If not, select [Philips BT50] or [Philips BT25] on your Bluetooth device to star t connection.

Page 10 - General information

8 EN 6 Product information Note • Product information is subject to change without prior notice. Amplifier Rated Output Power 2W RMS Frequency Response 100 -16000 Hz, ±3dB Signal to Noise Ratio > 70 dBA Audio-in Input 300 mV (typical) – 1600 mV (Max.) RMS Speaker Speaker Impedance 4 ohm Speaker D...

Page 11 - Troubleshooting; General

9 EN 7 Troubleshooting Warning • Never remove the casing of this device. To keep the warranty valid, never tr y to repair the system yourself. If you encounter problems when using this device, check the following points before requesting ser vice. If the problem remains unsolved, go to the Philips W...

Page 12 - Notice; Compliance; Trademark notice

10 EN 8 Notice Any changes or modifications made to this device that are not expressly approved by Gibson Innovations may void the user’s authority to operate the equipment. Compliance Hereby, Gibson Innovations declares that this product is in compliance with the essential requirements and other re...