Paradyne ENE2020-P - Manuals

Page 3 - Product Documentation; Package Contents

3 8. This Agreement and the license granted under this Agreement shall be terminated in the event of breach by the Licensee of any provisions of this Agreement. 9. Upon such termination, the Licensee shall refrain from any further use of the Software and destroy the original and all copies of the So...

Page 5 - Configuring the E1 Ports; Table 1. Configuration Switch Settings

5 Configuring the E1 Ports Configuration Switches for both E1 Port 1 and E1 Port 2 are numbered from left to right, 1–8. Table 1. Configuration Switch Settings ENE2020-P Provider Configuration Switches ENE2020-S Subscriber Configuration Switches Switch Port 1 Port 2 Port 1 Port 2 1 Speed Speed Not u...

Page 7 - Line Code; Timing

7 Line Code Switch 4 sets the Line Code for Ports 1 and 2 on both the ENE2020-P and the ENE2020-S. Switch 4 controls the line code of both E1 ports (Port 1 and Port 2); line code for the two ports cannot be configured independently. Line code is the E1 mode of transmission. The two line code options...

Page 8 - Connecting the E1 Lines; Loop Bonded Connection; Procedure

8 Connecting the E1 Lines The primary feature of the ENE2020 is loop bonding capability, although both the provider and subscriber units are able to function with a single E1 connection as well. Loop Bonded Connection Using two E1 lines for one network connection (loop bonding) will net twice the sp...

Page 9 - Connecting the Ethernet Line

9 Connecting the Ethernet Line The 10/100BaseT Ethernet Port auto-negotiates speed and duplex mode in accordance with the remote equipment to which it is connected; Ethernet speed and duplex mode configurations cannot be configured on the ENE2020. For the best connection results, the remote device (...

Page 10 - LED Indicators; LED

10 LED Indicators This document describes units manufactured after 13 January 2005. See the prior version of this document for information about units manufactured on or before that date. Whenever both ENE2020 E1 connections have lost link or have presented an E1 Alarm, the Ethernet link will automa...

Page 12 - RJ45 Pin Assignments; E1 RJ45 Pin Assignments

12 RJ45 Pin Assignments E1 RJ45 Pin Assignments If you are using a shielded E1 cable for your network connection, it must be grounded through pins 3, 6, 7 and 8. Ethernet RJ45 Pin Assignments Table 7. E1 RJ45 Pin Assignments Pin Function Pin 1 Rx Ring Pin 2 Rx Tip Pin 3 not used Pin 4 Tx Ring Pin 5 ...

Page 13 - EMI Notices; United States – EMI Notice:

13 EMI Notices United States – EMI Notice: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in ...

Page 14 - Important Safety Instructions

14 Important Safety Instructions 1. Read and follow all warning notices and instructions marked on the product or included in the manual. 2. Do not allow anything to rest on the power cord and do not locate the product where persons will walk on the power cord. 3. Do not attempt to service this prod...