Paradyne 8300 - Manuals - manualsarea.com

Page 3 - Installing the Power Cord; Hotwire 8300 Endpoint Back Panel; Procedure; Hotwire 8300 Endpoint Front Panel

3 Installing the Power Cord The POWER port on the unit is a standard, grounded, three-prong connector. The unit has no power switch. Figure 1. Hotwire 8300 Endpoint Back Panel Procedure 1. Insert the power cord’s receptacle into the POWER jack. 2. Plug the other end of the power cord into a grounded...

Page 4 - Front Panel LEDs and Switches; Indicator Description

4 Front Panel LEDs and Switches The front panel’s LED status indicators are described below: The user-activated input control buttons are described below: Indicator Description MODE Normally, this indicator lights green . The indicator lights amber while configuration is being set by the front panel...

Page 5 - Connecting the Supervisory Port

5 Connecting the Supervisory Port The SUPERVISORY port is a DB9 female DCE connector configured for 8 bits, no parity, and 1 stop bit. Bit rates are configured through the Web server interface. The initial default rate of the Supervisory port is 19200 bps. On power-up, the Supervisory port sends out...

Page 6 - Connecting the Ethernet Port; Connecting the Serial Port

6 Connecting the Ethernet Port The unit provides a single Ethernet interface port for IP Gateway, SNMP, and Web browser access. This interface is an eight-pin modular jack that complies with standard twisted-pair, 10/100BaseT requirements. Procedure 1. Insert one 8-pin connector of your Ethernet cab...

Page 7 - Connecting the CBR Port; Connecting the Network Port

7 Connecting the CBR Port The CBR (Constant Bit Rate) port is an RJ48C, eight-pin modular jack that is software-selectable for T1 or E1. As a T1 port, it terminates as 100 ohms, and as an E1 port at 120 ohms. This port is used to transport TDM traffic using a T1/E1 framer to provide ATM adaptation L...

Page 8 - Web Interface; Setting the Ethernet Port Address

8 Web Interface If you will use the Ethernet port for the web interface, you must set the IP address of the port, or use the default address of 192.168.6.1. The IP address of the 8300 Endpoint must be on the same subnet as the PC accessing the web interface. Setting the Ethernet Port Address To set ...

Page 9 - Accessing the Web Interface

9 Accessing the Web Interface To access the web interface: Procedure 1. Start your web browser. Microsoft Internet Explorer version 5.0 or higher is recommended. 2. Type the IP address of the 8300 Endpoint’s Ethernet port into the Address field of the browser and press Enter. The Unit Screen appears...

Page 11 - Notices to Users of the Canadian Telephone Network; CE Marking

11 The Telephone Company may make changes in its facilities, equipment, operations or procedures that could affect the operation of the equipment. If this happens, the Telephone Company will provide advance notice in order for you to make necessary modifications to maintain uninterrupted service. If...

Page 13 - Supplier’s Declaration of Conformity

13 10. This unit is provided with a replaceable lithium battery. Replace the battery only with the same type recommended by the manufacturer. Discard used batteries according to the manufacturer’s instructions. Supplier’s Declaration of Conformity Place of Issue: Paradyne Corporation 8545 126 th Ave...

Page 14 - Document Feedback; Trademarks

14 Document Feedback We welcome your comments and suggestions about this document. Please mail them to Technical Publications, Paradyne Corporation, 8545 126th Ave. N., Largo, FL 33773, or send e-mail to [email protected] . Include the number and title of this document in your correspondence. Ple...