Palsonic 3425G - Manuals

1. :Earphone Jack 2. MENU button: To enter into menu operation.3. AV/TV button: Video input select.4. VOL- button: volume down adjust; menu item adjust.5. VOL+ button: volume up adjust; menu item adjust.6. CH- button: channel down select; menu item select.7. CH+ button: channel up select; menu item ...

Back Please do not use the front and rear input terminals at the same time 5 IMPORTANT notes on the AV input terminals !

6 Notes: In most cases, the function of buttons are equal to the CH+/- buttons, and the function of buttons areequal to the VOL+/- buttons; but in TELETEXT operation, the , , , buttons only serve as teletext control keys. Identification of Controls (continued) Introduction Remote Controller / !

! Install two "AAA" batteriesmatching the +/- polaritiesof the battery to the +/- marks inside the batterycompartment. Replace the battery cover. Notes: The battery life should be about one year under normaluse. Do not try to recharge batteries not intended to berecharged.Use only the size a...

INSTALL the unit in a room where direct light will not fall upon the screen. Total darkness or a reflection onthe picture screen may cause eyestrain. Soft and indirect lighting is recommended for comfortable viewing. Antenna installation Optimum reception of colour requires a good signal and will ge...

Connect to video and audio equipment This TV set provides AV input terminals for your convenient connection to VTR, DVD or videocamera to enjoy the high quality picture.Please refer to the owner's manual of the equipment to be connected as well. Important notes on the AV input terminalsPlease do not...

Operations Select Input Signal Select input signal ! 4 3 2 1 Press AV/TV button on the TV set or AV buttonon the remote control. When the set is in TV mode, press this button and the set goesto AV mode. Now you could watch video program from AVinput terminals.If you want to switch to TV press AV but...

3 2 1 2 4 3 2 1 5 1. Press CH+ or CH- buttons to select item. Press VOL+ or VOL- buttons to adjust item. Press MENU button four times to call Programmenu page. Auto Search Press MENU button repeatedly to enter intoProgram menu page. Press CH+ or CH- button repeatedly to selectAuto Search item. Press...

4 3 2 1 5 Press MENU button repeatedly to enter intoProgram menu page. Press CH+ or CH- button repeatedly to selectChannel Number item. Press VOL+ or VOL- button to set a channelnumber (for example, channel 99). Press CH+ or CH- buttonrepeatedly to selectChannel Skip. Press VOL+ or VOL-button to set...

3 2 1 Setting Colour System If the picture colour is abnormal, maybe the colour system setting iswrong. Then you can select a proper colour system as follows. Press MENU button repeatedly to enter intoProgram menu page. Press VOL+or VOL-button to select a propercolour system. Setting Sound System If...

! 168 3 2 8 Press 0-9 directchannel selector. 1 Operations Channel Selection Use Direct Channel Selector (0-9 and -/-- buttons) To select one-digit channel: Press -/-- buttonrepeatedly todisplay "-". To select two-digit channel: Press -/-- buttonrepeatedly todisplay "--". To select t...

100 Item Standard Soft Brightness Brightness 4 Contrast weaker Color paler deeper Sharpness darker lighter softer sharper Picture mode Vivid Adjusting Picture Contrast Color 80 50 50 50 50 Press MENU button, the Picture menu pagedisplays. Sharpness Tint Press CH+ or CH- button to select item. 50 50 ...

Use MUTE button. ! Use VOL+ or VOL- button. Press VOL+ button, the volume increases;Press VOL- button, the volume decreases.The minimum volume is 0 and the maximum volume is 100. If you want to mute the sound,press button on the remote. To resume the sound, press thisbutton again. Notes: You can als...

2 1 Clock SleepTimerTime OffTime On 00:1000:30 - - 2 3 1 ! 2 3 Press MENU button repeatedly to enter intoClock menu page. Press VOL+ or VOL- button to set sleep time. The sleep time switches among Off, 10, 20, 30, 40, 50 and 60minutes. When the time is up the set auto goes to STANDBY. You can also u...

3 2 1 1 2 3 Setting Time On Press MENU button repeatedly to enter intoClock menu page. Press CH- button repeatedly to select Time Onitem. Press VOL+ or VOL- button to set On time. After you finish setting Time On item, press the STANDBYbutton on the remote control. Then the TV set auto turns onwhen ...

B. Before the icon disappear, continue to press 4, 3, 2, 1 on the remote control. C. Press VOL+ or VOL- button to switch between Off and On. 2 1 Press CAL (calendar) button onthe remote controller to displaycalendar.You can adjust month by VOL+/-buttons and year by CH+/- buttons. 20 Selecting OSD la...

Child Lock 1 2 4 3 Firstly, please refer to the Hotel mode on the previous page to enter into the Control menupage. Press CH - button to select Child Lock item and then press VOL+ or VOL- button toswitch between On or Off. When the Child Lock is set to On, all programs will be shielded andthe screen...

Teletext Operations Switch on/off/Description of TELETEXT/Button Introduction Teletext is an optional function, therefore only a set with the teletext system can receive the teletextbroadcast. Switching Teletext on/off Press the TEXT button to switch on teletext. The initial page orlast selected pag...

Remote controller doesnot work Unevenness in colour insome parts of the screen The screen is black Before calling service personnel, please check the following chart for a possible cause to the troubleyou are experiencing. Even if the picture or the sound is normal, changesin room temperature someti...

! TV system & channel range Power Supply: Power Consumption: Dimensions(mm): Weight(kg): CRT: AC 240V, 50Hz 60W 440(W) x 330(H) x 387(D) 12 34cm System PAL-B/G VHF 2-12 UHF 21-69 CATV X~Z+2,S1~S41 TELETEXT Color System: Sound output: Accessories: WST FLOF TELETEXT PAL-B/G NTSC playback 1.5W x 2 ...

PALSONIC CORPORATION PTY LTD 1 JOYNTON AVENUE WATERLOO NSW 2017 AUSTRALIA TEL:(02)9313 7111 FAX:(02)9313 7555 www.palsonic.com.au PALSONIC CUSTOMER SERVICE TELEPHONE AUSTRALIA: 1300 657 888 604-J14173-00