Omega OF916FX - Manuals - manualsarea.com

Page 4 - DO NOT USE THIS APPLIANCE AS A SPACE HEATER.

WARNINGS: 1. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or kno wledge, unless they have been given supervision or instruction concerning the use of the appliance by a person re sponsible for ...

Page 5 - LOCAL AUTHORITY REQUIREMENTS; C or higher. Do not install the appliance near; Clearance above and around domestic cookers; Extract from AS5601; REQUIREM ENTS

LOCAL AUTHORITY REQUIREMENTS Before installation, unpack all parts from carton, remov e all internal packaging and check for damage. Check Gas Type and specifications plate placed on the rear of the unit, alternatively there is a second label supplied – this should be fixed in an accessible posi...

Page 6 - IMPORTANT INFORMATION FOR INSTALLIN G THE APPLIANCE; The dimensions of the appliance are listed below:; Room Ventilation

IMPORTANT INFORMATION FOR INSTALLIN G THE APPLIANCE The cooker can be installed separately, a s a fre estanding unit, or betw een kitchen u nits or between a kitchen unit and the wall. This appliance is not connected to devices which e xh a u s t combustion products. Special attention must b...

Page 7 - APPLIANCE GAS CONNECTION; This appliance must be installed by an authorised person .; Gas inlet positions with different leg heights – mm; From RH rear side: 35 mm; Gas Regulator; Using a flexible c o n n e c t i o n

APPLIANCE GAS CONNECTION IMPORTANT: This appliance must be installed by an authorised person . WARNING: DO NOT MODIFY THIS APPL IANCE If the appliance cannot be adjusted to perform correctly, contact the service department. This appliance utilises a threaded 1/2" gas male fitting. To conn...

Page 9 - S U P P O R T L E G S; Fig. 06

S U P P O R T L E G S The cookers are supplied with four transit supports (one for each corner). Four support legs are supplied separately and are fitte d on location to the four corners of the lower support frame. Each support leg is pushed over the relevant transit support until flush with the sup...

Page 11 - CONVERSION T O DIFFERENT TYPES OF GAS; If converting to Natural Gas, fit gas regulator.; Fi g. 10 (representation only)

CONVERSION T O DIFFERENT TYPES OF GAS Before perfo rming any maintenance op eratio n, di sconnect the appliance from the ga s supply and electrici ty netw o rk. REPLACING THE NOZZLES TO OPERATE WITH ANOTHER TYPE OF GAS When converting to LPG remove the NG gas regulator (if fitted) and fit LPG test...

Page 12 - APPLIANCE ELECTRICAL CONNECTION

APPLIANCE ELECTRICAL CONNECTION The electric c o n n e c t i o n must comply with the current legal standards and regulations. Before making the connection, check that:  The system electrical rating and the current outlet are adequate for the maximum power output of the appliance (see the label app...

Page 13 - Three-Phase electric connection

Three-Phase electric connection The cookers that can also be connected to three-pha se systems normally are factory built for the single-phase 230V connection and are supplied with a power cord. Base d on the connection system used, install the power cord type indicated in table No.3. To use the sel...

Page 14 - APPLIA NCE U S E A N D MAINTENANCE; For cookers resting on base; Please maintain your appliance regularly

APPLIA NCE U S E A N D MAINTENANCE ATTENTION: Important Warnings.  For cookers resting on base ATTENTION: if the cooker rest on a base, take the measures necessary to prevent the cooker from sliding along the support base.  For cookers with electric ovens ATTENTION: The unit becomes hot during use...

Page 15 - CONTROL PANEL DESCRIPTION

Greasing th e val ve s: If it becomes difficult to operate the valve, it should be greased immediately by following the instructions listed below: 1) Disassemble the valve body by loosening the two screws located on the body of the valve (Fig.17) Fig. 17 2) Extract and clean the seal cone and its ho...

Page 16 - USING BU RNERS ON COOKTOP; Tips for usin g burners c o r r e c t l y :; USING THE OVEN T HERMOSTAT CONTROL KNOB

USING BU RNERS ON COOKTOP A diagram is etched on the control panel above eac h knob which indicates which burner corresponds to that knob.  Manual li ghting (it is alw ays possible even w hen the power is cut off): Turn the control knob that corresponds to the burner selected anticlockwise, setting...

Page 17 - top of the oven cavity.

USING THE OVEN FU NCTION CONTROL KNOB (Fig. 20) The oven function knob is used to control the electric fan and the oven elements in set combinations in conjunction with the ti mer and thermostat. The electric oven is heated by 4 elements: a) Upper element (1200W) and grill element (1500W) combined a...

Page 19 - USING T HE ELECTRIC OVEN

USING T HE ELECTRIC OVEN When using the oven for the first time it should be operated for a maximum of 30 minutes at a temperature of about 250°C to eliminate any odours generated by the inter nal insulation. During normal oven use, select the desired cooking temperature using the thermostat knob an...

Page 22 - TROUBLESHOOTING; Hobs ignite but don’t stay on; DISPOSAL INFORMATION

TROUBLESHOOTING If you have a problem with your appliance, check the following before contacting service. PROBLEM SOLUTION Oven or hob not working Check the electricity is turned on. Check your fuses. If the fuse continues to blow, call Omega service. Check the circuit breaker. Ensure correct knob...