Nostalgia KRS-2150 - Manuals

Page 2 - SERIES; KegoratorTM; Instruction Manual

Page 4 - ENGLISH; CONTENTS; Your safety and the safety of others are very important.

ENGLISH 2 CONTENTS IMPORTANT PRECAUTIONS . . . . . . . . . . . . . . . . . 3 IMPORTANT SAFEGUARDS . . . . . . . . . . . . . . . . . . 3 INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . 5 PARTS & ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . 6 WASHERS . . . . . . . . . . . . . ...

Page 5 - IMPORTANT PRECAUTIONS; IMPORTANT SAFEGUARDS

ENGLISH 3 IMPORTANT PRECAUTIONS NEVER use an abrasive sponge, cloth or scouring pad on this appliance. 1. NEVER leave appliance unattended while in use. 2. Unplug unit from outlet when not in use and during cleaning. 3. DO NOT operate this appliance with a damaged cord or 4. plug, or if the applianc...

Page 7 - INTRODUCTION

ENGLISH 5 INTRODUCTION To ensure that your KEGORATOR™ works to the maximum efficiency for which it was designed, keep it in a location where there is proper air circulation and electrical outlets. Choose a location where the KEGORATOR™ will be away from heat and will not be exposed to direct sunligh...

Page 8 - WASHERS

ENGLISH 6 PARTS & ASSEMBLY Read assembly instructions carefully before installing the KEGORATOR™ . If still unsure whether the KEGORATOR™ has been properly installed after assembly is complete, it is recommended that you contact a qualified installer. Allow the KEGORATOR™ to stand in an upright ...

Page 10 - REGULATOR

ENGLISH 8 REGULATOR The Double Regulator works the CO2 Tank and measures PSI (pounds per square inch), as well as the volume of the CO2 gas in the Cylinder. Set Output Pressure Gauge between 8-12 PSI for a nice, frothy head. Close the Shut Off Valve on the Double Regulator, and 1. open the CO2 Tank ...

Page 11 - INSTALLING THE CASTERS; INSTALLING THE GUARDRAIL

ENGLISH 9 INSTALLING THE CASTERS Follow the steps below to install the Casters. Empty the inside of the cabinet 1. completely and lay the KEGORATOR™ down on it’s side. We recommend that you place a piece of cardboard or cloth underneath the cabinet to prevent dents or scratches. Place washers over C...

Page 12 - CO2 & TAP TOWER INSTALLATION

ENGLISH 10 CO2 & TAP TOWER INSTALLATION You must read and understand the steps below for the CO2 assembly before installation. When you purchase the first keg of beer, you must also have your CO2 cylinder filled at your local supplier. CO2 tanks can be refilled at locations such as welding suppl...

Page 15 - TAPPING THE BEER KEG

ENGLISH 13 TAPPING THE BEER KEG (SINGLE VALVE-TYPE KEG) Follow these steps below to tap the beer keg. Make sure the black pull handle of the coupler is in the closed (up) 1. position before installing it on the keg (Fig. 1). Insert the coupler into the locking neck of the beer keg and turn clockwise...

Page 16 - HELPFUL TIPS

ENGLISH 14 HELPFUL TIPS It is recommended that you flush the hoses with water prior to • first use to remove any dust and debris from shipping.Only open the • CO2 Tank ¼ turn to begin with and then use the regulator to adjust to desired pour. If it is not enough, continue to open the CO2 Tank by ¼ t...