NorthStar M157594I - Manuals

Installation Instructions 5 Installing a Battery Warning: Sulfuric acid is a corrosive poison. Avoid contact with skin, eyes or clothing. Always wear safety glasses. Always wear safety glasses when working on or near the battery. The engine will not run and the burner will not fire without first ins...

Installation Instructions 6 Venting DANGER: Do not run machine indoors or in an enclosed area without adequate ventilation, or in areas where flammable vapors, (gasoline, solvents, etc.) may be present. Do not vent exhaust gases into a wall, a ceiling, or a concealed place. CAUTION: All venting must...

Operating Instructions 7 Read and understand the entire manual before operating the pressure washer. Follow these instructions every time you use the pressure washer. I.) Pre-Operation Read entire manual, especially the important safety instructions. 1.) Check hoses, fittings, wand, trigger gun and ...

Operating Instructions 8 V.) Turn Water Supply ON (city water tap only) Make sure the hose is not “kinked”. A kinked hose will provide insufficient water supply to the pump and will reduce its life. Make sure the hose remains unkinked after moving the pressure washer. VI.) Attach Nozzle Color of Noz...

Operating Instructions 9 X.) For Hot Water If HOT water is desired, make sure there is fuel in the fuel tank, turn the heat switch ON, and adjust the thermostat to the desired temperature. The burner will fire when the trigger is squeezed. You may need to initially adjust your burner for peak perfor...

Maintenance Instructions 10 WARNING: Unauthorized machine modification or use of non-approved replacement parts may cause personal injury and/or property damage and will void the manufacturer warranty . See Engine manual for engine maintenance . Maintenance Mode Before performing any maintenance on ...

Long Term / Winter Storage 11 During cold weather, store the pressure washer indoors and move it outdoors before starting the engine. Long Term Storage and Freeze Protection 1.) Attach a feed tank or bucket to the water inlet (feed tank). See Installation section for Attaching a Water Feed Tank inst...

Troubleshooting Guide 12 Engine Will Not Start Causes Solutions Low Oil Shutdown Fill engine with the adequate amount of oil. Cold Engine Choke engine to start. No Fuel Add gas to engine, make sure fuel shutoff valve is open. Dead Battery Recharge/Replace battery. Spark plug wire not attached Attach...

Trailer Assembly Instructions (157595 only) 17 1.) Remove the top and four sides of the steel crate. 2.) Remove a-frame from trailer frame. (keep fasteners for step 7) 3.) Slide a-frame into holders under trailer frame (built into the front posts). 4.) Install jack onto a-frame with 3/8x1” bolts, Cl...