Northern Industrial 142264 - Manuals

Page 2 - INTENDED USE; Description; GENERAL SAFETY RULES; Read and understand all instructions.; SAVE THESE INSTRUCTIONS; Keep work area clean,

Page of 13 2 Thank you very much for choosing a NORTHERN TOOL + EQUIPMENT CO., INC. Product! For future reference, please complete the owner’s record below: Model: _______________ Purchase Date: _______________ Save the receipt, warranty and these instructions. It is important that you read the enti...

Page 3 - Be aware of all power lines, electrical circuits,; ELECTRICAL SAFETY

Page of 13 3 • Do not use your tool where there is a risk of causing a fire or an explosion; e.g. in the presence of flammable liquids, gasses, or dust. Power tools create sparks, which may ignite the dust or fumes. • Keep children and bystanders away while operating a power tool. Distractions can c...

Page 4 - PERSONAL SAFETY

Page of 13 4 • Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. • Do not let your fingers touch the terminals of plug when installing to or removing from the outlet. • Ground fault circuit interrupters. If work area is not equ...

Page 5 - ASSEMBLY

Page of 13 5 • Do not exceed the maximum lift capacity. The application, size and type of load, the attachments to be used and the period of use must be taken into account . • Do not stand under hoisted loads . • If pushing the lift button continually does not have any affect , do not continue. This...

Page 7 - INSTALLATION; positioning clamp (C) for being aligned and properly tightened.; Special frame; Newton

Page of 13 7 INSTALLATION Notes: A) Before starting the electric hoist, first check two hinge type fixing clamps and positioning clamp (C) for being aligned and properly tightened. B) For smooth winding of rope, the roll axis must be kept level: Loose lock nuts, adjust nut (A), locate precise positi...

Page 8 - INSTALLATION IN SPECIAL FRAME

Page 9 - OPERATION

Page of 13 9 OPERATION 1. Before making the connection to the electric control panel, check that the line voltage corresponds to that shown on the motor plate. In case of three-phase motor, check also the row or triangle connection of each phase. 2. The user must provide the electrical connection to...

Page 10 - UNPACKING; Parts List; MAINTENANCE; Maintain your tools.

Page of 13 10 10. Be sure to check the condition of the cable every three months, and replace it if the wires are damaged, twisted, frayed or broken. Consequently, if the cable needs to be replaced, it can be secured using U-bolt clamps suitably proportioned to the diameter of the cable itself, as i...

Page 11 - DIAGRAM & PARTS LIST

Page 13 - WARNING

Page of 13 13 WARNING Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: • lead from lead-based paints, ...