Newcon Optik DN 463 - Manuals

5 2. DELIVERY SET DN463 Carrying case Pressure switch IR Illuminator User Manual Warranty card

7 4. OPERATING INSTRUCTIONS DN463/ night vision riflescope is intended for observation and hunting at dusk or during night time hours. When operated in conditions without artificial sources of light, it is a passive device. However, in environments of absolute darkness the built-in IR illuminator pr...

9 soft cotton tissue and alcohol or a cleaning solution approved for use with multicoated lenses. Do not pour the solution directly onto the lens!  The scope can be used in operating temperatures, ranging from -30°C to +40°C. However, if it has been brought indoors from cold temperatures, do not tu...

10 7. OPERATING INSTRUCTIONS  Install the batteries according to the directions in the section entitled “BATTERY INSTALLATION”.  Enter a dark environment.  Remove the objective lens cap by sliding it up on top of the objective lens (2) .  Turn on the unit by turning the selector switch (3) to th...

13  Using live ammunition, take 3 or 4 control shots, continually aiming at the same hit point on the target (you may also use a laser bore sighter and align the laser point to the center of the cross hairs).  Examine the target and determine if the aiming point coincides with point of impact, if ...

16  When making windage/elevation adjustments please note that one click of the riflescope's adjustment equals to: For the model DN463: 0.4235 MOA; 0.4435”/100 yds; 1.232cm/100m 1 mil (millirad) equals 3.6 inches at 100 yards or 36 inches at 1,000 yards, or 10 centimeters at 100 meters or 1 meter a...

17 10. TECHNICAL INSPECTION It is recommended to inspect the riflescope before every use. Make sure to check for the following:  Visually inspect the unit is free from any physical damage; cracks, dents or signs of corrosion disqualify it from proper use.  Check the sturdiness and proper fit of th...

19 13. USE OF THE PRESSURE SWITCH MODULE DN463/ is supplied with a remote-control console. The console has three buttons: - “ON” button turns on/off the riflescope (fixed when pressed). - “IR” button turns on/off the built-in IR Illuminator (fixed when pressed). - “Quick start” button - quick start-...

20 15. TROUBLE SHOOTING Listed below are some potential problems that may occur when using DN463. Carry out the recommended checks and troubleshooting steps in the order listed. Please note that the table does not list all of the possible problems. If the problem experienced with the scope is not li...

23 16. WARRANTY NEWCON warrants this product against defects in material and workmanship for one year from the date of the original purchase, but no more than 12 months from the date of manufacturing. Longer warranty is available, subject to the terms of the specific sales contract. Should your Newc...

26 18. ACCEPTANCE CERTIFICATE Image intensifier tube serial number: ____________________ Minimum Measured Resolution, lines/mm 57 Photocathode sensitivity, integral,  A/lm 600 Light amplification 35,000