Page 2 - WLT LAVALIER/LAPEL OR HEADWORN MICROPHONE; CONTENTS; available in VHF dual receiver wireless systems.; INTRODUCTION
2 CONTENTS .................................................................................................... 2 INTRODUCTION ............................................................................................. 2 USING THIS MANUAL ..............................................................
Page 3 - ENCORE I RECEIVER; • OFF/STANDBY/ON switch allows convenient audio muting with the; SYSTEM FEATURES
• Available on selected frequencies in the VHF high band (171‑216 MHz) for interference‑free, long‑range performance • Proprietary companding circuitry for an industry-best 120dB Dynamic Range, and the clearest, most natural sound available • Operating Range: Up to 250 feet typical (depending on sit...
Page 4 - Rackmounting the Receiver; both Encore receivers, join the two receivers with the; Powering the Receiver; Press the; RF LEVEL LED; display extinguishes, the
1. Rackmounting the Receiver There are two options available for rackmounting the Encore I receiver: singly or side‑by‑side with another Encore Series receiver. a. Single mounting: Remove the receiver SIDE MOUNT CLIP (1) from each side of the receiver (as shown) and slide in the optional ERM-12 RACK...
Page 5 - the mixer is turned OFF before making connection to the receiver.); Instrument Connection; (Note: Make sure the phantom power on your mixing board is turned off
5 5. Connecting the Audio Output The Encore I receiver provides both a fixed mic level BALANCED AUDIO OUTPUT XLR (14) and an adjustable line level UNBALANCED AUDIO OUTPUT 1/4” JACK (13) . The level from the UNBALANCED OUTPUT is controlled by the rear panel VOLUME CONTROL (6) . (Note: As when making ...
Page 7 - WHT HANDHELD MICROPHONE TRANSMITTER
1. Unscrew the BATTERY COMPARTMENT COVER (17) and remove, exposing the BATTERY HOLDER (18) . Insert a fresh 9V ALKALINE BATTERY (19) , observing the correct polarity as marked, and screw the cover back on to the microphone. Make sure the cover is screwed on completely. A fresh alkaline battery can l...
Page 9 - HEADWORN; will give a single quick flash, indicating; AF LEVEL LED; position the microphone farther from the source or adjust the; AUDIO INPUT LEVEL; until the red LED indicator flickers only on the loudest inputs.; WLT LAVALIER/LAPEL OR HEADWORN
1. Snap open the BATTERY COMPARTMENT (22) and insert a fresh 9V BATTERY (23) , observing the correct polarity. Close the compartment. 2. The WLT is provided with a 3.5 mm LOCKING JACK (24) for connecting the microphone. Plug in either the LAVALIER/LAPEL (25) or the HEADWORN MICROPHONE (26) , as supp...
Page 11 - ) will give a single quick flash, indicating; INPUT LEVEL CONTROL (34; without noticeable distortion on the high level peaks).; INPUT LEVEL; the supplied; WGT INSTRUMENT BODYPACK TRANSMITTER
11 1. Snap open the BATTERY COMPARTMENT (30 ) and insert a fresh 9V BATTERY (31) , observing the correct polarity. Close the compartment. The WGT is provided with a 3.5 mm LOCKING JACK (32 ) for connecting the INSTRUMENT CABLE (35 ). To secure the connection, turn the metal slip ring on the plug clo...
Page 13 - SPECIFICATIONS
13 ENCORE I OVERALL SYSTEM PERFORMANCE Frequency Response 25-20,000 Hz, +/-3dB Dynamic Range 120dB Total Harmonic Distortion < 0.3% RF Carrier Frequency Range 169‑216 MHz Frequency Stability +/- 0.005%, crystal controlled Modulation FM (F3E), +/-20KHz max. Operating Range Up to 250 ft. typical (d...
Page 14 - SERVICE INFORMATION; Do not attempt to service this unit yourself as
14 SERVICE INFORMATION In the U.S. If you are experiencing operational problems with your system, please refer to the Support page at www.nady.com for assistance. Should your wireless system require service, please contact the Nady Service Department at (510) 652‑2411 to obtain a Return Authorizatio...
Page 15 - This warranty is subject to the following conditions:; Nady will automatically void this warranty.; How To Obtain Service:; ONE-YEAR LIMITED WARRANTY
Nady Systems, Inc. warrants to the original consumer purchaser that the unit is free from any defects in material or workmanship for a period of one year from the date of original retail purchase. If any such defect is discovered within the warranty period, Nady Systems, Inc. will repair or replace ...