NAD T741 - Manuals - manualsarea.com

Page 3 - NOTES ON INSTALLATION.

GB 3 NOTES ON INSTALLATION. Your NAD T741 should be placed on a firm, level surface. Avoid placingthe unit in direct sunlight or near sources of heat and damp.Allow adequate ventilation. Do not place the unit on a soft surface like acarpet. Do not place it in an enclosed position such a bookcase or ...

Page 4 - ventilation openings.

GB 4 EXPLANATION OF GRAPHICAL SYMBOLS The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alertthe user to the presence of uninsulated “dangerous voltage” within the product’s enclosurethat may be of sufficient magnitude to constitute a risk of electric shock to...

Page 5 - Power Sources; as marked on the unit.; Polarization; pull the cord itself.; Extension cord; Clean the unit only as recommended in the Operating Instructions.

GB 5 ELECTRIC POWER 1 Power Sources - Connect this unit only to power sources specified in the Operating Instructions, and as marked on the unit. 2 Polarization - As a safety feature, some units are equipped with polarized AC power plugs which can only be inserted one way into a power outlet. If it ...

Page 7 - FIG. 3 REMOTE CONTROL

GB 7 FIG. 3 REMOTE CONTROL 1 2 6 8 11 22 25 10 13 23 26 4 14-1820 3 5 7 9 12 19 21 24 FIG. 4 FIG. 5 FIG. 6 T741 manual (GB) 22/10/01 3:56 pm Page 7

Page 9 - NOTES; • Never connect the T741’s speaker outputs and the speaker outputs; NOTE

GB 9 6. AUDIO PRE-OUTS / SUBWOOFER OUT AUDIO PRE-OUTS - The NAD T741 receiver has five power amplifiers built-in to power all the speakers connected to it (Left, Right, Center, LeftSurround, Right Surround). It is also possible to use the T741 as a pre-amplifier to drive external power amplifiers. T...

Page 10 - • Never loop the last unit back to the first NAD unit in the NAD-Link; • NAD components equipped with 12V input triggers are fully; REMOTE CONTROL; Press this button to switch the unit from operating to the

GB 10 10. NAD-LINK IN OUT The NAD-Link connector is used to pass commands from other units fittedwith NAD-Link connectors. This allows centralized control of a completesystem, and also allows some of the basic functions of other NADcomponents (such as a CD player) also equipped with NAD-Link to beco...

Page 11 - AND; button to scroll to a lower number Preset press the; Automatic tuning is available on both FM and AM.

GB 11 4. FM/AM The FM/AM button switches the tuner section from the AM band to theFM band and vice-versa. The Display Panel shows the frequency of thetuned station and which band is selected. The FM tuning is in 0.05 MHzincrements, AM tuning is in 9 kHz or 10kHz increments, depending onthe version (...

Page 12 - • In the VFL display “Speaker settings”, be sure to have selected and

GB 12 The control is also used to adjust various set-up settings and levels for theT741. In conjunction with the SETUP button (No. 17) the speakers sizeand delay can be adjusted; in conjunction with the Tone Control button(No. 18) the Bass and Treble levels can be adjusted. Refer also to sections“SE...

Page 13 - • Dolby Digital or DTS are only available as a Surround Mode if the; SET UP OPTIONS; TREB

GB 13 16. SURROUND MODE With the Surround Mode buttons the available surround sound modescan be selected. The selected Surround mode is permanently indicated inthe display Area. The Surround Mode buttons scroll through the availablesurround sound modes: With any of the Digital Inputs 1, 2 & 3 (p...

Page 14 - Any unused Presets will be skipped.

GB 14 STORING AND RECALLING PRESETS TO STORE A PRESET • Tune to the radio station you wish to enter into a Preset (refer to chapter “Front Panel Controls”; section 8). If the station istransmitting RDS information, the RDS indicator will light up andstation initials will be shown in the Display Pane...

Page 16 - To Adjust Speaker Settings -

GB 16 13. TUNE MODE / RETURN The TUNE MODE button functions the same as the button of the frontpanel of the T741, switching between the Tune Mode and the PresetMode. See complete description in the FRONT PANEL CONTROLS sectionabove. In DVD mode this button’s function is determined by the individual ...

Page 17 - The channel delay option is not available in DTS surround mode.; TO ADJUST DELAY SETTINGS; REAR

GB 17 Now rotate the VOLUME/SETUP knob until REAR LAR (current setting forthe SURROUND speakers) appears in the display window. Press the SETUP button again to change the size. Each press of the SET UP button willchange the setting for that speaker: REAR (Surround Speakers) can be set to LAR, SMA or...

Page 18 - ) on the Remote Control to help assess the loudness levels of each

GB 18 TIPS FOR SETTING DELAY Measure the distance from the listening position to the center speaker(dC) and to one of the front speakers (dFL or dFR). Subtract the centerchannel distance from the front L or R channel distance. For example, ifthe front speakers are 12 feet (3.7 m) from the listening ...

www.NADelectronics.com ©2001 NAD ELECTRONICS INTERNATIONAL All rights reserved. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International T741 Manual 10/01 Printed in Malaysia T741 manual (GB) 22/10/01 3:56 pm Pag...