NAD S70 - Manuals

NAD S70 – Manual in PDF format online.

Manuals:

Manual

Manual NAD S70

Summary

Page 2 - CONTENTS

CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17 Installing the battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17 Set-up of the S70 remote control . . . . . . . . . . . . . . . . . . . . ...

Page 8 - FIGURE 6

Page 9 - FIGURE 6a

Page 10 - FIGURE 6b

Page 11 - FIGURE 6c

Page 12 - FIGURE 6d

Page 13 - FIGURE 6e

Page 14 - FIGURE 7

Page 15 - FIGURE 8

Page 16 - FIGURE 9

Page 17 - itself from the S70’s casework.; SET-UP OF THE S70 REMOTE CONTROL; Component selection

17 INTRODUCTION Thank you for purchasing the NAD S70 System Remote Control. With the S70you can control all components of your NAD Silver Series system. The S70 caneasily be customised to suit your particular NAD Silver Series system and providesadditional functionality such as a clock, Sleep and on...

Page 18 - and return to Main Menu.; Set-up of the S70 remote control: S100 or S170 Preamp selection; to indicate it has been selected.; Activating and setting the clock; you will have to adjust the clock again next time you activate it.; Adjusting display contrast

Press any button (other than Volume Up/Down) to activate the display. In theMain menu, each category of Silver Series component is represented by its ownicon. Refer to figure No.2. To set up the S70 for your system:• From the Main Menu on the remote control, press the button next to where it indicat...

Page 19 - to return to Main Menu.; USING THE NAD S70 REMOTE CONTROL; Mute & Display back light

necessary to adjust contrast.• From the Main Menu, press the button next to "SYSTEM".• Press the button next to ">>" to increase contrast or "<<" to decrease contrast. • When the optimum contrast level has been set, press the button next to "EXIT" to retur...

Page 21 - SETTING AND ACTIVATING THE TIMER FUNCTION; the time adjustment buttons as described above.

NOTES: Make sure that the S70 is located well within range of all components, otherwise the Sleep Timer function will function erratically or not at all. The Sleep function is available only if Clock function has been selected (indicatedby tick-mark) in the System Set-up Menu. Refer to chapter "...

Page 22 - TROUBLESHOOTING GUIDE; Problem

22 TROUBLESHOOTING GUIDE Remote control worksintermittently or doesn’twork at all • Battery flat or snap-on connector incorrectlyattached • IR transmitter or receiver windows obstructed • IR receiver on components are in direct sun or verybright ambient light • Check or replace battery • Remove obst...

www.NADelectronics.com ©2001 NAD ELECTRONICS INTERNATIONAL All rights reserved. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International S70 Manual (S170 revision) 08/01 Printed in Hong Kong