MTD E2B5 - Manuals - manualsarea.com

Page 3 - SECTION 1: IMPORTANT SAFE OPERATION PRACTICES; Training; Operation

3 SECTION 1: IMPORTANT SAFE OPERATION PRACTICES WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual beforeattempting to operate this machine. F...

Page 4 - Maintenance & Storage; NOT LIFTING; DANGER

4 odorless and deadly gas. 6. Do not operate machine while under the influence of alcohol or drugs. 7. Muffler and engine become hot and can cause a burn. Do not touch. 8. Exercise extreme caution when operating on or crossing gravel surfaces. Stay alert for hidden hazards or traffic. 9. Exercise ca...

Page 5 - SECTION 2: ASSEMBLING YOUR SNOW THROWER; Unpacking From Carton; Before Assembly; Assembling the Discharge Chute

5 SECTION 2: ASSEMBLING YOUR SNOW THROWER NOTE: This Operator’s Manual covers several models. Snow thrower features vary by model . Not all features discussed in this manual are applicable to allsnow thrower models. Unpacking From Carton • Cut along corners of the carton and lay it down flat. Remove...

Page 6 - SECTION 3: KNOW YOUR SNOW THROWER

6 SECTION 3: KNOW YOUR SNOW THROWER Figure 3 Auger Control Handle Located on the upper handle, the auger control handle is used to engage and disengage the auger. The snow thrower is designed to propel by the rotation of the auger. Pull the auger control handle back against the upper handle to engag...

Page 7 - SECTION 4: OPERATING YOUR SNOW THROWER; Before Starting; Recoil Starter

7 SECTION 4: OPERATING YOUR SNOW THROWER Before Starting • The spark plug wire was disconnected for safety. Attach spark plug wire to spark plug before starting. Gas and Oil Fill-Up • Check oil and gasoline level and add if necessary. Follow related instructions in the separate engine manual packed ...

Page 8 - Operating Tips

8 To Stop Engine • To stop engine, turn ignition key counter-clockwise. Disconnect the spark plug wire from the spark plug to prevent accidental starting while equipment is unattended. To help prevent possible freeze-up of starter, proceed as follows: • Run engine for a few minutes before stopping t...

Page 9 - SECTION 5: MAKING ADJUSTMENTS; Shave Plate; Control Cable

9 SECTION 5: MAKING ADJUSTMENTS Shave Plate • To check the adjustment of the shave plate, place the unit on a level surface. See Figure 6. The wheels, shave plate and augers should all contact level surface. Note that if the shave plate is adjusted too high, snow may blow under the housing. If the s...

Page 10 - SECTION 6: MAINTAINING YOUR SNOW THROWER; Replacing Belt; Replacing Shave Plate

10 SECTION 6: MAINTAINING YOUR SNOW THROWER Replacing Belt • Remove the belt cover by removing five hex screws. See Figure 8. Figure 8 • Pull up on the idler pulley and slip the belt off the engine and auger pulley. See Figure 9. Figure 9 • Reassemble new belt. Reinstall the belt cover. Replacing Sh...

Page 11 - SECTION 8: TROUBLESHOOTING GUIDE

11 SECTION 8: TROUBLESHOOTING GUIDE For repairs beyond the minor adjustments listed above, contact your nearest authorized service representative or call for the Customer Support Center. Refer to the engine manual for more engine related information. For US Customers: 1- (330) 220-4MTD (4683) or 1- ...