MTD 450 Series - Manuals

5 Safe Operation Practices WARNING This symbol points out important safety in-structions which, if not followed, could endanger the personal safety and /or property of yourself and others. Read and follow all instructions in this manual before attempting to oper-ate this machine. Failure to comply w...

3 Assembling Your Tiller WARNING Do not put your fingers under the belt cover.Maximum tire pressure under any circumstances is 30 p.s.i. Equal tire pressure should be maintained on both tires. Figure 3-3 Figure 3-4 Figure 3-5 Attaching Control Rod • Make sure the handle assembly is in the highest po...

8 Gear Selection Handle The gear selection handle is located in the center of the handle on the tiller. It is used to select NEUTRAL, REVERSE, or one of the FORWARD mode. Pull or push the handle so that the indicator on top of shift cover points to the operating mode desired. See Figure 4-1. Neutral...

10 Setting The Depth Tilling depth is controlled by the depth stake which can be adjusted to five different settings. Adjust the side shields as you adjust the depth stake. WARNING: Be certain spark plug wire is disconnected and grounded against the engine when performing any adjustments. • When usi...

11 To adjust the depth stake, remove the clevis pin and hairpin clip. Move the depth stake to the desired setting and secure with the clevis pin and hairpin clip. See Figure 5-1.To adjust the side shields, remove the wing nuts. Move the side shield to the desired position and replace the wing nuts. ...

1 Cleaning Tine Area Clean the underside of the tine shield after each use. The dirt washes off the tines easier if rinsed off im-mediately instead of after it dries. Always towel dry the tiller afterwards and apply a light coat of oil or silicone to prevent rusting or water damage. IMPORTANT: Never...

13 8 • Remove the belt keeper bracket located behind the engine pulley by removing two hex bolts and lock washers. See Figure 8-1. • Remove belt and reassemble new belt. Follow instructions in reverse order. NOTE: Upon reassembly, make certain the belt is routed over the idler pulley and inside of b...

15 9 Illustrated Parts List Model 450 Series To order replacement parts, contact 1 (800) 800-7310 or visit www.mtdproducts.com Ref. Part No. Part Description 1. 611-04074 Wheel Shaft Ass’y 33T 2. 611-0021 Tine Shaft Ass’y: 18T 3. 611-0128 Jack Shaft Ass’y 4. 611-0129 Input Shaft Ass’y 5. 617-0058 Re...

0 For repairs beyond the minor adjust- ments listed here, contact an authorized service dealer. 10 Trouble Shooting Cause Problem Remedy Engine fails to start 1. Spark plug wire disconnected.2. Fuel tank empty or stale fuel.3. Throttle control lever not in correct starting position (if equipped) 4. ...

1 For parts and/or accessories please call 1-800-800-7310, or 1-330-220-4683. www.mtdproducts.com NOTES: Use this page to make notes and write down important information. NOTE: Specifications are subject to change without notification or obligation. Images my not reflect your exact model and are for...

The limited warranty set forth below is given by MTD LLC with respect to new merchandise purchased and used in the United States, its possessions and territories.“MTD” warrants this product against defects in material and workman-ship for a period of two (2) years commencing on the date of original ...