Monarch PLT200 - Manuals - manualsarea.com

Page 2 - SAFEGUARDS AND PRECAUTIONS; RCA

SAFEGUARDS AND PRECAUTIONS WARNING - This product emits a visible beam of laserlight. Avoid exposure to the laser radiation. The use ofoptical viewing aids (binoculars, for example) mayincrease the ocular hazard. CAUTION - The laser beam should not be intentionallyaimed at people or animals. C A U T...

Page 3 - Both

TABLE OF CONTENTS TABLE OF CONTENTS 1.0 OVERVIEW ............................................................................. 12.0 FEATURE LOCATIONS ............................................................ 13.0 LCD DISPLAY SYMBOLS ....................................................... 24.0 PLT...

Page 4 - FEATURE LOCATIONS

1 1.0 OVERVIEW The Pocket Laser Tach 200 is a precision hand-held multifunctionTachometer, Ratemeter, Totalizer and Timer. It is programmable to displaydirectly in Revs, Inches, Feet, Yards, Miles, Centimeters and Meters orfunction as a stopwatch or interval timer. Input / output sockets allow forre...

Page 5 - Direct Contact Measurements; Laser; Rotational; ONLY USE MODERATE PRESSURE

2 3.0 LCD DISPLAY SYMBOLS On Target Indicator. Blinks on whenever there is an inputsignal. Will appear to be solid on at higher frequencies. Low Battery icon. Indicates that the batteries are low andneed to be replaced. Times Ten icon. Indicates that the value shown is ten timesthat which is display...

Page 6 - RPH; Contact Specifications using optional Remote Contact Assembly:; DONE

3 4.0 PLT200 SPECIFICATIONS Laser Specifications: Classification: Class 3R (per IEC 60825-1 Ed 1.2 2001-8) Complies with FDA performance standards for laser products exceptfor deviations pursuant to Laser Notice No. 50, dated July 26, 2001. Maximum Laser Output: 3mW Pulse Duration: Continuous Laser ...

Page 7 - Contact Measurements Ranges:; TIMER

4 Contact Specifications (continued): Accuracy: Revs: ±0.05% of reading (RPM) or resolution limit(with no slippage) Linear: ± 0.5% of reading or resolution limit (with no slippage) Contact Measurements Ranges: TACHOMETER: Revolutions per Minute (RPM) 0.5 to 20,000 RPMRevolutions per Second (RPS) 0.0...

Page 8 - Internal or External optics or linear contact wheel; Timer Specifications:; TOTALizer Operation

5 Contact Measurements Ranges (continued): RATES: Wheel Circumference: Yards per Hour 10cm: 3.281 to 131,233 YPH 12 in: 10.000 to 240,000 YPH Miles per Hour 10 cm: 0.002 to 74.564 MPH 12 in: 0.006 to 136.36 MPH Centimeters per Second 10 cm: 0.084 to 3,333.3 CM/S 12 in: 0.21 to 3,048.0 CM/S Centimete...

Page 9 - Installation Category II; NONE

Display: 5 x 0.5” (12.7mm) numeric digits plus 5 Alpha-numeric LCD Batteries: 2 “AA” 1.5 V (DC) alkaline included (Note: Batteries are NOT rechargeable.) Battery Life: 30 hours continuous typical with batteries provided External Input: Absolute max: -0.3 V to 5 V (DC) Minimum: low below 1.2 V and hi...

Page 10 - PREPARATION FOR MEASUREMENT; Direct Contact Preparation; Select and install contact option:

7 5.0 PREPARATION FOR MEASUREMENT 5.1 Non-Contact Preparation For Internal operation (Red laser) or External operationusing optional Remote Optical Sensor (ROS-Red LED). 5.2 Direct Contact Preparation For External operation ONLY using optional RemoteContact Assembly (RCA). 1. Clean Shaft As small as...

Page 11 - Connecting External Sensors; OR; TOTAL

8 5.3 Connecting External Sensors Plug sensor intoInput socket Tighten screwsecurely into flaton shaft. Remote Optical Sensor (ROS-P) Install withpin in shaftfully seatedin slot.Tightenscrew. 2. 10 cm Wheel 3. 12 inch Wheel OR Remote Contact Assembly (RCA) (shown with optional 12 inch wheel) ...

Page 14 - TACHometer Operation; RATE

11 Measure Recall Max Recall Min If unit Lockedon: Power OFF Min Speed Max Speed Automatic after 90 secondsif unit not Locked on OR Press and hold Lock on 6.2 TACHometer Operation Resets Max/Min OR 12 1. TurnPowerON 2. EnterSetupMode 3. Enterselectionof Mode 4. SelectRATEMode 5. Save andadvance OR T...