M&K Sound SW-150 - Manuals - manualsarea.com

Page 2 - Table of Contents; Please complete the following:

Table of Contents 1. Introduction ...................................................................................................3 Figure 1 - Major Components of the SW-150 .........................................3 2. Speaker Hookup .................................................................

Page 3 - FIGURE 1 - The Major Components of the SW-150

1. INTRODUCTION Congratulations! Your new M&K in-wall speaker system will give you years of unmatched enjoyment and excitement while listening to your favorite musical and audio/video sources. We encourage you to read this owner’smanual, as there is a great deal of information provided here to h...

Page 5 - Fill in the wall space around the; IMPORTANT! - MAKE SURE WALL ELECTRICITY IS; POST CONSTRUCTION INSTALLATION

1. Mark wall with the template, using astud finder to maintain a 2” distance fromany stud. Make sure that you are clear ofany crossbraces in the wall structure. FOR STANDARDINSTALLATIONDRYWALLTHICKNESS CANNOTEXCEED 1.25 INCHES.FOR THICKERWALLS CALLM&K SOUND. 2. Cut opening precisely with a drywa...

Page 6 - Angle the speaker toward the wall and slip the; Center the speaker within the wall opening

In-wall Operation Manual 9. Remove packing material and grille from speaker. DoNot Remove the Elastic Cord! Make sure that themounting screws are flush with the front baffle as shown. 10. Angle the speaker toward the wall and slip the bottom portion of the mounting arms into the wallopening. 11. Tip...

Page 7 - Tighten all mounting screws sequentially to light

In-wall Operation Manual 13. Make sure that the baffle is level by checking with aleveling device. 14. Tighten all mounting screws sequentially to light resistance. Continue to tighten screws to an even torquethat will secure the baffle to the wall. 15. The grille ca be painted with Latex paint to m...

Page 8 - and Negative speaker inputs on the back of BOTH Main speakers.

7. SATELLITE/SUBWOOFER PHASING TEST When using a subwoofer with your SW-150, a phasing test must be performed to insure good bass blending. This test insures optimum sound in the critical bass frequencies where your Subwoofer and Main speakersoverlap. Play a familiar CD or DVD with steady, consisten...

Page 9 - IF YOU NEED SERVICE OR SET-UP ASSISTANCE; DO NOT RETURN YOUR SPEAKERS TO THE FACTORY FOR

In-wall Operation Manual 9 8. SPEAKER DAMAGE & HOW TO AVOID IT An important factor to consider with any loudspeaker system is the potential for speaker damage. Even though your M&K Speakers have extremely high power handling ability (especially for Main speakers), they still can bedamaged by...

Page 10 - 1 SPECIFICATIONS; ohms

11 SPECIFICATIONS IMPEDANCE: 4 ohms MINIMUM POWER: 25 watts RMS RECOMMENDED POWER: amplifiers with between 25 and 400 watts RMS MAXIMUM POWER: 400 watts RMS unclipped peaks FREQUENCY RESPONSE: 77 Hz - 20 KHz ± 2 dB SENSITIVITY (2.83 V @ 1m): 92dB FRONT BAFFLE: 11 gauge steel GRILLE DIMENSION (H x W ...