Mitsubishi Trim 110- Manuals

3. Press CTRL + ALT and keep them pressed while pressing the DELETE key. The Log-In screen will appear ensuring the correctsetup. The default setup is normally the correctone. If this default setup is incorrect, please contactyour local support engineer. 4. Press Enter . The system automatically sta...

During normal operation 4 programmes areneeded. Program RipManager Manager RipMate PlateSetter Monitor The above icons represent the available pro-grammes, and each programme can display one ormore windows on the screen. Program Manager The Program Manager in Windows NT managesall programmes. If one...

Active Queue This queue shows all jobs ready for processing.The jobs will be processed in top-down order. Held Queue This queue shows already processed jobs and thejobs which have generated an error. A black dotnext to the job name indicates an error has occured.Check the RIP Monitor for error messa...

2. Otherwise, select Start Inputs from the Rip- Mate menu in RipMate. The connection to the front-end will now be estab-lished. Monitoring the RIP The RipMonitor/System Monitor displays a log ofthe RIP as shown below. 1. If the above window does not appear, select Rip Monitor from the RipMate pull-d...

Liquid Level: The level in the activator tank is to low. Change the chemistry or refill the replenish-ment bottles Drive Load: The processor stopped due to over- load of the processor motor. Check whether thereis a plate in the processor section. Dryer Exit: Jam in the processor section. Open the pr...

7. Click Form Feed. 8. Click YES to form feed a plate. Repeat the last two steps until all exposed materialis fed. 9. Click OK. 10. Iconise the RipMagager by clicking the follow- ing button in the upper right corner. 11. To expose, start processing again. See section “Start/stop processing”. Emptyin...

5. Unplug the cable for the heating element un- derneath the processor module. 6. Release the draining hoses and insert each one into a separate empty container. Open the taps. 7. When the unit is empty, shut off the taps and fit the hoses into their holders. Before filling the empty tanks with new ...

Warning: Never turn on the power unless theprocessor module is filled or the power plug forthe heating element is removed, as this may causeoverheating and damage to the processor module. Troubleshooting Error messages The DPX SYSTEM displays error messages in theOutput Controller and in the PlateSe...

2. Technical Specifications DPX SYSTEM Digital Platesetter Type: Digital Plate Exposure System Max. plate format: 460 x 550 mm / 16.5 x 21.6" Max. image/exposure area: 436 x 546 mm / 16.3 x 21.4" Imaging technology: Internal drumLight source: 670 nm visible red laser diode Plate material: Ph...