Mitsubishi MSZ-GA80 VA- Manuals

6 4 NOISE CRITERIA CURVES 90 80 70 60 50 40 30 20 10 63 125 250 500 1000 2000 4000 8000 NC-60 NC-50 NC-40 NC-30 NC-20 NC-70 OCT A VE BAND SOUND PRESSURE LEVEL, dB re 0.0002 MICRO BAR BAND CENTER FREQUENCIES, Hz Test conditions Cooling : Dry-bulb temperature 27 : Wet-bulb temperature 19 : APPROXIMATE...

7 OUTLINES AND DIMENSIONS 5 MSZ-GA25VA Unit : mm 155 155 335 320 41.5 215 42.5 214 3 287.5 70 55 55 55 225 225 or more 7 100 90 106 298 102 624.5 780 210 5 53.5 19 159 58 14 273.5 234 Air in Air out Wall hole [ 65 Indoor unit Installation plate Installation plate 11X20 Oblong hole 11X26 Oblong hole ...

8 6 WIRING DIAGRAM REFRIGERANT SYSTEM DIAGRAM 7 MSZ-GA22VAMSZ-GA25VAMSZ-GA35VA Indoor heat exchanger Flared connection Room temperaturethermistorRT11 Indoor coil thermistorRT13(sub) Flared connection Refrigerant flow in cooling Refrigerant flow in heating Refrigerant pipe [ 9.52 (with heat insulator...

9 SERVICE FUNCTIONS 8 8-2. P.C. BOARD MODIFICATION FOR INDIVIDUAL OPERATION A maximum of 4 indoor units with wireless remote controllers can be used in a room.In this case, to operate each indoor unit individually by each remote controller, P.C. boards of remote controller must bemodified according ...

10 TROUBLESHOOTING 9 9-1. Cautions on troubleshooting 1. Before troubleshooting, check the following 1) Check the power supply voltage. 2) Check the indoor/outdoor connecting wire for mis-wiring. 2. Take care of the following during servicing 1) Before servicing the air conditioner, be sure to turn ...

11 2 1 Stopper Lock. Left Insert this end first. 3. Troubleshooting procedure 1) First, check if the OPERATION INDICATOR lamp on the indoor unit is flashing on and off to indicate an abnormality. To make sure, check how many times the abnormality indication is flashing on and off before starting ser...

13 2. Indoor unit failure mode table NOTE : Blinking patterns of this mode differ from the ones of Troubleshooting check table(9-4.). 12-time flash2.5-second OFF Replace the indoor electronic controlP.C. board. Indoor control system It cannot properly read data in the nonvolatile memory of the indoo...

17 Check of indoor fan motor A When OPERATION INDICATOR lamp flashes 3-time.Indoor fan does not operate. w If more than 12 seconds or more passes after EMERGENCY OPERATION switch is pressed, the voltage mentioned above 2 goes 0V DC although the indoor electric control P.C. board is normal. Indoor el...

18 Check of remote controller and receiver P.C. board B Indoor unit operates by pressing EMERGENCY OPERATION switch, but does not operate with the remote controller. w Check if the remote controller is exclusive for this air conditioner. Yes Replace the batteries. (Refer to 9-1.4.) Turn ON a radio t...

19 The unit does not operate with the remote controller.Also, OPERATION INDICATOR lamp does not light up by pressing EMERGENCY OPERATION switch. Check of indoor electronic control P.C. board and indoor fan motor C Yes No w 1. The fan motor connector's 1 lead wire is red, whereas 3 is black. w 2. Con...

20 How to check mis-wiring and serial signal error D Is there rated voltage in the power supply? Is there any mis-wiring, poor contact, or wire disconnection of the indoor/outdoor connecting wire? W 1. Mis-wiring may damage indoor electronic control P.C. board during the operation. Be sure to confir...

21 Check of installation of the horizontal vane E Replace the indoor electronic control P.C. board. Replace the interlock switch(Fan). Is the stopper of the horizontal vane locked to the indoor unit correctly? Yes No Is there resistance 0 " ? Relock the stopper of the horizontal vane to the indo...

22 Electromagnetic noise enters into TV sets or radios F Replace or repair the antenna.Replace or repair the coaxial cable. No No No Yes Yes No No Yes Yes Yes Is the distance between theantennas and the indoorunit within 3m, or is thedistance between theantennas and the outdoorunit within 3m? Is the...

24 DISASSEMBLY INSTRUCTIONS 10 (1) Slide the sleeve and check if there is a locking lever or not. (2) The terminal with this connector has the locking mechanism. 1 Slide the sleeve. 2 Pull the terminal while pushing the locking lever. 1 Hold the sleeve, and pull out the terminal slowly. The terminal...

25 2. Removing the electronic control P.C. board, the power monitor receiver P.C. board, SW P.C. boardand the terminal block (1) Remove the horizontal vane, the panel (Refer to 1.) and the corner box. (2) Remove the screw of V.A. clamp, and then the indoor/outdoor connecting wire. (See Photo 2.) (3)...

27 PARTS LIST (non-RoHS compliant) 11 MSZ-GA22VAMSZ-GA25VAMSZ-GA35VA11-1. INDOOR UNIT STRUCTURAL PARTS No. Part No. Part name Remarks Symbol in Wiring Diagram Q'ty/unit 1 234567 8 9 1011 REMOTE CONTROLLERREMOTE CONTROLLER HOLDER KM05B BOXBOXPANEL ASSEMBLY SCREW CAPFRONT PANEL CATECHIN AIR FILTER (LE...

PARTS LIST (non-RoHS compliant) 28 11-3. INDOOR UNIT ELECTRICAL PARTS AND FUNCTIONAL PARTS MSZ-GA22VAMSZ-GA25VAMSZ-GA35VA 4 2 5 3 9 1 6 22 11-4. INDOOR UNIT HEAT EXCHANGER 10 8 7 12 13 14 15 16 21 24 23 11 15 15 19 17 18 20 OB378C--1.qxp 07.3.30 8:35 AM Page 28

29 BEARING MOUNTSLEEVE BEARINGDRAIN HOSENOZZLE ASSEMBLYVANE MOTOR UNIT (HORIZONTAL)INTERLOCK SWITCH(FAN)HORIZONTAL VANEFUSEFUSEVARISTORPOWER MONITOR RECEIVER P.C. BOARD HOLDERV.A. CLAMPTERMINAL BLOCK COVERTERMINAL BLOCK HOLDERTERMINAL BLOCKELECTRONIC CONTROL P.C. BOARD W 1 ELECTRONIC CONTROL P.C. BO...

33 BEARING MOUNTSLEEVE BEARINGDRAIN HOSENOZZLE ASSEMBLYVANE MOTOR UNIT (HORIZONTAL)INTERLOCK SWITCH(FAN)HORIZONTAL VANEFUSEVARISTORPOWER MONITOR RECEIVER P.C. BOARD HOLDERV.A. CLAMPTERMINAL BLOCK COVERTERMINAL BLOCK HOLDERTERMINAL BLOCKELECTRONIC CONTROL P.C. BOARD W 1 ELECTRONIC CONTROL P.C. BOARD ...

34 MAC-093SS-E Model Part No. MSZ-GA22VA MSZ-GA25VAMSZ-GA35VA 13-2. QUICK CLEAN KIT ● You can sweep the surface of heat exchanger if you install the special-made brush to your vacuum cleaner. Heat exchanger 13 OPTIONAL PARTS Model Part No. MAC-415FT-E MSZ-GA22VAMSZ-GA25VAMSZ-GA35VA Air cleaning filt...

HEAD OFFICE: TOKYO BLDG., 2-7-3, MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPAN C C Copyright 2005 MITSUBISHI ELECTRIC ENGINEERING CO.,LTD Distributed in Apr. 2007. No. OB378 REVISED EDITION-C 6Distributed in Jan. 2007. No. OB378 REVISED EDITION-B 6Distributed in Jan. 2006. No. OB378 REVISED EDITION-...