Milwaukee 9572 - Manuals

APPLICATION INFORMATION This hoist is intended for general industrial use for lifting andtransporting freely suspended material loads within its ratedcapacity. MILWAUKEE cannot be responsible for applications other than those for which MILWAUKEE equipment is recommended. Prior to installation and op...

Milwaukee Electric Tool Corporation13135 West Lisbon RoadBrookfield, Wisconsin 53005TEL: (800) 729-3878 2. Before operating the hoist, be sure to observe the following: a. ALWAYS DISCONNECT HOIST FROM POWER SUPPLY before removing the electrical cover or when making anyelectrical connection in the ho...

11. Do not operate unless hook travel limit devices function. Test without load each shift. 12. Do not operate when hoist is not centered over load. 13. Do not operate if chain is not seated properly in sprockets or sheave grooves. 14. Do not operate damaged or malfunctioning hoist. OVERLOAD LIMITIN...

7 CHAIN Chain is to be kept clean and lubricated (See LUBRICATION,page 9). Visually check chain every time hoist is used. Hoistmust not be operated when chain is twisted or kinked. Animportant phase of hoist maintenance is chain inspection.Check individual links and check for chain elongation. 1. Ch...

Chain Replacement with No Chain in Hoist Refer to Figures 4 and 5. 1. DISCONNECT HOIST FROM POWER SUPPLY and move hoist to a work table. Do not remove the electrical cover. 2. Lay the hoist on its side and remove the four screws that attach the sheave housing to the gear housing (See Figure12, Ref. ...

9 3. Carefully raise load block to upper limit and observe if it stops automatically at desired level. Do not allow load blockto run into hoist housing — this will damage the hoist.Maintain a minimum clearance of 2" from the hoist housingand the top of the load block on single-chained models and...

Limit Switch Shaft Remove any dirt accumulation and spray with a generalpurpose lubricant. Hook Bearing Apply a few drops of SAE 30 gear or motor oil around the edgeof the bearing. Idler Sheave Bearing (Bushing) Disassemble load block and apply a light coat of NLGI #2grease, or equivalent, inside of...

11 5. Remove four screws attaching gear box cover to gear housing and remove gear box cover. Limit switch drive shaftwill come along with the cover. 6. Inspect gears for broken or severely worn teeth and inspect all bearings. Replace as necessary. The overload slip clutchis factory calibrated and mu...

Milwaukee Electric Tool Corporation13135 West Lisbon RoadBrookfield, Wisconsin 53005TEL: (800) 729-3878 13 1. Limit switch not operating 1. Check adjustment (See LIMIT SWITCH ADJUSTMENT, page 8). Check connections against wiring diagram. Tighten loose connections or replace. 2. Brass limit switch nu...

16 3 16 15 14 7 2 12 1 4 6 8 10 13 5 1 Motor 1 (See Figures 13 & 14) 2 Sheave Housing Screw 4 3 Sheave Housing 1/2 Ton 1 1 & 2 Ton 1 4 Gear Housing 1/2 Ton 1 1 & 2 Ton 1 5 Gear Case Gasket 1 6 Gearbox Cover 1 7 Electrical Cover Gasket 1 8 Electrical Cover 1 9 1/4" Spring Lockwasher 1...

20 Figure 16 - Electrical Parts Milwaukee Electric Tool Corporation13135 West Lisbon RoadBrookfield, Wisconsin 53005TEL: (800) 729-3878 1 Gear Box Cover 1 2 Panel Plate 1 3 Reversing Contactor 1 hp, 115/230V 1 1 hp, 230/460V 1 1/2 hp 1 4 Transformer Pri.: 115/230V, Sec.: 24V 1 Pri.: 230/460V, Sec.: ...

Milwaukee Electric Tool Corporation13135 West Lisbon RoadBrookfield, Wisconsin 53005TEL: (800) 729-3878 21 Figure 17 - Limit Switch Parts 7 15 17 16 6 13 10 9 12 3 11 14 5 1 4 1 Gear Box Cover 1 2 Limit Switch & Shaft Assembly 1 (Includes Items 4-12) 3 Limit Switch Assembly 1 (Includes Items 4-8...

22 Figure 18 - Pushbutton Station Milwaukee Electric Tool Corporation13135 West Lisbon RoadBrookfield, Wisconsin 53005TEL: (800) 729-3878 12 6 7 10 11 4 5 13 14 15 4 8 4 9 16 3 2 1

24 Figure 19 - Transmission Parts Milwaukee Electric Tool Corporation13135 West Lisbon RoadBrookfield, Wisconsin 53005TEL: (800) 729-3878 12 1 4 2 13 9 3 11 8 7 23 26 24 23 20 25 27 30 5 18 20 21 17 15 31 18 22 14 15 16 16 18 19 6 10 26 **32 27 28 29 7 13 *NOTE: Orient output gear (32) with long bos...

26 Figure 20 - Chaining Parts Milwaukee Electric Tool Corporation13135 West Lisbon RoadBrookfield, Wisconsin 53005TEL: (800) 729-3878 2-Ton Models 1-Ton Models 2-Ton Models 1/2 -Ton Models 1 17 16 15 18 14 22 11 29 6 9 12 27 13 20 5 3 4 8 28 23 21 25 35 36 35 34 7 10 32 31 36 46 47 41 24 44 33 50 19...

30 Milwaukee Electric Tool Corporation13135 West Lisbon RoadBrookfield, Wisconsin 53005TEL: (800) 729-3878 NOTES

Strong Public Support Market Survey Report  97% of survey respondents would love to see the Madison Public Market developed  71% of survey respondents would shop at the Madison Public Market

MADISON PUBLIC MARKET Market Assets and Vendor Options • 52 locally-owned permanent vendors • Demonstration kitchen • Customer seating area • On-site parking at new underground ramp • 22 three-season day stalls • 8 carts North Market in Columbus, Ohio, USA

Stalls Farmer’s Market Co-op ~ Soul Food ~ Wine Bar ~ Market Diner Taste of Wisconsin ~ Fresh Tortilla Maker ~ Hmong Prepared Food Chocolatier ~ German Deli & Sausage Maker Restaurants Café 150 ~ Brew Pub Madison Public Market Proposed Vendor Mix…A Sampling Stores International Grocery ~ Butcher...

Site Attributes • Block 105 is the best site for Madison Public Market!! • Site accommodates 40,000-45,000 net leasable SF • Unmet opportunity for 45-minute lunch counter • Tenant mix will meet needs of existing & future downtown residents • Close to Monona Terrace & Existing Hotels (1,068 r...

Downtown Community Assets Residents • 26,560 People live within a mile Employees • 29,594 Employees or 22% of All City Employment in CBD Census Tracts Ethnic Minorities • Even Distribution of Latinos, African Americans and Asians

Development Details • 40,000 – 45,000 net square feet optimal size • City role will be in real estate development, not management • Estimated $10 million construction budget • Timeline – Construction in 2014 • Market Opens in 2015 • Construction Coordinated with Parking and other Major Redevelopment...

• MPM Exterior Great Example of ―Bulbout‖ Restaurant Seating Concept Grove Arcade in Asheville, North Carolina, USA

Entryways Pedestrian Entries: • Major entrances at S. Pinckney Street corners of E. Doty and E. Wilson • Secondary Entry midblock of E. Doty • Entry via elevator from underground ramp • Potential for shared egress with Great Dane Vehicle Parking: • Entrance to Underground ramp from either E. Doty or...

Ground Floor Non- Retail Uses • Pulic restrooms to be provided on the ground floor. • Way-finding signage and event/kiosk/bulletin boards should be provided throughout the Market • Happenstance seating should be provided in nooks and crannies wherever possible.

Second Floor and/or Loft Uses • Multipurpose conference/meeting room • Board Meeting (around a table) with 20 attendees • Public Meeting with 60 (standing) attendees • State-of-the-art demonstration kitchen • Connected to multi-purpose room • Host cooking classes (classroom style) with 40 attendees ...

Parking • MPM Visitor Vehicle Parking available on site • MPM will be one floor above a regional parking ramp • Parking is easy to find and navigate • MPM predicted parking demand is roughly 200 spaces • Estimate that 63% of MPM visitors will arrive by car • Highest Demand for MPM parking will occur...