Miele KWT 1611 Vi - Manuals

Installation options There are many different installationoptions. You are limited only by thedesign of the kitchen. The door hinge cannot beexchanged. Single column The appliance can be installed at anypreferred location in the kitchen. However, be sure the door will openand close properly in the c...

. . . with partition The minimum thickness of the partitionis 5 / 8 " (16 mm). If there is a partition between theadjacent appliances, then eachappliance is to be individually installedwithin its own niche. A heating mat must only be installed ifthe partition wall is less than 6"(160 mm) wid...

Door dimensions (open min. 90°) A KWT 16x1 Vi 26 5/8" (677 mm) A KWT 16x1 Vi 12" (305 mm) 1. Power supply Dimensions 39

Before you begin Read these instructions completelyand carefully.Have the appliance installed by aqualified technician, according tothe enclosed installation instructions. To reduce the risk of injury ordamage to the product, two peopleshould be used for installation. These installation instructions...

Aligning the appliance ^ Align the appliance with the customfront. The installation aids e have been designed for the following totalthickness of custom doors: – 3/4" (19 mm) – 1 1/2" (38 mm). Be sure to take into account thepossible differing thicknesses of thecustom doors that are to be fi...

Preparing the custom door ^ Open the appliance door. ^ Unscrew the installation supports n from the appliance door. ^ Loosen the remaining screws fromthe strips o on each side of the door, then remove. ^ Set aside the screws and side strips o - you will need them again later. ^ Take off the light sw...

^ Adjust the custom door to adjacentfurniture/fixtures. ^ Align the custom door with thedouble-threaded bolts. ^ Tighten the nuts on the adjusting rail.This will correct the side alignment ofthe door. ^ Put the side strips o back into place and screw them completely down onboth sides of the applianc...

^ Insert the cover strip into the spacebetween the appliance and the sidepanel.For side-by-side combinations, thecover strips (on both sides of theappliance) are applied to theoutermost spaces only. ^ Attach the light switch cover. Attaching the toe kick panel The maximum height of the toe kickpanel...

Attaching the cover strips If the frame width is narrow, the coverstrip side piece may need to beshortened.To determine the required length of theside piece, one test piece is enclosedwith the cover strip. ^ Cut the cover strips (long for thesides of the door) to the requiredlength X . ^ Push the co...

Mounting the air separator The air separator keeps the supply andexhaust air separate. This preventswarm exhaust air from flowing into themachine, optimizing the energyperformance of the unit. ^ If necessary, shorten the three partsof the air separator. ^ Insert the foam pieces back into thesides. ^...

, Avoid the risk of electrical shock- Plug into a grounded 3-prongoutlet.- Do not move the ground plug.- Do not use an adapter.- Do not use an extension cord. Failure to follow these instructionscan result in death, fire, or electricalshock. Improper connection of theequipment grounding conductormay...