Page 4 - No Quibble Limited; Middleby Marshall will repair the equipment 24
4 MIDDLEBY MARSHALL INC. OVEN LIMITED WARRANTY (Non U.S.A.) The Seller warrants equipment manufactured by it to be free fromdefects in material and workmanship for which it is responsible. TheSeller’s obligation under this warranty shall be limited to replacingor repairing, at Seller’s option, witho...
Page 5 - Table of Contents
5 Table of Contents Page SECTION 1 DESCRIPTION .................................................................... 6 I. OVEN USES .................................................................... 6 II. OVEN COMPONENTS .................................................... 6 A. Conveyor Motor Drive...
Page 11 - D. STANDOFF INSTALLATION
11 D. STANDOFF INSTALLATION 1 Place screw, P/N 19A15144, through counter-bored hole in standoff, P/N 48522, and screw into weld nut on rear shroud. 2. Repeat procedure for both sides.
Page 12 - REVERSING THE CONVEYOR BELT
12 ATTACHING THE POINT OF SALE CABLE Remove the cable (P/N 59198) from the Kit. Attach the 90degree plug to the rear of the touchscreen display and routethe serial connector out the grommetted bottom hole andalong the gas pipe. Connect the serial connector with thecable supplied by the customer. CON...
Page 14 - D. PS770 Propane conversion
14 Certain safety code requirements exist for the installation ofgas ovens; refer to the beginning of Section 2 for a list of theinstallation standards. In addition, because a the oven isequipped with casters, the gas line connection shall be madewith a connector that complies with the Standard for ...
Page 15 - SECTION 3 - OPERATION; I. LOCATION AND DESCRIPTION OF CONTROLS; Displays messages during oven operation.; E. Energy Level Indicators; Displays energy usage on left and right sides of the oven.
15 SECTION 3 - OPERATION I. LOCATION AND DESCRIPTION OF CONTROLS A. Main On/Off Button Turns all oven functions on or off. If the oven is below the setpoint, it will rise to the set point and turn the conveyor on.If it is turned off and the oven is above 200° F, the blowerswill remain on until the o...
Page 17 - SCREEN ALERTS
17 III. QUICK REFERENCE: TROUBLESHOOTING SYMPTOM PROBLEM SOLUTION No electrical power • Check that the circuit breaker/fused disconnect is on. Makesure the emergenct stop button is on. Oven will not turn On. No gas pressure Burner did not light • Make sure main gas is on. • Turn oven off, and restar...
Page 22 - DESCRIPTION
22 1 2 3 4 5 1 0 1 5 16, 17, 18 1 9 ITEM QTY. P/N DESCRIPTION 1 1 59080 DIGITAL DISPLAY, PROGRAMMED 2 1 58678 MOTOR, CONVEYOR DRIVE 3 1 58679 CONVEYOR CONTROL BOARD 4 2 59169 INVERTER, PROGRAMMED 5 1 M9608 POWER SUPPLY 6 1 59047 KIT, THERMOCOUPLE (5 THERMOCOUPLES) 7 2 M9616 FAN, COOLING 8 2 57288 MO...