Meyer Sound SB-1 - Manuals - manualsarea.com

Page 2 - declares that the product:; conforms to the following Product Specifications:; Environmental Specifications for; Contents

2 Pour indiquer les risques résultant de tensions dangereuses Zu die gefahren von gefährliche spanning zeigen Important operating instructions Pour indequer important instructions Zu wichtige betriebs- anweisung und unter- haltsanweisung zeigen Frame or chassis Masse, châssis Rahmen oder chassis Pro...

Page 3 - Product Summary; Meyer SB-1 Parabolic Sound Beam; AC Power; The Intelligent AC; Power Requirements; maximum continuous RMS

3 Product Summary The Meyer SB-1 Parabolic Sound Beam is the first device that propagates sound waves with SPLs thatdecrease as little as 3 dB per doubling of distance formore than 300 ft, across a five-octave frequency range,with a consistent and narrow beam width. The physical construction of the ...

Page 4 - Safety Issues; Aud io Input; input polarity switch

4 The minimum electrical service amperage required by asystem of SB-1s is the sum of the maximum continuous RMS current for each speaker. We recommend allowing an additional 30% above the minimum amperage to pre-vent peak voltage drops at the service entry. Safety Issues Pay close attention to these...

Page 5 - AC Troubleshooting; Active; TruPower Limiting System; HI Limit; do not; hard limiting; Driver Troubleshooting with TPL

5 AC Troubleshooting If the Active lamp does not light after connection to an AC source for three seconds, the problem is probably in thepower supply. In the unlikely case that the circuit breakerstrip (the white center buttons pop out), the amplifier orpower supply may be malfunctioning. Do not res...

Page 6 - Fans and Cooling System; temperatures or direct sunlight; Yoke Installation and

6 Fans and Cooling System The SB-1 uses a forced-air cooling system with two fansto prevent the amplifiers from overheating. A variable-speedprimary fan runs continuously with an inaudible operatingnoise of 22 dBA at 1 m at its slowest speed. The speed ofthe primary fan begins increasing when the te...

Page 8 - grade; High Frequency Pod

8 Cover Removal and Installation The Dish cover is held in place by four sets ofC-brackets and locking pins as shown below. It is easier to remove the dish cover if the pins andbrackets are not supporting the entire weight of the cover.To ease the stress on the pins, loosen the 3 / 4 ” grade rigging...

Page 9 - Driver Polarity Verification; Place the measurement microphone 75°

9 While keeping a firm grip on the pod insert one of the legsinto a c-bracket so that the holes in the legs are aligned withthe holes in the c-bracket. Then insert a pin through theholes while pressing down on its button head. When thefirst pin is in position attach the leg opposite to the first one...

Page 10 - Safety Summary

10 • To reduce the risk of electric shock, disconnect the loud- speaker from the AC mains before installing audio cable.Reconnect the power cord only after making all signalconnections. • Connect the loudspeaker to a two-pole, three wire grounding mains receptacle. The receptacle must be connected t...

Page 11 - Controls and Connectors; Front; Physical Dimensions; Contact Information

11 Controls and Connectors European Rear User Panel with IEC 309 connector Rear User Panel shown with the optional Remote Monitoring System (RMS) panel Packed for shipping (with yoke) Front Side Physical Dimensions 48.5 18.0 54.0 54.0 Weight: SB-1: 293 lb (133 kg); SB-1 with yoke: 392 lb (178 kg) Me...