McIntosh MPC500 - Manuals - manualsarea.com

Page 3 - Orange → 2. Orange; Antenna “F” Connector; Connector and Cable Information

3 following information includes the eight pin connector Socket and the Ethernet Connection Cable. Ethernet RJ45 Socket 1. Transmit Data (+) 5. N/C 2. Transmit Data (-) 6. Receive Data (-) 3. Receive Data (+) 7. N/C 4. N/C 8. N/C Ethernet Cable - Straight Thru Connections Pin Number - Wire Color Pin...

Page 5 - The following dimensions can assist in determining; Dimensions; Side View of the MPC500

5 Dimensions The following dimensions can assist in determining the best location for your MPC500. Dimensions Side View of the MPC500 Front View of the MPC500 Rear View of the MPC500 (100V-120V) 17- 1/2 " 44.5cm 6" 15.2cm 5- 3/8 " 13.7cm 4- 5/8 " 11.8cm 13- 1/4 " 33.7cm 17- 1/8 &...

Page 6 - Be sure to cut out a; When the MPC500 is installed together with other Mc-; Custom Cabinet Cutout; in Custom Cabinet

6 Installation Installation The MPC500 can be placed upright on a table or shelf, standing on its four feet. It also can be custom installed in a piece of furniture or cabinet of your choice. The four feet may be removed from the bottom of the MPC500 when it is custom installed as out- lined below. ...

Page 9 - Switched AC Power Outlets:; Caution: Do not connect the AC Power Cord to the; Power Control Connections:

9 OUT Connector to the Network Router/Switch and Ethernet Crossover Adapter Input Connector. 6. Connect Network Cables from the Router/Switch or Ethernet Crossover Adapter NETWORK Output connectors to each of the Audio/Video Compo- nents (A/V Control Center, Media Bridge, and any addition components...

Page 12 - Front Panel Displays and Controls

12 Front Panel Displays and Controls DISPLAY CONTROL selects various operation func- tions. Push in the DISPLAY CONTROL to activate the SETUP Operation Modes of various functions selectable by rotating the Control OUTLET STATE Control switches the MPC500 On or Off by pushing the Control In. Rotate t...

Page 13 - Note: If during the last time the MPC500 was On; How to Operate; DISPLAY CONTROL, figures 3A or 4A will now; Status of the Power AC Outlets; AC LINE POWER

13 Each of the displays indicate the Status of the MPC500 AC Power Outlets and the Power Con- trol Settings for the AC Power Outlets. Display Control After the MPC500 is switched On and the Front Panel Display has indicated the previous figures (3A, 4A or 3B/4B), rotate the DISPLAY Control Clockwise...

Page 14 - How to Operate, con’t

14 4. Rotate the OUTLET STATE Control to select the setting of GLOBAL or LOCAL. Refer to figures 19 and 20. 5. Once the new Power Control Setting has been selected, press the DISPLAY CONTROL. Setup Display Brightness Configuration The Front Panel Display Brightness is adjustable via a Setup Mode of ...

Page 15 - Setup Factory Reset Operation; FACTORY RESET

15 Setup Factory Reset Operation If the MPC500 Operational Settings need to be re- stored to the default settings perform the following: 1. Press DISPLAY CONTROL and then rotate the Control until the Front Panel displays “FACTORY RESET (Hold SETUP). Refer to figure 22. 2. Then press in and hold the ...

Page 17 - Photos

McIntosh MPC500 - Manuals

Manuals:

User Manual McIntosh MPC500

Summary