Maytag W10252706B- Manuals

6 INSTALLATION INSTRUCTIONS Unpack Range 1. Remove shipping materials, tape and film from range. 2. Remove oven racks and parts package from inside oven. 3. Do not remove the shipping base at this time. 4. On Ranges Equipped with Storage Drawers: Remove the storage drawer. See the “Storage Drawer” s...

7 5. To mount anti-tip bracket to wood floor, drill two ¹⁄₈ " (3.2 mm) holes at the positions marked on the bracket template. Remove template from floor. To mount anti-tip bracket to concrete or ceramic floor, use a ³⁄₁₆ " (4.8 mm) masonry drill bit to drill 2 holes at the positions marked o...

10 Direct Wire Installation: Copper or Aluminum Wire This range may be connected directly to the fuse disconnect or circuit breaker box. Depending on your electrical supply, make the required 3-wire or 4-wire connection. 1. Strip outer covering back 3" (7.6 cm) to expose wires. Strip the insulat...

12 Verify Anti-Tip Bracket Location 1. On models with a storage drawer, remove storage drawer. See the “Storage Drawer” section. On models with a warming drawer, the rear leg cannot be seen by removing the warming drawer. It will be necessary to view the rear foot from outside the range. 2. To check...

13 To Replace: 1. Lift up the back of the storage drawer and place it inside the range in its fully forward position. 2. Lift up the front of the storage drawer to a level position. 3. Slowly push the storage drawer into the range until the drawer side rails engage with the gap in the drawer glides....

14 Moving the Range When moving range, slide range onto cardboard or hardboard to avoid damaging the floor covering. If removing the range is necessary for cleaning or maintenance: For power supply cord-connected ranges: 1. Slide range forward. 2. Unplug the power supply cord. 3. Complete cleaning o...

15 ANTI-TIP BRACKET TEMPLATE Cut on dotted lines and place the left edge against the left side cabinet and the top edge against the rear wall. Left edg e Top edge