Page 2 - IMPORTANT DEFINITIONS; Maytag Customer Service Center:; DANGER
2 SAFE INST SAFE INST SAFE INST SAFE INST SAFE INSTALLA ALLA ALLA ALLA ALLATION TION TION TION TION, USE AND SERVICE , USE AND SERVICE , USE AND SERVICE , USE AND SERVICE , USE AND SERVICE Your safety and the safety of others is extremely important in the installation, use and servicing of this wate...
Page 5 - Thank You; Abbreviations Found In This Instruction Manual:
5 Thank You for purchasing a Maytag water heater. Properly installed and maintained, it should give you years of troublefree service. It is strongly suggested that this new water heaterbe professionally installed, call Maytag Customer Serviceat 1-800-788-8899 for recommended installers. Abbreviation...
Page 6 - Tools
6 ACCESSORIES AND TOOLS NEEDED ACCESSORIES AND TOOLS NEEDED ACCESSORIES AND TOOLS NEEDED ACCESSORIES AND TOOLS NEEDED ACCESSORIES AND TOOLS NEEDED Tools You may or may not need all of these tools, depending on yourtype of installation. These tools can be purchased at your localMaytag store. Pipe Wre...
Page 7 - Removing the Old Water Heater
7 Removing the Old Water Heater FIGURE 1. 1. Turn “OFF” electrical supply to the water heater. FIGURE 2. 2. Turn “OFF” the water supply to the water heater at the water shut-off valve or water meter. FIGURE 3. 3. Attach a hose to the water heater drain valve and put the other end in a floor drain or...
Page 8 - Locating the New Water Heater; This water; INSULATION BLANKETS; Typical Installation
8 FIGURE 7. Mineral buildup or sediment may have accumulated in the oldwater heater. This causes the water heater to be much heavierthan normal and this residue, if spilled out, could cause staining. Locating the New Water Heater You should carefully choose an indoor location for the newwater heater...
Page 9 - The Convertible Lower Element; call Maytag Customer Service at
9 supply or hardware stores. Follow manufacturers instructionsfor installation of the valves. Before changing the factory settingon the thermostat, read the “Temperature Regulation” sectionin this manual. FIGURE 8 WATER HEATERS EVENTUALLY LEAK: Installation of the waterheater must be accomplished in...
Page 11 - Temperature-Pressure Relief Valve
11 FIGURE 9A. Temperature-Pressure Relief Valve This heater is provided with a properly certified combinationtemperature - pressure relief valve by the manufacturer. The valve is certified by a nationally recognized testinglaboratory that maintains periodic inspection of production oflisted equipmen...
Page 12 - Filling the Water Heater; Converting the Lower Element; all Maytag Customer Service at
12 FIGURE 10. Filling the Water Heater Never use this water heater unless it is completely full of water.To prevent damage to the tank and heating element, the tankmust be filled with water. Water must flow from the hot waterfaucet before turning “ON” power. To fill the water heater with water: 1. C...
Page 14 - Wiring
14 8. Tighten terminals 2 and 3 to ensure proper electricalconnection. Failure to tighten terminal screws can cause a fire which canresult in DEATH, SERIOUS BODILY INJURY, OR PROPERTYDAMAGE. 9. Replace terminal cover on thermostat and fold insulationback over the element making sure that the locking...
Page 16 - Wiring Diagrams; STANDARD WIRING FOR 2 WIRE LEAD WATER HEATERS
16 Wiring Diagrams STANDARD WIRING FOR 2 WIRE LEAD WATER HEATERS NON-SIMULTANEOUS OPERATION 240 VOLT DOUBLE ELEMENT FIGURE 24. FIGURE 25. WIRING FOR 3 WIRE LEAD WATER HEATERS NON-SIMULTANEOUS OPERATION 240 VOLT DOUBLE ELEMENT
Page 17 - Thermostat Adjustments; SERVICE AND MAINTENANCE
17 Temperature Regulation HOTTER WATER CAN SCALD: Water heaters are intended toproduce hot water. Water heated to a temperature which willsatisfy clothes washing, dish washing, and other sanitizingneeds can scald and permanently injure you upon contact.Some people are more likely to be permanently i...
Page 18 - Anode Rod Inspection; Call Maytag; Draining
18 The upper and lower thermostats are adjustable if a differentw a t e r t e m p e r a t u r e i s d e s i r e d . R e a d a l l w a r n i n g s i n t h e“Temperature Regulation” section before proceeding. NOTE: It is not necessary to adjust the upper thermostat. However, if it is adjusted above th...
Page 22 - THERMAL EXPANSION; TROUBLESHOOTING
22 18. Replace access panel. 19. Turn “ON” electric power to water heater. FIGURE 41. Drain Valve Washer Replacement . NOTE: For replacement, use a 17/32" x 13/64" x 1/8" thickwasher available at your nearest hardware store. Forordering a replacement washer, refer to the “Parts OrderList...
Page 23 - Operational Conditions; SMELLY WATER
23 Operational Conditions SMELLY WATER In each glass-lined water heater there is installed one anoderod (see parts section) for corrosion protection of the tank.Certain water conditions will cause a reaction between thisrod and the water. The most common complaint associatedwith the anode rod is one...
Page 24 - Leakage Checkpoints; call
24 5. Replace the insulation cap with handle so that it completely covers the thermostat and element. 6. Replace the access panel. 7. Turn “ON” electric power to the water heater. If the high limit must be reset again, call Maytag customer Service at 1-800-788-8899 for an authorized servicer to find...
Page 26 - all Maytag; MODEL NO’S; Key
26 MAYTAG ELECTRIC WATER HEATERS REP REP REP REP REPAIR P AIR P AIR P AIR P AIR PARTS LIST ARTS LIST ARTS LIST ARTS LIST ARTS LIST NOTE: UPPER ELEMENT: These water heaters are equipped with 3800 watt elements. LOWER ELEMENT: These water heaters are equipped with factory installed convertible element...
Page 28 - LIMITED TANK WARRANTY AGAINST LEAKS; TO RECEIVE WARRANTY SERVICE
28 FULL ONE YEAR WARRANTY For one year from date of original retail purchase, any part which fails in normal home use will be repaired or replaced freeof charge. If a leak occurs in the tank, a new water heater of the closest capacity and quality then available, will be replaced free ofcharge. The w...