Page 2 - hours; WARNINGS & IMPORTANT SAFEGUARDS CONTINUED ON PAGE 2
1 GENERAL WARNINGS AND SAFETY INFORMATION READ ALL INSTRUCTIONS When using electrical appliances, basic safety precautions should always be followed including the following: • Cannot be operated for more than 3 hours . • Use GFI protected electrical outlet to reduce the risk of electrical shock. • F...
Page 3 - GENERAL WARNINGS AND SAFETY INFORMATION; WARNINGS & IMPORTANT SAFEGUARDS CONTINUED ON PAGE 3
GENERAL WARNINGS AND SAFETY INFORMATION • Be careful when removing food from electric grill. All surfaces are HOT and may cause burns. Use protective gloves or long, sturdy cooking tools. • Drip tray is only for the bottom of electric grill. Do not put drip tray on cooking grate this may damage elec...
Page 4 - foods use a low setting with lid open.; SAVE THESE INSTRUCTIONS; KNOWN TO THE STATE OF CALIFORNIA TO CAUSE BIRTH DEFECTS,; WARNING
3 GENERAL WARNINGS AND SAFETY INFORMATION • Fatty foods (hamburgers,etc.) can have excess grease and cause fl are ups. When cooking fatty foods use a low setting with lid open. • Clean internal base pan before each use. This will cut down on build-up and fl are-ups. • Do not expose electric grill to...
Page 5 - PARTS LIST; PART NO
4 PARTS LIST PART NO QTY DESCRIPTION PART NO QTY DESCRIPTION 1 1 Grill Lid 14b 1 Back Panel 2g 1 Temperature Gauge 15 2 Hub Cap 2b 1 Temperature Gauge Base 16 2 Wheel 3 1 Right Side Shelf 17 2 Foot 4 1 Heating Element 18* 2 Leg 5 1 Grill Base 19* 2 Wheel Leg 6 1 Left Side Shelf 20 1 Cooking Grate 7 ...
Page 6 - HARDWARE LIST
PARTS LIST 5 (B) M6x35 Phillips Head Screw Qty: 2 (F) Bakelite Spacer Qty: 2 (J) M4 Flat Washer Qty: 5 (D) M4x40 Phillips Head Screw Qty: 2 (G) M6x13 Phillips Head Screw Qty: 40 (L) M6x8 Phillips Head Screw Qty: 4 (A) M5 Thumb Screw Qty: 2 (H) M4x12 Phillips Head Screw Qty: 3 (E) M8x55 Phillips Head...
Page 7 - ASSEMBLY; ARE IDENTIFIED AND ACCOUNTED FOR.; LABELS; – Back Left; DO NOT FULLY
SHOR T SIDE FRONT ASSEMBLY *Note that the front of the grill is actually the shortest width of the bottom storage shelf (12). • BEFORE ASSEMBLY READ ALL INSTRUCTIONS CAREFULLY.• ASSEMBLE UNIT ON A CLEAN, FLAT SURFACE.• TOOL NEEDED: PHILLIPS HEAD SCREWDRIVER• UNPACK ALL PARTS AND LAY OUT IN FRONT OF ...
Page 8 - STEP 5a; short panel without the serial plate]
SHOR T SIDE FRONT 7 ASSEMBLY STEP 4 Attach bottom shelf (12) to legs (18) using screws (G) with the feet facing away from right side of the shelf as shown. Repeat for wheel legs (19) on left side using screws (G). STEP 5a Locate front panel (14f) [This is the short panel without the serial plate] an...
Page 9 - STEP 5b
8 ASSEMBLY STEP 5b Repeat step 4a for leg (19, “FL”). STEP 5c Place panel (14b) [the panel with the serial plate] over panels (13) and insert screw (G); into bottom holes. 19 19 18 14f 13 13 G G FL BL BR 14b
Page 10 - Repeat steps for left side.
ASSEMBLY STEP 6 Insert support (11b) into front leg (18, “FR”) with holes facing in-ward. Insert other (11a) into back leg (18, “BR”) with holes facing inward. Repeat steps for left side. When all supports are in place screw holes should be facing each other as shown in image. 13 18 19 18 G BR BL FR...
Page 14 - FIGURE 2
ASSEMBLY STEP 14 Attach temperature gauge (2g) and temperature gauge base (2b) to grill lid (1) using wing nut. 1 WING NUT 13 STEP 15 Place bakelite spacer (F) on grill lid (1). Attach handle (27) using washers (J) and screws (D) as shown. Make sure lid handle (27) is slop-ing downward as shown in F...
Page 15 - FIGURE 1
14 ASSEMBLY STEP 17 Place refl ector plate (9) into bottom of grill base (5). 5 9 STEP 16 Attach left side shelf (6) to both supports (11) using screws (G). Repeat step on opposite side with right side shelf (3). GO BACK AND TIGHTEN ALL SCREWS AT THIS TIME. G 6 11 FIGURE 1 NOTCH 6 Note: The left sid...
Page 17 - FIGURE 3
16 STEP 20 Insert warming rack (21) onto cooking grate (20), with forks of warming rack straddling grate as shown in FIGURE 3. STEP 21 Plug controller (10) into side of grill base (5) from below side shelf (6), coming in at a slight angle, carefully inserting plug while lifting so that top of contro...
Page 18 - SAFE STORAGE AND MAINTENANCE
17 • Inspect hardware and assembled parts on a regular basis to insure grill is in safe working condition. • ALWAYS allow grill to cool completely before handling. • ALWAYS empty drip tray after use only when ashes have completely cooled. • Clean grill, including special surfaces such as cooking gra...
Page 19 - LIMITED WARRANTY; California residents only:
18 LIMITED WARRANTY Masterbuilt warrants its products to be free from defects in material and workmanship under proper assembly, normal use and recommended care for 90 days from the date of original retail purchase. Masterbuilt warranty does not cover paint fi nish as it may burn off during normal u...