Magnum PATHFINDER-GRN-500W - Manuals

Specification of H102 display 10 / 18 i. ODO: Shows the mileage accumulated by the user. ii. TRIP: Display the user's cycling mileage. The single mileage will not be cleared when power off. The user needs to reset the mileage manually in the setting interface. iii. RANGE: Remaining mileage. The rema...

Specification of H102 display 11 / 18 6.4. Setting item description and operation 6.4.1. Enter and exit the Settings page and instructions for the Settings Press the key and at the same time to enter the setting interface. The meter on the setting page is displayed as follows: In the Settings page y...

Specification of H102 display 13 / 18 Users can adjust the display unit of mileage and speed according to actual needs. Choice of metric or British units. 6.4.3. Maximum speed setting Select the TOP SPEED, and then press the key to enter the Maximum Speed Setting page. This item can be adjusted only...

Specification of H102 display 14 / 18 Display current battery voltage, battery capacity, number of charging cycles. If the battery is not recommended by the manufacturer, the battery information may not be displayed properly. 6.4.5. System version Select the VERSION, and then press the key to enter ...

Specification of H102 display 15 / 18 in the main interface is 0-5. If OFF is selected, the adjustable range of the power gear is 0-6. 6.4.7. Mode setting Select the MODE, and then press the key to enter the Mode setting item. SPEED mode or TORQUE mode can be selected depending on the type of power ...

Specification of H102 display 17 / 18 7. Common questions and solutions Q: why can't you turn it on? Answer: the boot needs to hold down the power button for 2 seconds. If you can't turn on the check table wire beam and the controller's connector contact is secure. Q: how should the instrument displ...