Lumex AQ2000 - Manuals - manualsarea.com

Page 2 - CONTENTS

2 AQ1000-INS-LAB-RevD13 CONTENTS INTRODUCTION ...................................................................................... 3 INTENDED USE OF THIS DEVICE ........................................................ 3 CONTRAINDICATION ................................................................

Page 3 - INTRODUCTION; INTENDED USE OF THIS DEVICE; IMPORTANT SAFETY PRECAUTIONS

AQ1000-INS-LAB-RevD13 3 INTRODUCTION Use this manual for setup and operation of the Lumex AQ1000 / AQ2000 Alternating Pressure Pad and Pump System. Read all instructions before using the pad and pump system. Save this manual for future reference. INTENDED USE OF THIS DEVICE The intended use of the A...

Page 4 - immediately; WARNING

4 AQ1000-INS-LAB-RevD13 CAUTION: Indicates a potential hazard or unsafe practice that, if not avoided, could result in minor or moderate personal injury. s NOTICE: Indicates a potential hazard or unsafe practice that, if not avoided, could result in product or property damage. Info: Provides applica...

Page 5 - only; NOTICE

AQ1000-INS-LAB-RevD13 5 WARNING: Never operate this product if a) it has a damaged cord or plug. b) it is not working properly. c) it has been dropped or damaged. d) it has been dropped into water. Return the product to your Graham-Field authorized distributor. WARNING: Keep the cord away from heate...

Page 6 - EQUIPMENT SYMBOLS

6 AQ1000-INS-LAB-RevD13 EQUIPMENT SYMBOLS Attention! Consult accompanying documents (this manual) “BF”symbol: Indicates that this product is in accordance with the degree of protection against electric shock for type BF equipment Grounding terminal Class II (for UL only) Disposal of Electrical &...

Page 7 - PRODUCT DESCRIPTION; BUBBLE PAD AND PUMP SYSTEM; PUMP

AQ1000-INS-LAB-RevD13 7 PRODUCT DESCRIPTION BUBBLE PAD AND PUMP SYSTEM bubble pad and pump system air tubes bubble pad pump PUMP pump (AQ2000 shown) front panel wire hangers fuses (220V only) air tube connectors

Page 8 - Front panel pressure control dial (AQ2000 only)

8 AQ1000-INS-LAB-RevD13 FRONT PANELAQ1000 AQ1000 pump front panel ON/OFF switch air tube connectors AQ2000 AQ2000 pump front panel ON/OFF switch pressure control dial Front panel pressure control dial (AQ2000 only) : The pressure control dial controls the air pressure output. To increase pressure, t...

Page 9 - INSTALLATION; UNPACKING; Before unpacking, check for obvious damage to the; PUMP AND BUBBLE PAD INSTALLATION; installation; Fold open the wire hangers on the back of the pump as

AQ1000-INS-LAB-RevD13 9 INSTALLATION UNPACKING 1. Before unpacking, check for obvious damage to the carton or its contents. If damage is evident, please notify the carrier and your Graham-Field authorized distributor. 2. Remove all loose packing from the carton.3. Carefully remove all components fro...

Page 11 - OPERATION; will begin to deliver air into the bubble pad.; AQ2000 ONLY: PRESSURE ADJUSTMENT; Adjust the pressure control dial for comfort.; QUICK DISCONNECT

AQ1000-INS-LAB-RevD13 11 OPERATION 1. Turn the ON/OFF switch to the ON position. The pump will begin to deliver air into the bubble pad. 2. Replace all sheets, blankets, and pillows on the bed. Info: if the pressure level seems low, check for any leakage in the air tubes or bubble pad. Replace any d...

Page 12 - MAINTENANCE; CLEANING; Check the air tubes for kinks or breaks. For

12 AQ1000-INS-LAB-RevD13 MAINTENANCE CLEANING Perform the following cleaning procedures before use and as necessary thereafter. Pump Wipe the pump with a clean, damp cloth and mild detergent, and keep it away from dust. Air dry. s NOTICE: Do not use phenolic products or corrosive or powdered cleanse...

Page 13 - If you suspect a blown fuse, disconnect the plug from; fuse location; Use a small screwdriver to remove the cover of the fuse; STORAGE; with no exposure to direct sunlight.

AQ1000-INS-LAB-RevD13 13 Fuse replacement (220V system only) tool needed: small screwdriver 1. If you suspect a blown fuse, disconnect the plug from the wall outlet immediately. fuse location fuse fuse cover 2. Use a small screwdriver to remove the cover of the fuse holder (fuse locations are shown ...

Page 14 - SPECIFICATIONS; Contact your Graham-Field dealer or visit Graham Field's; Info: Specifications are subject to change without notice.

14 AQ1000-INS-LAB-RevD13 SPECIFICATIONS Model AQ1000 (Standard) AQ2000 (Deluxe) Power Supply 120V: 120V AC, 60 Hz, 1A 220V: 230VAC, 50 Hz, 7W Fuse Rating 120V: N/A 220V: T1A, 250V Pressure 1.9 psi (13.10 kPa) 1.0 - 2.0 psi (6.89-13.79 kPa) Air Output 120V: 4.5 LPM 120V: 4-5 LPM 220V: 5.0 LPM 220V: 5...

Page 15 - WARRANTY

AQ1000-INS-LAB-RevD13 15 WARRANTY GF Health Products, Inc. warrants the Lumex AQ1000 / AQ2000 Alternating Pressure Pad and Pump System for defects in workmanship and materials for the terms listed below. Pump: one year Pad: 90 days If a product is deemed to be under warranty, GF Health Products, Inc...