Page 2 - Disclaimer
All Rights Reserved © Copyright 2005 The use, disclosure, modification, transfer, or transmittal of this work for any purpose, in any form, or by any means, without the written permission of the copyright holder, is strictly forbidden. Trademarks used herein are the property of their respective owne...
Page 3 - Table of Contents
Linksys PAP2 Installation Guide Page i Table of Contents 1 Introduction ................................................................ 1 2 Adapter Description .................................................... 2 2.1 PAP2 Overview .............................................................. 2 2...
Page 4 - Introduction
Linksys PAP2 Installation Guide Page 1 1 Introduction This document is an installation/configuration guide for the Linksys PAP2 phone adapter running firmware version 2.0.10 (LSc). It describes how to configure the SIP parameters, codec settings and analog coefficients for outbound calling. It also ...
Page 5 - Adapter Description; Overview; and; Menu Options table on the following page for codes.
Linksys PAP2 Installation Guide Page 2 2 Adapter Description The sections below briefly describe the PAP2 device. 2.1 PAP2 Overview The PAP2 is a 2-port FXS phone adapter, which allows you to connect two (2) analog phones. PAP2 2-Port FXS Phone Adapter 2.2 Connectors and Pinouts The image below disp...
Page 6 - PAP2 MENU OPTIONS
Linksys PAP2 Installation Guide Page 3 PAP2 MENU OPTIONS Action Code User Input Behavior Notes Enter IVR Menu **** None Do not press any other keys until you hear, “Configuration menu. Please enter option followed by the pound (#) key, or hang up to exit.” Check DHCP 100 None The system announces if...
Page 7 - General Configuration for Outbound Calling; To configure the PAP2 for outbound calling:
Linksys PAP2 Installation Guide Page 4 3. Provisioning 3.1 General Configuration for Outbound Calling To configure the PAP2 for outbound calling: 1. Connect to the PAP2 by entering the device’s IP address in the Web browser’s Address bar. For instructions on obtaining the IP address, refer to sectio...
Page 8 - Configuration; IMPORTANT
Linksys PAP2 Installation Guide Page 5 3.2 Line-Specific Configuration 1. Click the Line1 or Line2 tab at the top of the page, and in the NAT Settings section, change the following setting: Field Value NAT Keep Alive Enable no 2. In the Proxy and Registration section (see the screen on the following...
Page 10 - Click the Submit All Changes button to save the settings.
Linksys PAP2 Installation Guide Page 7 Audio Configuration and Dial Plan Sections 7. In the Dial Plan section, change the Dial Plan to fit the dialing pattern in your country. The dialed number must start with ‘1’ for US calls and ‘011’ for non-US calls. Please read the PAP2 manual to customize your...