Linksys C260 - Manuals

Linksys C260 – Manual in PDF format online.

Manuals:

Manual

Manual Linksys C260

Summary

Page 2 - draft control must be

2 T esTing i nformaTion This manual describes the installation and operation of the Legacy™/Elite™ C/E260 non-catalytic wood heaters. These heaters meet the U.S. Environmental Protection Agency’s emissions limits for wood heaters sold on or after July 1, 1990. This heater has been developed, tested,...

Page 3 - onTenTs

c onTenTs T esTing i nformaTion .........................................................................2 g eneral s afeTy P recauTions ................................................................2 D rafTing .....................................................................................4 ...

Page 4 - rafTing; Slow; egaTive; Creosote, Formation and Need for Removal.

D rafTing Your wood stove is dependent upon a properly functioning chimney for optimum performance. It is a high efficiency appliance that loses much less heat up the chimney than older appliances and fireplaces. For this reason it is important to match the stove to the chimney. The chimney has two ...

Page 6 - CAUTION: Wear gloves during brick installation in; Figures 2 and 3; Figure 2

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. B rick i nsTallaTion Legacy™/Elite™ C/E20 Brick Installation CAUTION: Wear gloves during brick installation in case of sharp edges inside the stove. Note: Installation of the baffle bricks and insulating blanket is easier when you can still access...

Page 7 - The hearth and/or floor protection must be a thermally rated; COMBUSTIBLE MANTEL; Mantel; Hearth Protection; Trim; equireD; WARNING: BE ABSOLUTELY SURE THE DISTANCE BE-; Figure 4

7 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. Model F (1) G H J M C20 22” 559mm 1” 356mm 22-1/2” 572mm 5-1/” 133mm 50-1/2” 1283mm E20 22” 559mm 1” 356mm 22-1/2” 572mm 5-/” 133mm 5” 1143mm C20 with mantel and/or side shields u 22” 559mm 1” 356mm 22-1/2” 572mm 5-1/” 133mm 8” 965mm * Reduced c...

Page 8 - READ ENTIRE INSTALLATION INSTRUCTIONS; POSITIVE FLUE CONNECTION:; Figure 6

8 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. c himney r equiremenTs The L egacy ™/e Lite ™ c/e260 inserts are approved for use in masonry fireplaces built to UBC Chapter 37 or equivalent with a minimum 30” opening at the front of the fireplace. Do not remove brick or mortar from masonry fi...

Page 9 - NOTE: LENNOX HEARTH PRODUCTS RECOMMENDS PRO-; nserT; Figure 7

9 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. Clearance to Combusibles See “Required Clearances” on Page 7. Fireplace Pre-Installation Preparation NOTE: LENNOX HEARTH PRODUCTS RECOMMENDS PRO- FESSIONAL INSTALLATION BY A LICENSED AND BONDED INSTALLER. SEE YOUR DEALER FOR RECOMMENDATIONS. IMP...

Page 11 - DO NOT

11 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. o PeraTing h inTs 1. Burn only dry, well-seasoned wood for maxi- mum heat output. In some states it is illegal to burn wet wood or anything other than clean, dry wood products. 2. Your stove is designed to operate with the door closed! Operate ...

Page 12 - Be sure to clean the Nickel or Gold Plated door with; Figure 8

12 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. s TarTing anD m ainTaining a f ire Be sure to clean the Nickel or Gold Plated door with Windex brand cleaner and a very soft cloth to remove any fingerprints and residues prior to the first fire. 1. NEVER USE FLAMMABLE LIQUIDS TO START OR REKIN...

Page 15 - ainTenance

15 Experiment with different loading configurations to achieve longer burns . Try loading the wood from side to side and nesting it in the ashes to prevent airflow under and around the wood. Fresh wood should be loaded to the back of the firebox or to the sides. Hot coals or half burned wood should ...

Page 16 - . If your stove is not drafting properly, your chimney is; SMOKES WHEN; ) The draft control must be closed further.; PAINT GIVES OFF; Paint is tempering-in. Burn only moderately hot for the first

1 T rouBleshooTing P roBlem s oluTion POOR DRAFT: Extend chimney in length or have the chimney realigned to the proper size flue. Oversized chimneys normally have poor drafts. Remember, the stoves’ draft depend solely on the natural draft of the chimney (See Drafting section on Page 4 ) . If your st...

Page 17 - fully opening

17 D o ’ s anD D on ’ T DO NOT: Install or operate this stove before reading this manual. DO NOT: Close the draft beyond the point at which the flames are completely extinguished. DO NOT: Open the stove door without fully opening the draft first. DO NOT: Burn driftwood or wood that has been in salt ...

Page 18 - Replacement Parts

18 BLOWER PARTS Cat. Number Description H555 Speed Control - Wood Insert UHP Blower 201 Blower Power Cord H5559 UHP1 Cage Black H518 UHP1 Cage Gold H517 UHP1 Cage Nickel BRICKS, BLANKET, AND GASKETS H52 Firebrick (replacement - specify size) H557 Firebrick Letter A - -1/” x 9” ( per stove)” H09 Fire...

Page 20 - Accessories

20 TOP SURROUND PANEL (REQUIRED) Cat. No. Description 71015 7-1/2”H x 8”W Black (Total dimension when installed equals 29”x8”) 7101 10-1/2”H x 8”W Black Oversized (Total dimension when installed equals 2”x8”) BLOWER 71001 Blower Black 71002 Blower Gold 7100 Blower Nickel BLOWER SIDES 7110 Blower Sid...

Page 21 - Notes

Page 22 - WARRANTY; LENNOX HEARTH PRODUCTS

Printed in U.S.A. © 2007 by Lennox Hearth Products P/N 775,210M REV. B 12/2007 The manufacturer reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for firepla...