LG WD(M)-16105FD - Manuals

34 nstallation I 1 . To prevent internal damage during transport, the special 4 bolts arelocked. Before operating the washer,remove the bolts along with the rubber bungs. • If they are not removed, it may cause heavy vibration, noise and malfunction. 3 . Take out the 4 bolts along with the rubber bu...

35 nstallation I Level floor : Allowable slope under entire washer is 1˚ Power outlet : Must be within 1.5 meters of either side oflocation of washer. Do not overload the outletwith more than one appliance. Additional Clearance : For wall, door and floor modeling is required.(10cm : rear /2cm:right ...

36 nstallation I Water supply pressure must be between30kPa and 1000kPa (0.3~10kgf/cm 2 ) Don’t strip or crossthread when connectingInlet hose to the valve. If the water supply pressure is more than1000kPa, a decompression device should beinstalled. • Two rubber seals are supplied with the water inl...

37 nstallation I Installation of drain hose max. 100 cm min. 60 cm ca. 105 cm ca. 145 cm ca. 100 cm max. 100cmmin. 60cm Hose Retainer Laundry tub Tie strap max. 100cmmin. 60cm max. 100 cm ca. 105 cm ca. 145 cm ca. 100 cm min. 60 cm • The drain hose should not be placed higher than 100 cm above the f...

38 nstallation I Level adjustment Concrete floors(tile...) Wooden floors 1. Adjusting the washing machine level properly prevents excessivenoise and vibration.Install the appliance on a solid and level floor surface, preferably in acorner of the room. 2. If the floor is uneven, adjust the adjustable...

39 are before washing C 1. Care Labels Look for a care label on your clothes. This will tell you about the fabric content of yourgarment and how it should be washed. 2. Sorting To get the best results, Sort clothes into loads that can be washed with the same wash cycle.Water temperature and spin spe...

40 dding detergent A • Main wash only U • Pre Wash + Main Wash U • Do not exceed the maximum fill line. Overfilling can cause early dispensingof the fabric softener which could stainclothes. • Do not leave the fabric softener in the detergent drawer for more than 2 days.(Fabric softener could harden...

41 unction F Recommended program according to the laundry type ❋ Pre Wash : If the laundry is heavily soiled, “Pre Wash” course is recommended. Pre Wash is available in Whites, Coloureds, Synthetic program. ❋ Water Temperature : Select the water temperature to the wash cycles. Always follow garment ...

42 anguage Selection L 1. Press the Help button. 4. When language selected, the “Saving a set-up data” is display 2. Rotate the Program Dial and select “1. Language selection” option. Help menu 3. Rotate the Program Dial select desire language, and press theprogram dial. 1. Language selection 2. Pro...

43 ow to use washer H • Press the Power( ) button to start. • Press the Start/Pause( ) button. • Initial condition - Wash : Main wash - Rinse : 3 times - Spin : 1600 rpm (1400 rpm) - Water temperature : 40˚C - Program : Coloureds • Press the Power( ) button to start. • Select the conditions which yo...

44 ow to use washer H Programme 1. Power 2. Initial Program Power • Press the Power( ) button to turn power on and off. • To cancel the Time Delay function, the Power( ) button should be pressed. • When the Power( ) button is pressed, the washer is ready for Coloureds program. And the other initial ...

45 ow to use washer H Start/Pause • This Start/Pause( ) button is used to start wash cycle or pause the wash cycle. • If temporary stop of wash cycle is needed, press Start/Pause( ) button. • When in pause, the power is turned off automatically after 4 minutes. • NB. The door will not open before 1 ...

46 ow to use washer H 1. Spin selection Spin • Spin speed is available according to the program as follows. - Whites / Coloureds / Quick 30 [WD-16101FD / 16106FD] No Spin - 400 - 600 - 800 - 1000 -1200 - 1400 - 1600 [WD-14101FD / 14106FD] No Spin - 400 - 600 - 800 - 1000 -1200 - 1400 - Synthetic / W...

48 ow to use washer H Time Delay 1. Time Delay Preparing washing before starting “Time Delay.” - Turn on the water tap.- Load laundry and close the door.- Place the detergent and fabric softener in the drawer. • How to set “Time Delay” 1. Press Power( ) button. 2. Rotate the Program Dial button to s...

49 ow to use washer H • When washing cycle is completed, “word (Finished) and animation” isdisplayed on the “ Multi display ”. • During washing cycle, the remaining washing time is displayed. • Default time of each program. - Whites : around 2 hours and 45 minutes - Coloureds : around 2 hours and 2m...

50 aintenance M The water inlet filter - " " error message will blink on the control panel when water does not enter the detergent drawer. - If your water is very hard or contains traces of lime deposit, the water inlet filter may become clogged. It is therefore a good idea to clean it from ...

51 aintenance M Dispenser drawer ❋ After a while detergents and fabric softeners leave a deposit in the drawer. • It should be cleaned from time to time with a jet of running water.• If necessary it can be removed completely from the machine by pressing the catch downward and by pulling it out. • To...

52 aintenance M Cleaning your washer 1. Exterior Proper care of your washer can extend its life. The outside of the machine can be cleaned with warm water and a neutral non abrasive household detergent. Immediately wipe off any spills. Wipe with damp cloth. Try not to hit surface with sharp objects....

53 roubleshooting guide ❋ This washing machine is equipped with automatic safety functions which detect and diagnose faults at anearly stage and react appropriately.When the machine does not function properly or does not function at all, check the following points beforeyou contact your service prov...

56 erms of Warranty What Is Not Covered: • Service trips to your home to teach you how to use the product. • If the product is connected to any voltage other than that shown on the rating plate. • If the fault is caused by accident, neglect, misuse or Act of God. • If the fault is caused by factors ...

57 Warranty Certificate For offer a 24-month warranty for this apparatus During the 24-month warranty period, we will repair your apparatus at no cost to you or makeavailable spare parts to your dealer free, if this apparatus fails due to manufacturing ormaterial defects. Further claims are excluded...