Page 2 - General Safety Precautions; draft control must be fully open
General Safety Precautions 1. If this solid-fuel room heater is not properly installed, a house fire may result. For your safety, follow the installation direc- tions. Contact local building or fire officials about restrictions and installation inspection requirements in your area. 2. Wear gloves du...
Page 3 - Table of Contents
Table of Contents General Safety Precautions ................................................................. Testing Information ...........................................................................4 Draft Requirements ............................................................................
Page 4 - Overfiring Damage; Selecting the Proper Venting System; A draft test should read greater than; Page 5
4 Testing Information This manual describes the installation and operation of the Striker™ S160 non-catalytic wood heaters. These heaters meet the U.S. Environmental Protection Agency’s emissions limits for wood heaters sold on or after July 1, 1990. This heater has been developed, tested and constr...
Page 7 - Installation Clearances - Refer to Diagrams A, B and C
7 Diagram B: Side View-Alcove & Parallel Installation Diagram A: Top View-Parallel Installation K B A E C D *L K Floor Protection Floor Protection Floor Protection G G F F 72" Min. H I M J I J H † E † E L 48” Maximum Depth Diagram C: Top View-Corner Installation N P T Installation Clearances...
Page 8 - Outside Air Kit Installation; Figure 3; Leg and Heatshield Installation; Wear gloves during installation in case of; Leg Installation
8 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. Heat Shield Mounting Holes Air Channel Front Figure 2 Figure 1 Outside Air Kit Installation To install the “Outside Air Kit,” position the clip so that the nut is directly above the hole punched in the back of the heatshield (See Figure 3 ). Ins...
Page 9 - YOUR; Stove Installation; Figure 4
9 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. 11. For residential installations, install the first section of stove pipe with the crimped end going down inside the flue collar on the heater. Continue with your stove pipe, installing each section-crimped end down. Make the final connection t...
Page 10 - Wear gloves during installation in case of; DO NOT LEAVE THE STOVE; Figure 5
10 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. 5. If required, install the Outside Air Kit (cat. no. 71112) as per the following instructions. To locate the hole in the hearth for outside air mark and cut a 4” (102 mm) hole in the hearth. The hole’s center should be 3” (76 mm) directly forw...
Page 12 - Figure 7; Brick Sizes; Figure 6; Figures 7 and 8; Figure 8
1 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. Ceramic Fiber Blanket Baffle Bricks Top View Figure 7 Brick Sizes A = 4-1/4” x 9” B = -1/4” x 8-7/8” C = -1/” x 9” D = -1/4” x 9” E = 1-1/” x 8-7/8” F = Full Brick (4-1/” x 9”) G = 1-1/” x 9” H = -1/” x 8-7/8” Figure 6 3. Next, install baffle br...
Page 13 - DO NOT; WARNINGS; Figure 9
1 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. Optional Blower Installation A blower, catalog number 71000, can be installed on the stove to improve hot air distribution throughout the room. To install the blower: 1. Remove all the contents from the blower box. Included with the blower shoul...
Page 14 - Starting and Maintaining a Fire; Be sure to clean the Nickel or Gold Plated door with a household; Fully open the primary draft control by pulling the 1”; For best results, use smaller pieces of wood to get the
14 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. Starting and Maintaining a Fire Be sure to clean the Nickel or Gold Plated door with a household type cleaner and a very soft cloth to remove any fingerprints and residues prior to the first fire. 1. NEVER USE FLAMMABLE LIQUIDS TO START OR RE- ...
Page 15 - CAUTION
15 Operating Techniques and Hints Recent developments in wood-burning technology have made wood-burning a cleaner and more convenient way to heat your home. Overall efficiency in a wood-burning appliance is a combina- tion of combustion efficiency and heat transfer efficiency. Whether heating your e...
Page 17 - Maintenance; WARNING; Inspect and clean chimney and connector frequently.
17 Experiment with different loading configurations to achieve longer burns . Try loading the wood from side to side and nesting it in the ashes to prevent airflow under and around the wood. Fresh wood should be loaded to the back of the firebox or to the sides. Hot coals or half burned wood should ...
Page 18 - Troubleshooting; Problem; SMOKES WHEN; ) The draft control must be closed further.; POOR HEAT
18 Troubleshooting Problem Solution POOR DRAFT: Extend chimney in length or have the chimney realigned to the proper size flue. Oversized chimneys nor-mally have poor drafts. Remember, the stoves’ draft depend solely on the natural draft of the chimney (See drafting section on Page 4 ). If your stov...
Page 19 - Do’s and Don’ts; Install or operate this stove before reading this manual.; Complete and return your warranty card.; DO; Enjoy the warm feeling of your new CountryTM Collection stove.
19 Do’s and Don’ts DO NOT: Install or operate this stove before reading this manual. DO NOT: Close the draft beyond the point at which the flames are completely extinguished. DO NOT: Open the stove door without fully opening the draft first. DO NOT: Burn driftwood or wood that has been in salt water...
Page 20 - Replacement Parts - Model S160; Contact an Authorized Lennox Hearth Products dealer to obtain
0 Replacement Parts - Model S160 Contact an Authorized Lennox Hearth Products dealer to obtain any of these parts. Never use substitute materials. Use of non-approved parts can result in poor performance and safety hazards. BLOWER PARTS Cat. No. Description H5658 Fan Blade (FSB700) H5657 Fan Cage (F...
Page 21 - Accessories
1 Accessories Model S160 PEDESTALS (REQUIRED) Cat. No. Description 71108 Pedestal 71109 Ash Drawer Pedestalor LEGS (Required) 70000 Olympic Sculptured Black 70001 Olympic Sculptured Gold 7000 Olympic Sculptured Nickel 70007 Olympic Sculptured Brushed Gold 70008 Olympic Sculptured Brushed Nickel 7000...