LG MT-60PZ12V/A/B/K/S, MT-60PZ14V/A/B/K/S, MZ-60PZ14V/A/B/K/S - Manuals

6 Safety Instructions WARNING Do not placing any-thing containing liquidon top of the Monitor. - This may cause a fire or could give an electricshock. Do not insert anyobject into theexhaust vent. - This may cause a fire or could give an electricshock. NOTES Do not place heavyobjects on theMonitor. ...

8 Controls of the Monitor ON/OFF ON/OFF INPUT SELECT VOLUME INPUT SELECT VOLUME <Front Panel Controls> Main power button INPUT SELECT button Sub power button VOLUME ( F F , G G ) buttons Power standby indicatorIlluminates red in standby mode Illuminates green when theMonitor is turned on Remot...

10 Accessories D-sub 15 pin cable Tilt wall mounting bracket Wall mounting bracket Vertical Wall mounting bracket AS mark LG TV Owner’s Manual 1.5V 1.5V Alkaline batteries (Optional) interface board Power cord POWER SLEEP INPUT SELECT PSM SSM ARC STILL PIP / TWIN PICTURE PIP INPUT MENU MUTE OK VOL P...

12 Controls of the remote control - When using the remote control aim it at the remote control sensor of the Monitor. POWER SLEEP INPUT SELECT PSM SSM ARC STILL PIP / TWIN PICTURE PIP INPUT MENU MUTE OK VOL POWER STOP PLAY FF REC REW P/STILL VOL POSITION POWER SLEEP (Refer to p.35) PSM (Refer to p.3...

14 Monitor Installation - This model can be installed on a wall as shown below. Wall mount is optional, and is not supplied with the monitor. - This plasma display is designed to be mounted horizontally or vertically. Wall Mount: Horizontal Installation ,,,,,, ,,,,,, ,,,,,, ,,,,,, • The monitor can ...

15 ENGLISH Wall Mount: Vertical Installation ,,,,,,, ,,,,,,, ,,,,,,, ,,,,,,, • The monitor can be installed vertically on the wall as shown above. Caution: When installing the monitor vertically, the front panel controls must be in the left-down side position as shown above.(For further information,...

16 Watching VCR (+) ( ) (+) ( ) AUDIO (MONO) R L VIDEO Y PB R P AV INPUT AUDIO R L R L EXTERNAL SPEAKER (8 Ω ) AC INPUT AUDIO INPUT RS-232C S-VIDEO COMPONENT(480i/480p) RGB-PC INPUT (VGA/SVGA/XGA/SXGA) (DVD INPUT) CONTROL LOCK REMOTE CONTROL ON/ OFF (+) ( ) (+) ( ) EXTERNAL SPEAKER 8 Ω R L AC INPUT ...

17 ENGLISH Watching Cable TV - After subscribing to a cable TV service from a local provider and installing a converter, you can watch cable TV programming. TV VCR RF Cable (R) AUDIO (L) VIDEO (+) ( ) (+) ( ) AUDIO (MONO) R L VIDEO Y PB R P AV INPUT AUDIO R L R L EXTERNAL SPEAKER (8 Ω ) AC INPUT AUD...

18 (+) ( ) (+) ( ) AUDIO (MONO) R L VIDEO Y PB R P AV INPUT AUDIO R L R L EXTERNAL SPEAKER (8 Ω ) AC INPUT AUDIO INPUT S-VIDEO COMPONENT(480i/480p) RGB-PC INPUT (VGA/SVGA/XGA/SXGA) (DVD INPUT) RS-232C (+) ( ) (+) ( ) EXTERNAL SPEAKER 8 Ω R L AC INPUT RGB-PC INPUT R AUDIO INPUT L AUDIO (VGA/SVGA/XGA/...

19 ENGLISH Watching DVD • Connect DVD video inputs to Y, P B , P R of COMPONENT (480i/480p) (DVD INPUT) and audio inputs to Audio sockets of AV INPUT. How to connect How to use • Press INPUT SELECT button on the remote control of the monitor to select COMPONENT . • Try this after turning on the DVD ...

INPUT SELECT On the remote control How to use (+) ( ) (+) ( ) AUDIO (MONO) R L VIDEO Y P B R P AV INPUT AUDIO R L R L EXTERNAL SPEAKER (8 Ω ) AC INPUT AUDIO INPUT S-VIDEO COMPONENT(480i/480p) RGB-PC INPUT (VGA/SVGA/XGA/SXGA) (DVD INPUT) RS-232C (+) ( ) (+) ( ) EXTERNAL SPEAKER 8 Ω R L AC INPUT RGB-P...

21 ENGLISH Monitor Image Display Specifications 640x350 720x400 31.468 70.09 37.861 85.08 31.469 70.08 37.927 85.03 31.469 59.94 35.000 66.66 37.861 72.80 37.500 75.00 43.269 85.00 45.913 90.03 53.011 100.04 64.062 120.00 35.156 56.25 37.879 60.31 48.077 72.18 46.875 832x624 1024x768 1280x720 1152x8...

22 3 2 Function checking in PC mode - Select RGB input source. - PIP/DW function is worked when the interface board is installed. Interface board (AP-60EA21) is not equipped on MT/Z-60PZ14 series models. 1 Press the MENU button. Press the G button and then press the D / E or F / G button to select a...

23 ENGLISH 1 3 Adjusting in PC mode Press the D / E button to select SCREEN and then press the G button. If picture needs to be adjusted more after Auto adjustment, you canmanually adjust the image position and PHASE . - Select RGB input source - Automatically adjusts picture position and eliminates...

24 Adjusting in PC mode 3 2 1 Press the D / E button to select SCREEN and then press the G button. Adjusting horizontal / vertical position READY Press the D / E button to select V-POSITION or H-POSITION and then press the G button. • The adjustment range of V-POSITION is -50 ~ +50. The adjustment r...

25 ENGLISH 3 2 1 Press the D / E button to select SCREEN and then press the G button. Adjusting phase READY - If the picture isn’t clear after auto adjustment and especially that characters are still trem- bling, then adjust the picture phase manually. - When watching PIP/TWIN PICTURE, SCREEN option...

26 PIP function - Select RGB input source before pressing PIP - This function works only when the interface board is installed. Interface board (AP-60EA21) is not equipped on MT/Z-60PZ14 series models. - This function works only in the following resolution; 640x480, 800x600, 1024x768 (only in Vertic...

27 ENGLISH POSITION Moving the Sub picture Press the POSITION button in PIP mode. • Each press of the POSITION button will change the position of the sub picture on the screen as shown below. PIP INPUT Selecting the input signal Press the PIP INPUT button in PIP mode. • Each time you press PIP INPUT...

28 Selecting PIP sound options 3 2 1 Press the D / E button to select PIP / DW and then press the G button. READY Press the D / E button to select SOUND SELECT and then press the G button. Press the D / E button to select SOUND [ M ] or SOUND [ S ] and then press the OK button. VOL VOL OK Press the ...

29 ENGLISH Twin picture mode / TWIN PICTURE Press the ✱ /TWIN PICTURE button. • Each time you press ✱ / TWIN PICTURE or F / G button, you can select ON or OFF . <ON> <OFF> DW DW F OFF G F ON G • To avoid showing a fixed image on the screen, subpicture moves every 2hours. :Center Upside D...

30 Twin picture mode PIP INPUT Selecting a source for the Twin picture Press the PIP INPUT button in TWIN PICTURE mode. • Each time you press PIP INPUT button, you toggle VIDEO , S-VIDEO and COMPONENT . COMPONENT source only works with 480i signal input. PIP INPUT F VIDEO G

31 ENGLISH Using the remote control Inserting batteries • Open the battery compartment cover on the back side and insert the batteries with correct polarity. • Apply two 1.5V alkaline batteries of AAA type. Don’t mix the used batteries with new batteries. Notes for using the remote control Make sure...

32 Turning on the Monitor 3 2 1 2 1 - When using the remote control, aim it at its sensor on the Monitor. Turning on the Monitor just after installation Turning on the Monitor (power cord is still connected) Connect power cord correctly. Press the ON/OFF button on the Monitor. At this moment, the Mo...

33 ENGLISH Menu Rotation for Vertical Viewing 3 2 1 READY Press the D / E button to select OSD ROTATE and then press the G button. Use the D / E button to select NOR- MAL or ROTATE . • Select NORMAL if the monitor was installed horizontally. • Select ROTATE if the monitor was installed vertically. P...

34 1 3 2 Press the MENU button. Press the D / E button. • Each time you press this button you can see menus shown below. MENU Function checking Press the G button and then press the D / E or F / G button to select a function you want to use. • Press the OK button to exit. VOL VOL - Select VIDEO inpu...

35 ENGLISH Setting sleep time Sleep Timer turns the Monitor off after a preset time Press the SLEEP button to set sleep time.Each time you press SLEEP button, the next preset setting time is changed as shown below. • To release sleep time setting, press the SLEEP or F / G button repeatedly to select...

36 2 1 PSM PSM (Picture Status Memory) Press the PSM button. Press the PSM or F / G button to select your desired picture condition. • Each press of F / G button changes the screen display as shown below. • You can also select DYNAMIC , MILD or USER in the PIC- TURE menu. • The picture DYNAMIC , MIL...

37 ENGLISH 2 1 READY Use the D / E button to select CON- TRAST and then press the G button. (to adjust contrast setting) • Adjust BRIGHTNESS , COLOUR , TINT , and SHARPNESS in the same way. OK VOL VOL Press the MENU button and then press the D / E button to select menu. Press the G button. MENU VOL ...

38 DRP (Digital Reality Picture) DRP allows you to select Clear or Soft for your picture appearance. 3 1 READY Press the D / E button to select DRP and then press the G button. Press the OK button. OK Press the MENU button and then press the D / E button to select menu. Press the G button. MENU VOL ...

39 ENGLISH Selecting menu options 3 2 1 READY Use the D / E button to select SCREEN and then press the G button. Use the D / E button to select TV or VCR . • Select the VCR option if watching a VCR. • Select the TV option for other equipment.(Except VCR) • Each time you press the D / E button you to...

40 Adjusting sound 2 1 READY Use the D / E button to select TRE- BLE and then press the G button. (if adjusting treble) • Adjust BASS and BALANCE in the same way. Use the F / G button to make appro- priate adjustment and then press theOK button. • Press the D / E button to select other options. OK V...

41 ENGLISH Auto sound control SSM • This function lets you enjoy the best sound without any special adjust- ment because the Monitor automatically selects the appropriate soundoption based on the program content. 1 SSM Press the SSM button. 2 Press the SSM or F / G button to select your desired soun...

43 ENGLISH Using Still function 1 2 STILL Press the STILL button. • You can still the current picture.• The sub picture is stilled in PIP or Twin picture mode. <Moving image> <Still image> To return to normal viewing, press the STILL buttonagain. Tips • If still picture is on the screen ...

44 Adjusting OSD Transparency 3 2 1 READY Press the D / E button to select TRANSPARENCY and then press the G button. Press the F / G button to adjust OSD transparency. • The adjustment range of TRANSPARENCY is 0 ~ 5. Press the OK button. OK Press the MENU button and then press the D / E button to se...

45 ENGLISH Adjusting colour temperature 3 2 1 READY Press the D / E button to select COLOUR TEMP. and then press the G button. Press the D / E button to select RED and then press the G button. (to adjust RED setting) Use the F / G button to make appropriate adjustments and then press the OK button. ...

46 Setting picture format ARC Press the ARC button to select a desired pictureformat. • You can also select 16:9 , 4:3 or ZOOM in the SPECIAL menu. • Each time you press ARC or F / G button, you can select 16:9 , 4:3 or ZOOM alternatively. ARC F 16 : 9 G <16:9> <4:3> <Zoom> ARC F 4...

47 ENGLISH External Control Device Setup - Connect the RS-232C input jack to an external control device (such as a computer or an A/V controlsystem) and control the Monitor’s functions externally. (+) ( ) (+) ( ) AUDIO (MONO) R L VIDEO Y PB R P AV INPUT AUDIO R L R L EXTERNAL SPEAKER (8 Ω ) AC INPUT...

48 Type of connector : D-Sub 9-pin male * Use a null modem cable. Wire the 7-Wire cable so that each pair of data lines cross between the two devices. These data line pairsare RXD (Receive data) and TXD (Transmit data), DTR (DTE side ready) and DSR (DCE side ready), andRTS (Ready to send) and CTS (C...

50 1 Use the D / E buttons to select SET ID and then press the G button. • Use this function to specify a monitor ID number. Set ID READY 2 Use the F / G button to adjust SET ID to choose the desired monitor ID number. • The adjustment range of SET ID is 1 ~ 99. Press the MENU button and then press ...

58 No output from one of the speakers • Adjust BALANCE in the SOUND menu. (Refer to p.40) Strange sound from the Monitor • Typical sound due to normal Monitor operation, Monitor is not faulty. Troubleshooting check list No picture & No sound • Check whether the Monitor is turned on. • Power cord...

59 ENGLISH Product specifications MODEL Width (inches / mm) Height (inches / mm) Depth (inches / mm) Weight (pounds / kg) Power requirement Resolution Colour Temperature Humidity MT-60PZ12V/A/B/K/SMT-60PZ14V/A/B/K/S MZ-60PZ14V/A/B/K/S 57.3 / 1455 34.8 / 883 3.9 / 99 154.3 / 70 110-240V~ 50/60Hz 1280...